Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 1995-1999  (2)
  • 1985-1989  (4)
  • 1970-1974
  • Polymer and Materials Science  (6)
Material
Years
  • 1995-1999  (2)
  • 1985-1989  (4)
  • 1970-1974
  • 1990-1994  (4)
Year
  • 1
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    Surface and Interface Analysis 14 (1989), S. 388-392 
    ISSN: 0142-2421
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Physics
    Notes: The change in surface composition of Co(50.4 at.%)-Ni alloy under Ar+ ion bombardment was investigated by Auger electron spectroscopy (AES) and ion scattering spectroscopy (ISS). The surface concentrations were estimated by employing a spectrum synthesis method, since the Co and Ni signals in both AES and ISS spectra overlap each other. The results based on the quantifications by AES and ISS have indicated that the composition of the Co-Ni alloy surface under Ar+ ion bombardment is the same as the bulk composition within the accuracy in quantification, leading to the conclusion that ion bombardment does not cause surface composition change in the Co-Ni alloy. This supports the proposal that the Co-Ni alloy system is an appropriate reference material for surface chemical analysis.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    Surface and Interface Analysis 23 (1995), S. 351-362 
    ISSN: 0142-2421
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Physics
    Notes: We have studied the effect of elastic scattering and analyser geometry on calculations of electron escape depths. A theoretical analysis of the electron escape depth has been presented that shows how it is related to the solid angle for detection and the geometrical configuration of a cylindrical mirror analyser. To estimate the extent to which elastic scattering can modify the values of the escape depth, Monte Carlo simulations of the emission of Auger electrons were carried out for Cu MVV (59 eV), Cu LMM (916 eV), Au NVV (238 eV) and Au MNN (2025 eV) signals. From the calculated depth distributions of signal electrons, we have derived a correction factor for the electron escape depth in terms of the corresponding inelastic mean free path which includes both the effects of elastic scattering and analyser geometry. We have found that elastic scattering reduces the value of the escape depth by several tens of per cent and, depending on the target, signal electron energy and analyser geometry, the ration between the escape depth and the inelastic mean free path varies from 0.4 to 0.6.
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 0142-2421
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Physics
    Notes: The Japanese VAMAS-SCA working group is composed of 19 institutes. Three kinds of Au-Cu alloys (Au25 at%-Cu75 at%, Au50 at%-Cu50 at%, Au75 at%-Cu25 at%) were prepared, and these specimens were distributed to the members of Japanese VAMAS-SCA working group and Auger peak amplitude ratios were measured to clarify the correlation factor of different types of spectrometers. The comparison was carried out by using the relative sensitivity factor for Au and Cu. The relative sensitivity factor for lower energy varied from spectrometer to spectrometer, but that for higher energy did not vary so much. Therefore, to carry out the inter-laboratory comparison of the data, the transfer of the data of peak amplitude at higher energy should be recommended.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    Surface and Interface Analysis 12 (1988), S. 161-161 
    ISSN: 0142-2421
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Physics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    ISSN: 0142-2421
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Physics
    Notes: The simulation of electron/solid interactions is discussed, with emphasis on its applicability to the matrix correction in quantitative analysis by AES, and to its potential use in background substraction in AES. The Monte Carlo calculation models are first explained, which have been improved to allow the estimation of (i) back-scattering correction factors, and (ii) energy profiles of back-scattered electrons in the high-energy region (i.e. elastically-scattered electrons and the characteristic loss structures) and the slow secondary region. For this purpose, a dielectric approach is used for the treatment of the electron inelastic scattering in the solid. Then, the models are applied to samples with bi-layer structures, and the change of Si Auger signals observed during sputter-etching of a sample consisting of a Si thin film (7000 Å) on a W substrate is well explained. Changes in the energy distributions of back-scattered electrons during the formation of very thin (5 to 100 Å) Cu films on a Si substrate are also estimated by the Monte Carlo calculation, together with the shapes of the elastic peak and the characteristic loss peaks.
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    Surface and Interface Analysis 25 (1997), S. 860-868 
    ISSN: 0142-2421
    Keywords: ISO/TC 201 on Surface Chemical Analysis ; standards ; surface analysis ; Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Physics
    Notes: A summary is given of the organization and work of Technical Committee 201 on Surface Chemical Analysis of the International Organization for Standardization (ISO). Twelve potential international standards are currently in various stages of development and a further thirteen standards are expected to be developed shortly. Information is also given on expected future needs for standards with examples from a recent survey of experts in Auger electron spectroscopy and x-ray photoelectron spectroscopy. © 1997 John Wiley & Sons, Ltd.
    Additional Material: 14 Tab.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...