Library

X
feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Articles: DFG German National Licenses  (3)
  • cell damamge  (2)
  • DNA synthesis rate  (1)
Source
  • Articles: DFG German National Licenses  (3)
Material
Years
Keywords
  • 1
    Electronic Resource
    Electronic Resource
    Damaging agitation intensities increase DNA synthesis rate and alter cell-cycle phase distributions of CHO cells (1992)
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 40 (1992), S. 978-990 
    Details
    ISSN: 0006-3592
    Keywords: DNA synthesis rate ; agitation ; cell-cycle kinetics ; flow cytometry ; cell culture ; Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The effects of fluid-mechanical force (agitation) on the cell cycle kinetics of Chinese hamster ovary (CHO) cells cultured in suspension in 2-L bioreactors has been examined. A two-color flow cytometry method was used to determine the fraction rate of DNA synthesis. With increased agitation intensity, cell viability decreased as a result of increased cell death. However, increased agitation induced the viable cells of the culture to a higher proliferative state relative to a control culture. The fraction of viable cells of the high-agitation culture (250 rpm) in S phase was higher (up to 45%) and in G1 phase was lower (up to 50%) compared with the viable cells of the control culture (80 rpm). The DNA synthesis rate per viable S-phase cell of the high-agitation culture was confirmed by recovery experiments, which were conducted to measure the apparent specific growth rate and the cell cycle kinetics of the high-agitation culture upon reduction in the agitation rate from 250 rpm back to 80 rpm. The apparent specific growth rate of the test culture, calculated for the first 12 h of the recovery period, was greater than the apparent specific growth rate of the control culture. Furthermore, the proliferative state of the viable cells of the test culture, which had become higher relative to the control culture during the high agitation period, gradually approached the level of the control culture during recovery. Results also show that the magnitude of the agitation intensity; the culture agitated at 250 rpm attained a greater proliferative state than a parallel culture agitated at 235 rpm. The 250-rpm culture had a higher fraction of S-phase and a lower fraction of G1-phase cells than the 235-rpm culture. The DNA sunthesis rate per viable S-phase cell of the 250-rpm culture was greater than of the 235-rpm culture. © 1992 John Wiley & Sons, Inc.
    Additional Material: 13 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/bit.260400814
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 2
    Electronic Resource
    Electronic Resource
    Analysis of cell-to-bubble attachment in sparged bioreactors in the presence of cell-protecting additives (1995)
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 47 (1995), S. 407-419 
    Details
    ISSN: 0006-3592
    Keywords: cell-to-bubble attachment ; cell damamge ; cell protecting additives ; interfacial properties ; Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: To investigate the mechanisms of cell protection provided by medium additives against animal cell injury in sparged bioreactors, we have analyzed the effect of various additives on the cell-to-bubble attachment process using CHO cells in suspension. Cell-to-bubble attachment was examined using three experimental techniques: (1) cell-bubble induction time analysis (cell-to-bubble attachment times); (2) forming thin liquid films and observing the movement and location of cells in the thin films; and (3) foam flotation experiments. The induction times we measured for the various additives are as follows: no additive (50 to 500 ms), polyvinyl pyrrolidone (PVP: 20 to 500 ms), polyethylene glycol (PEG: 200 to 1000 ms), 3% serum (500 to 1000 ms), polyvinyl alcohol (PVA: 2 to 10 s), Pluronic F68 (5 to 20 s), and Methocel (20 to 60 s). In the thin film formation experiments, cells in medium with either F68, PVA, or Methocel quickly flowed out of draining thin liquid films and entered the plateau border. When using media with no additive or with serum, the flow of cells out of the thin liquid film and film drainage were slower than for media containing Pluronic F68. PVA, or Methocel. With PVP and PEG, the thin film drainage was much slower and cells remained trapped in the film. For the foam flotation experiments, a separation factor (ratio of cell concentration in the foam catch to that in the bubble column) was determined for the various additives. In the order of increasing separation factors (i.e., increasing cell attachment to bubbles), the additives are as follows: Methocel, PVA, Pluronic F68, 3% serum, serum-free medium with no additives, PEG, and PVP. Based on the results of these three different cell-to-bubble attachment experiments, we have classified the cell-protecting additives into three groups: (1) Pluronic F68, PVA, and Methocel (reduced cell-to-bubble attachment); (2) PEG and PVP (high or increased cell-to-bubble attachment); and (3) FBS (reduced cell attachment butslower drainage films compared with F68, PVA, and Methocel with some cell entrapment in those films). These phenomena are discussed in relation to the interfacial properties of the media reported in a companion Study (this issue). © 1995 John Wiley & Sons Inc.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/bit.260470402
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 3
    Electronic Resource
    Electronic Resource
    Interfacial properties of cell culture media with cell-protecting additives (1995)
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 47 (1995), S. 420-430 
    Details
    ISSN: 0006-3592
    Keywords: cell damamge ; shear protectant ; surface tension ; rheological interfacial properties ; Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: In an effort to identify key rheological properties that contribute to cell protection against shear damage, we have measured surface shear and dilatationai viscosities, dynamic surface tension, foaminess, and foam stability for media containing cell-protecting additives. In a companion article,18 we found that cell-to-bubble attachment was decreased in media containing Methocel, Pluronic F68, or polyvinyl alcohol (PVA). In medium containing polyethylene glycol (PEG) or potyvinyl-pyrrolidone (PVP), attachment was increased. PEG, PVP, serum (FBS), and serum albumin (BSA) increased the surface viscosity of the air/medium surface (thus, producing a more rigid interface), whereas F68 and PVA lowered it greatly. Foaming experiments showed that Methocel, PEG, PVA, and F68 decreased the foam half-life while FBS, BSA, and PVP were foam stabilizers. Interestingly, the foam stability of CHO cell suspensions decreased significantly for cell concentrations higher than ca. 2 × 106 cells/mL. Nonviable CHO cells reduced foam stability further. Dynamic surface tension values of the media tested were found significantly differentfrom their static surface tension values. The interfacial properties measured and the results presented in the companion study suggest that the additives that lower dynamic surface tension the most (Methocel, F68, and PVA) correlate well with reduced cell-to-bubble attachment, and thus, cell protection. Reduced dynamic surface tension with these additives implies faster surfactant adsorption, mobile interfaces, lower surface viscosity, and foam destabilization. Because PEG and PVP resulted in increased cell-to-bubble attachment and had different interfacial properties, a different mechanism (compared with Methocel, PVP, and F68) is apparently responsible for their protective effect. Finally, cell protection offered by FBS and BSA is attributed to the foam stabilization properties provided by these additives. © 1995 John Wiley & Sons Inc.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/bit.260470403
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...