Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 89 (2001), S. 3381-3387 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The relationship between microstructure and giant magnetoresistance (GMR) of granular Au80Co20 was investigated. Two different processing routes were explored. With the melt spinning technique the microstructure appeared to be so coarse that it was not expected to exhibit any substantial GMR effect. On the other hand, with the procedure of solid-solution annealing and water quenching afterwards, a suitable nanostructure was prepared that showed a GMR of 29% at 10 K and 50 kOe. Subsequent annealing causes coarsening of Co particles. In additional spinodal decomposition occurred for a certain temperature range and a loss of coherency of the Co particles with respect to the Au was observed with high-resolution transmission energy microscopy. At magnetic fields above ∼20 kOe, all annealed alloys showed a saturating magnetization, whereas the resistance is still steadily decreasing, challenging the presumed mathematical relationship between GMR and overall magnetization. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 86 (1999), S. 3661-3669 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Two tools for the analysis of facets as detected by scanning-probe microscopy (SPM) images are proposed. One tool is an adaptation of the radial-histogram transform proposed by D. Schleef et al. in Phys. Rev. B. 55, 2535 (1997). In this article the local slopes in the SPM image are in the present version determined by Savitsky–Golay filters with variable lengths [A. Savitsky and M. J. E. Golay, Anal. Chem. 36, 1627 (1964)]. These variable length filters turn out to be important to suppress the influence of noise obscuring the possibility to detect facets and to analyze corrugations with different length scales in SPM images, e.g., surface reconstructions. The other tool allows the direct quantitative determination of the orientation (with a standard deviation) of user-specified parts of facets. It makes use of a Savitsky–Golay filter as well. Both tools were applied to an artificially constructed SPM image and several experimental SFM images showing (ionic) MnO precipitates protruding out of a (metallic) Cu surface. It is shown that the Miller indices of the facets can be derived experimentally. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 80 (1996), S. 623-632 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: This paper presents a detailed analysis of high-load friction atomic force microscopy (AFM) images of layered structures in terms of a discrete stick-slip model. It turned out that based on a geometric approach, the characteristics of slip behavior can be linked to the cantilever/sample spring anisotropy. In particular, the use of polar scans is emphasized to analyze and to quantify these characteristics. The measured stiffness as derived from the slip behavior is in correspondence with the stiffness inferred from static friction. It is concluded that the combined stiffness of substrate and cantilever is constant during an AFM scan in a given direction, which supports the simple stick-slip model. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 77 (1995), S. 3467-3478 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Amorphous Si layers were grown by krypton plasma sputter deposition at 310 °C. By pulsation of the substrate potential between 0 and 50 eV, the Kr concentration in the layers could be varied to a maximum of 5.5 at. %. A model which describes trapping of inert gas atoms in the sputtered layer in terms of implantation and trapping, diffusion, growth, resputtering, and gas sputtering is presented. High-resolution electron microscopy, electrode-probe (x-ray) microanalysis, positron annihilation, Raman spectroscopy, Mössbauer spectroscopy, and bending and hardness measurements were performed on the deposited layers. It turns out that the ion assisted growth leads to a strong reduction of open volume defects. The experiments point to the presence of very small Kr agglomerates. From the Mössbauer experiments a lower limit of 250 K for the Debye temperature of the Kr agglomerates is derived. Molecular-dynamic simulations from which the Debye temperatures of Kr mono-, di-, and trimers in amorphous Si can be derived are presented. The simulations indicate the presence of predominantly Kr monomers and dimers. © 1995 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 75 (1994), S. 809-813 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A model is proposed to predict the following quantities for powder materials compacted by shock waves: the pressure, the specific volume, the internal energy behind the shock wave, and the shock-wave velocity Us. They are calculated as a function of flyerplate velocity up and initial powder specific volume V00. The model is tested on Cu, Al2024, and Fe. Calculated Us vs up curves agree well with experiments provided V00 is smaller than about two times the solid specific volume. The model can be used to predict shock-wave state points of powder or solid material with a lower or higher initial temperature than room temperature.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 53 (1988), S. 663-665 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: In general, neon implantation is not very effective in reducing wear rates. However, neon implantation into laser-melted steel turns out to reduce the wear rate substantially as a result of a conversion of residual tensile stresses into compressive ones. Nitrogen implantation, on the other hand, at a high dose of 3×1017 ions/cm2 at 90 °C exhibits a deleterious effect on the wear performance. A brittle layer of ε-Fe2(C,N)1−x nitrides is formed. At a lower dose of 1×1017/cm2 or implantation of nitrogen at 150 °C, the wear rate is also reduced.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 56 (1990), S. 2402-2404 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Structural features of TiS2 were studied by scanning tunneling microscopy (STM) and single-crystal x-ray diffraction was applied as a complementary technique. STM images in air and at room temperature revealed, besides the trigonal symmetry of the lattice, several new features having this symmetry as well. We conclude that these features are not only to be described by structural defect phenomena which affect sites in the 1T-CdI2 structure but tetrahedral sites as well. Sample orientation determination by x-ray diffraction provides a unique relation between feature types and sites. A model is proposed in which displaced Ti atoms account for the observed features.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 82 (1997), S. 3763-3770 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: This article presents a quantitative determination of static deformation at a nanometer scale of a surface caused by the tip of an atomic force microscope. An analysis of cantilever displacements while in contact with the surface leads to a directly measurable dimensionless parameter which is well sensitive to surface deformation. The method is specifically aimed at stick/slip friction measurements like on layered compounds, like TiS2 or on a relatively rigid surface of an ionic crystal, in this study NaCl [100]. Stick/slip friction images offer a possibility to investigate details of strain-dependent deformation. The observed deformation in TiS2could play an important role in the occurrence of strong stick/slip friction in this and other layered materials. © 1997 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 83 (1998), S. 3444-3444 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 91 (2002), S. 1901-1909 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The detailed mechanisms of the structural phase transformations that occur in epitaxial Y–hydride switchable mirrors are revealed with high resolution transmission electron microscopy (both cross sectional and plan view). The triangular ridge network that develops in Y prior to the α–β transformation is a result of {101¯2} deformation twinning. The basal plane that is originally parallel to the film/substrate interface is rotated by twinning over 5.6° and transformed into a prismatic plane and similarly the prismatic plane is transformed into a basal plane giving a final crystal reorientation for the ridge of 95.6°. After transformation to β, nearly vertical Σ3{111} twin boundaries arise in the ridges. In contrast, horizontal twin boundaries develop in the β domains to prevent macroscopic shape changes. Inbetween the two twin variants within the domains, Shockley partial dislocations are persistently present, which enable efficient reversible β–γ switching of the mirror. © 2002 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...