Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 86 (1999), S. 4176-4183 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have studied the formation of surface blisters in 〈100〉 n-type silicon following co-implantation with boron and hydrogen. The silicon substrates had four different n-type dopant levels, ranging from 1014 to 1019 cm−3. These substrates were implanted with 240 keV B+ ions to a dose of 1015 cm−2, followed by a rapid thermal anneal at 900 °C for 30–60 s to force the boron atoms into substitutional lattice positions (activation). The samples were then implanted with 40 keV H+ to a dose of 5×1016 cm−2. The implanted H+ distribution peaks at a depth of about 475 nm, whereas the distribution in the implanted B+ is broader and peaks at about 705 nm. To evaluate the role of the B+ implantation, control samples were prepared by implanting with H+ only. Following the H+ implantation, all the samples were vacuum annealed at 390 °C for 10 min. Blisters resulting from subsurface cracking at depths of about 400 nm, were observed in most of the B+ implanted samples, but not in the samples implanted with H+ only. This study indicates that the blistering results from the coalescence of implanted H into bubbles. The doping with B facilitates the short-range migration of the H interstitials and the formation of bubbles. A comparison of the observed crack depth with the depth of the damage peak resulting from the H+ implantation (evaluated by the computer code TRIM) suggests that the nucleation of H bubbles occurs at the regions of maximum radiation damage, and not at the regions of maximum H concentration. For given values of B+ and H+ doping, the blister density was found to decrease with increasing n-type doping, when the boron is activated. Blister formation was also observed in B+ implanted samples which had not been activated. In this case, the blister density was found to increase with increasing value of n-type doping. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Journal of the American Chemical Society 75 (1953), S. 3882-3887 
    ISSN: 1520-5126
    Source: ACS Legacy Archives
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Diamondlike carbon (DLC) was deposited on silicon using a plasma immersion ion deposition (PIID) method. Inductive radio-frequency plasma sources were used to generate Ar and C2H2 plasmas at low gas pressures ranging from 0.04 to 0.93 Pa. The film stress and hardness were sharply dependent upon bias voltage at an operating pressure of 0.04 Pa. A maximum hardness of 30 GPa and compressive stress of 9 GPa was observed at a pulsed bias of −150 V bias (carbon energy of 80 eV). The mechanical properties of DLC films are correlated with UV Raman peak positions which infer sp3-bonded carbon contents. © 1998 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 71 (1997), S. 1320-1322 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Electron field emission from allotropes of carbon (graphite, diamondlike carbon, and diamond) have been reported many times in the literature. This work explores the use of ion irradiation for improving electron field emission from carbon fibers. Carbon fibers have been irradiated with H, C, Ar, and Xe ions. Field emission characteristics have been measured as a function of ion dose. A reversible reduction in the required field for a fixed current level has been observed. The critical dose, Dc, defines the dose corresponding to the lowest field necessary to emit a fixed current (5 μA). The critical dose appears to correlate with the nuclear energy loss (collisions with atoms) of the ion in the carbon fiber. Transmission electron microscopy and parallel electron energy loss spectroscopy analysis indicate an amorphous surface, and an increase in the sp3 content of the fiber surface to 20%–30%. A corresponding decrease in the work function is expected and may account for the improvement in electron emission. © 1997 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Journal of the American Chemical Society 37 (1915), S. 1783-1797 
    ISSN: 1520-5126
    Source: ACS Legacy Archives
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    ISSN: 1745-6584
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Energy, Environment Protection, Nuclear Power Engineering , Geosciences
    Notes: Flow-through microcosms were constructed to conduct ecological experiments on aquifer organisms. The two 5-channel microcosms were simple to construct, were fed by an artesian spring, and maintained close to in situ temperature and O2 concentrations. They were used to test relative microbial colonization of three substrate sizes: silt (0.063 mm), sand (0.9 mm), and gravel (3 mm). After 96 days of incubation, O2 microelectrode measurements revealed the lowest O2 tension in the silt, the highest in the gravel, and intermediate values in the sand. Microbial activity (3[H]-thymidine incorporation) was greatest in the gravel, followed by sand and then silt. Denitrification was greatest in the silt, followed by sand and then gravel. Microbial activity may be greatest with the largest particle size because of increased water exchange through pores, and denitrification may be greatest with the smallest particle sizes because of the occurrence of anaerobic microzones.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Journal of the American Chemical Society 74 (1952), S. 2693-2693 
    ISSN: 1520-5126
    Source: ACS Legacy Archives
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Journal of the American Chemical Society 75 (1953), S. 3877-3882 
    ISSN: 1520-5126
    Source: ACS Legacy Archives
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    ISSN: 1476-4687
    Source: Nature Archives 1869 - 2009
    Topics: Biology , Chemistry and Pharmacology , Medicine , Natural Sciences in General , Physics
    Notes: [Auszug] Indirect detections of massive — presumably Jupiter-like — planets orbiting nearby Sun-like stars have recently been reported,. Rocky, Earth-like planets are much more difficult to detect, but clues to their possible existence can nevertheless be obtained from observations of the ...
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    ISSN: 1572-879X
    Keywords: partial oxidation of methane ; synthesis gas ; rhodium ; oxygen species ; transient study ; DRIFTS
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract The nature of surface sites responsible for methane activation and COx formation on Rh catalysts for the partial oxidation of methane to syngas was investigated. The interaction of H4 with Rh-black after oxidative and reductive pretreatments was studied applying (a) pulse experiments at reduced total pressure (10−4 Pa) and 1013 K in the temporal-analysis-of-product (TAP) reactor and (b) in situ DRIFTS at 973 K. The saturation of the metal surface sites with oxygen was found to inhibit methane dissociation. Direct methane oxidation to CO2 on the oxidized surface sites proposed earlier was excluded. Methane is first dissociated on reduced surface sites; the carbon species formed, then, react with surface oxygen to CO2. Rh sites responsible for methane activation are neither related to the formation of the Rh2O3 nor Rh0. Probably the partially oxidized species (Rh+) or highly dispersed Rh3+ entities act as active surface centers for the dissociation of methane. For supported catalyst, such sites are stabilized by the support, which on the other side acts as a source of active oxygen involved in the oxidation of surface carbon and hydrogen.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...