ISSN:
1573-1987
Keywords:
drag reduction
;
turbulent pipe flow
;
polymer solutions
;
riblets
Source:
Springer Online Journal Archives 1860-2000
Topics:
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
Notes:
Abstract The flow of 3 to 100 wppm aqueous solutions of a polyethyleneoxide polymer,M w=6.2×;106, was studied in a 10.2 mm i.d. pipe lined with 0.15 mm V-groove riblets, at diametral Reynolds numbers from 300 to 150000. Measurements in the riblet pipe were accompanied by simultaneous measurements in a smooth pipe of the same diameter placed in tandem. The chosen conditions provided turbulent drag reductions from zero to the asymptotic maximum possible. The onset of polymer-induced drag reduction in the riblet pipe occurred at the same wall shear stress, τ* w =0.65 N/m2, as that in the smooth pipe. After onset, the polymer solutions in the riblet pipe initially exhibited linear segments on Prandtl-Karman coordinates, akin to those seen in the smooth pipe, with specific slope increment $$\delta /\sqrt c = 6$$ . The maximum drag reduction observed in the riblet pipe was independent of polymer concentration and well below the asymptotic maximum drag reduction observed in the smooth pipe. Polymer solution flows in the riblet pipe exhibited three regimes: (i) Hydraulically smooth, in which riblets induced no drag reduction, amid varying, and considerable, polymer-induced drag reduction; this regime extended to non-dimensional riblet heightsh +〈5 in solvent andh +〈10 in polymer solutions. (ii) Riblet drag reduction, in which riblet-induced flow enhancementR′〉0; this regime extended from 5〈h +〈22 in solvent and from 10〈h +〈30 in the 3 wppm polymer solution, with respective maximaR′=0.6 ath +=14 andR′=1.6 ath +=21. Riblet drag reduction decreased with increasing polymer concentration and increasing polymer-induced flow enhancement S′. (iii) Riblet drag enhancement, whereinR′〈0; this regime extended for 22〈h +〈110 in solvent, withR′→;−2 forh +〉70, and was observed in all polymer solutions at highh +, the more so as polymer-induced drag reduction increased, withR′〈0 for allS′〉8. The greatest drag enhancement in polymer solutions,R′=−7±1 ath +=55 whereS′=20, considerably exceeded that in solvent. Three-dimensional representations of riblet- and polymer-induced drag reductions versus turbulent flow parameters revealed a hitherto unknown “dome” region, 8〈h +〈31, 0〈S′〈10, 0〈R′〈1.5, containing a broad maximum at (h +,S′,R′) = (18, 5, 1.5). The existence of a dome was physically interpreted to suggest that riblets and polymers reduce drag by separate mechanisms.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF00863517
Permalink
