Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Analytical chemistry 46 (1974), S. 843-855 
    ISSN: 1520-6882
    Source: ACS Legacy Archives
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 73 (1993), S. 5771-5775 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have searched for the electronic states that mediate oscillatory magnetic coupling in superlattices, and have found strong evidence that these are quantum well states, which are created by quantizing the momentum of s,p-band states perpendicular to the interfaces. In noble metal layers on ferromagnets we find such states at the Fermi level, where they are able to influence magnetic coupling and transport. They exhibit several traits connecting them with oscillatory magnetic coupling, such as periodicity and spin polarization.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 69 (1991), S. 5000-5002 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The properties of the magnetic domain structures of ultrathin fcc cobalt films epitaxially grown on Cu (001) have been examined using an ultrahigh vacuum surface magneto-optic Kerr effect instrument. The evolution of magnetic behavior is observed for film thicknesses ranging from 1.4 to 7.5 monolayers. The coercivity is sensitive to film growth temperature and thermal cycling history. The coercivity decreases with diminishing film thickness and falls to very low values for the thinnest layers. The results are discussed in terms of Néel domain-wall micromagnetics for ultrathin films.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 70 (1991), S. 5929-5931 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We report experimental results on the ferromagnetic critical behavior of cobalt and metastable cobalt-copper alloy two-dimensional layers CuxCo1−x epitaxially grown on Cu(001). Copper alloying reduces the magnitude of the cobalt magnetic moment and introduces a magnetization component normal to the film. Reorientation of the magnetization back into the plane occurs via a second-order phase transition at a temperature which is lower than the film Curie temperature. We discuss these results in light of the recent predictions of Pescia and Pokrovsky.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 67 (1990), S. 5417-5417 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The important question of the effect of lattice strain on the electronic band structure of strained magnetic layers is addressed. Specifically, we compare high-resolution angle-resolved (k-dependent) photoemission from metastable fcc cobalt films with those from metastable fcc iron films, both epitaxed to a Cu(001) substrate as a function of film thickness over a range of 1–10 monolayers. The cobalt films show the effect of a stable magnetic moment in a homogeneously strained film. The iron films show more complex behavior indicative of inhomogeneous strain associated with an unstable magnetic moment and strong surface magnetic anisotropy effects. The photoemission measurements are compared with in situ magnetometry measurements using the surface magneto-optic Kerr effect (SMOKE).1
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 73 (1993), S. 6760-6762 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have used molecular-beam epitaxy to grow high-quality pseudomorphic Ni and Co1Ni9 films on Cu(001). From temperature-dependent surface magneto-optic Kerr effect measurements of these films, we have determined the finite-size scaling behavior of the Curie temperature of ultrathin films for a thickness range of n=2.5–16 monolayers (ML). The film thickness dependent Curie temperature for each of these ferromagnetic thin-film systems, TC(n), is described by a finite-size scaling formula: [TC(∞) − TC(n)]/TC(n) = [(n − n')/n0]−1/ν, where TC(∞) is the bulk Curie temperature, n0=2.5±0.5 ML for Co films and 3.5±0.4 ML for Ni and Co1Ni9 films is the microscopic length scale, and ν=0.76±0.08 is the bulk correlation length exponent. An interesting result is that TC(n) extrapolates to zero in the single mononolayer limit, n'=1.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 62 (1991), S. 1475-1480 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A potential modulation differentiation technique which uses heterodyne modulation is presented. The second derivative I‘(V) of the collected current I(V) is obtained by modulating the voltage V using two synchronized signals with angular frequencies Kω0 and (K − 1)ω0, K(very-much-greater-than)1, and detecting the component of the collected current with angular frequency ω0. This technique eliminates problems caused by stray capacitively coupled signals and harmonic distortions produced by the signal generator and the preamplifiers. It can be applied to techniques in which the desired signal is the second derivative of the collected current, such as retarding field Auger electron spectroscopy, appearance potential spectroscopy, and work-function measurements. Auger spectra obtained using a multigrid retarding field analyzer and the proposed modulation technique show that only three grids are needed rather than the four grids required in the conventional experimental setup. Furthermore, there is no need for resonant filters or neutralization (bridge) amplifiers, and the high dynamic range commercial lock-in amplifier can be replaced by a circuit based on a single chip.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Publishing Ltd
    Soil use and management 14 (1998), S. 0 
    ISSN: 1475-2743
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Geosciences , Agriculture, Forestry, Horticulture, Fishery, Domestic Science, Nutrition
    Notes: Abstract. The stability of aggregates can be improved by amending the soil with charged synthetic polymers. We have evaluated the effects of addition of low rates of anionic polyacrylamide (PAM) on the stability of aggregates from three predominately kaolinitic soils, and investigated whether the applied PAM penetrated into the aggregates or was adsorbed onto exterior surfaces only. Aggregates (6.3–9.5 mm) from the Ap horizons of a Cecil sandy loam and a Cecil loamy sand (Typic Kanhapludult) and from the Bt horizon of a Davidson clay (Rhodic Kandiudult) were treated with a high molecular weight(2 × 107Da), negatively charged (20% hydrolysis) PAM at rates of 0, 10 or 20 kg/ha. The treated aggregate were dried and exposed to 20 mm of high kinetic energy (23.0 kJ/m3) simulated rain. Some of the PAM-treated Cecil loamy sand aggregates (5 or 10 kg/ha) were broken in half to expose untreated aggregate interiors to the rain. Percentage stable aggregates (weight/weight) in the PAM treatments ranged from 52 to 97%, vs. 20-32% in the control. PAM addition significantly increased the percentage of 〉4 mm sized aggregates compared with the untreated aggregates. PAM was more effective at stabilization in the light to medium textured Cecil soils than in the clayey Davidson. When internal surfaces of PAM treated aggregates were exposed, the percentage of stable aggregates exceeded the amount expected if the polymer was only adsorbed on to external surfaces. This suggested that some PAM had penetrated to some degree into aggregate interiors, thereby stabilizing both external and internal aggregates surfaces. Based on these results it is envisaged that use of PAM could be a viable alternative to the commonly used soil and water conservation practices (e.g. mulching, dyking, contour tillage).
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 79 (1996), S. 5635-5637 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have investigated ultrathin FexNi1−x films grown epitaxially on Cu(100) with different stochiometry. With the surface magneto-optic Kerr effect (SMOKE) we measured the variation of the Curie temperature TC as a function of the film thickness n in monolayers (ML). Using the results of our previous investigations on finite-size scaling (Huang et al.), we are able to extrapolate the value TC(∞) for samples with different Fe content. In particular, alloy films with Fe concentrations close to 65% remain ferromagnetic. This is in contrast to bulk Fe65Ni35, which shows a collapse of long range order, which is the so-called invar effect associated with a fcc to bcc structural transition. Growing these alloy films on a Cu(100) substrate forces them to adapt the Cu lattice spacing, thereby suppressing the structural relaxation. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The magnetic structure of nanoscale alloy films has been probed using the magnetic x-ray linear dichroism in photoelectron spectroscopy. FeNi and CoFe epitaxial films were grown on Cu(001), in situ and using molecular beam epitaxy techniques. The magnetic x-ray linear dichroism measurements were made at the Spectromicroscopy Facility of the Third Generation Advanced Light Source. Because soft x-rays were used to generate photoemission from the 3p core levels, both elemental selectivity and magnetic sensitivity were achieved simultaneously. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...