Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 5 (1967), S. 343-360 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The results of detailed measurements of osmotic pressure, light scattering, and viscosity of poly(vinyl chloride) solutions are used to establish the molecular weight dependence of [η] and A2, to estimate the unperturbed dimensions of the poly(vinyl chloride) molecule, and to analyze critically the [η]-M correlations published hitherto.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 7 (1969), S. 1755-1760 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Rates of crystallization of polyethylene fractions have been studied at high undercoolings by differential calorimetry to demonstrate the utility of this technique for fast crystallization analysis. It has been shown that there is continuity in the crystallization kinetics from low to high undercoolings. On the other hand, the influence of molecular weight on the crystallization rates, as the undercooling increases, is very moderate, as would be expected.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 5 (1967), S. 705-710 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Recent precision measurements of the heats of combustion of atactic and isotactic polystyrene permit an unequivocal calculation of the enthalpy difference in the bulk amorphous forms of the two isomers of this polymer. Contributions to this quantity arise mainly from the differences in nonbonded interactions in the two configurations but may also contain terms relating to higher energy conformations and to intermolecular interactions. The thermochemical and NMR data of specific polymers and of simple molecules are discussed in a comparison with model compound calculations. The thermochemical method has potentially important applications in studying molecular interactions in stereoregular polymers.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 6 (1968), S. 1627-1637 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Fibrous crystals of polyethylene are produced by crystallization from agitated solutions in xylene. If crystallization temperature is maintained between 97°C and 108°C these fibers are free from overgrowth effects and are seen to consist of flat, striated ribbons. This material was treated with fuming nitric acid, and the molecular weight distribution of the degradation product was analyzed by gel permeation chromatography. This distribution was found to consist of a low molecular weight peak and an exceptionally resistant high molecular weight tail over a wide range of degradation times in quantitative agreement with the serrations developed during the nitric acid attack. This is consistent with the fibers possessing a composite folded and extended chain structure. The lateral pulling out of smooth fibrils from the original fibers in the course of certain electron microscope sample preparation methods is consistent with the presence of chain-folded material and might account for the structureless fibrils reported in the literature. Partially successful attempts to obtain the extended chain portion in pure form by selective dissolution are mentioned together with some low-angle x-ray results.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 5 (1967), S. 511-533 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The temperature dependence of x-ray small-angle scattering from fractionated linear polyethylene crystallized from the melt was determined experimentally over a range of temperatures from room temperature to the melting point. It was found in general that only the most intense of the several small-angle peaks exhibited a thermally dependent behavior. Below the crystallization temperature this peak increased in intensity with temperature, at constant peak position. Recrystallization was manifest in a discontinuous shift of the peak. During isothermal crystallization, the peak intensity first increased, then decreased, with time. It is concluded from supplementary electron microscopy and from the behavior of the peak that its position reflects the period of stacking of lamellae and that its intensity is controlled primarily by the thickness of the layer separating lamellae. The reversible peak intensity effect is attributed to an entropydriven growth of the interlamellar layer at the expense of the crystalline lamellae. The intensity effects observed during crystallization are associated with the primary and secondary phases of crystallization. Lamellar surface free energies were computed from melting point observations and were found to increase with molecular weight.
    Additional Material: 14 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 7 (1969), S. 1819-1833 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Annealed polyethylene single crystals have been degraded with fuming nitric acid, and the molecular weight distribution of the fragments determined by using a gel-permeation chromatograph. Peaks due to chain folding were observed in these distributions as for unannealed single crystals. The peaks moved to lower molecular weight with increasing degradation time. Comparison of the lowest molecular weight peak length after a given degradation time with the low-angle x-ray periodicity before degradation gave information about a disordered surface layer. The thickness of this layer at early states of degradation was dependent solely on annealing temperature, though changes in the layer must have occurred with annealing time, since there was an increase in reaction rate with annealing time. At higher degradation states, the thickness of the layer was dependent solely on the original low-angle periodicity. This has been related to the depth at which some folds are buried beneath the lamellar surfaces. The relevance of these observations to the structure of annealed single crystals is discussed.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    ISSN: 0449-296X
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: The surface product formed in the reaction between TiCl3 and Al(CH3)3 has been studied. Stoichiometric data, CH3/CD3 exchange, and infrared spectra permit the conclusion that the surface product is essentially a compound having the formula A model structure is proposed for this compound, valid for the 001 face of α-TiCl3. In it the titanium and chlorine atoms maintain the positions which they occupy in the α-TiCl3 lattice. One of the methyl groups protrudes from the surface whereas the other occupies the chlorine vacancy created during the reaction in the chlorine surface layer. A different sterism of the methyl groups is compatible with the experimental result that half of the methyl groups are very easily exchanged whereas the other half are not touched by the exchanging agent. According to this model it has to be assumed that the titanium atoms in the 001 plane, by far the largest face of the α-TiCl3 crystal, are not accessible. A similar model, loading to equivalence conclusions is proposed for β-TiCl3. The infrared spectra of Al(CH3)3, Al(CD3)3, AlCl(CH3)2, AlCl(CD3)2, AlCl2CH3, AlCl2CD3, TiCl3CH3, TiCl3CD3, Hg(CD3)2, and Zn(CD3)2 are discussed. Spectra of surface products formed on interaction of some of these compounds with TiCl3 are given.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-1: Polymer Chemistry 4 (1966), S. 1951-1969 
    ISSN: 0449-296X
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: The determination of the number of sites active in the polymerization of ethylene on the surface of α-TiCl3-Al(CH3)3 dry catalysts leads to the conclusion that this number is small in comparison to the total surface of the catalyst. Qualitatively this conclusion is also reached by two other independent methods. Infrared spectra of the catalyst before and after polymerization do not show a change in the type of bonds present in the surface. Electron microscopy proves that no active sites are formed on the basal plane of the α-TiCl3 which constitutes 95% of the total surface. The results strongly favor the lateral faces of α-TiCl3 as the preferred location of active centers. The lateral faces contain chlorine vacancies and incompletely coordinated titanium atoms. This must then be the essential conditions for the formation of active centers. The propagation of the polymer chain has been repeatedly shown to follow an insertion mechanism. The active site, therefore, necessarily contains a metal-carbon bond. The study of catalysts derived from TiCl3CH3 leads to the conclusion that a Ti—C bond on titanium of incomplete coordination is the active species in these cases. The alkylation of surface titanium atoms was proven to be an intermediate step in the catalyst formation from TiCl3 and AlR3. Survival of titanium-alkyl bonds on the lateral faces, where titanium atoms are incompletely coordinated explains best, in the light of our data, the activity of Ziegler-Natta catalysts. Coordination of aluminum alkyl compounds in or around the active center probably complicates the structure of the active centers.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-1: Polymer Chemistry 4 (1966), S. 1642-1644 
    ISSN: 0449-296X
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-1: Polymer Chemistry 7 (1969), S. 209-216 
    ISSN: 0449-296X
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Trioxane-1,3-dioxolane copolymers of high molecular weights and good thermal stability are obtained with high yields by a crystallization-polymerization method. The feed consists of concentrated solutions of trioxane in cyclohexane in the presence of dissolved 1,3-dioxolane. The 1,3-dioxolane/trioxane molar ratio in the feed lies in the range 2 to 10%. The results are compared with those obtained from isothermal copolymerizations.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...