ISSN:
1432-1351
Source:
Springer Online Journal Archives 1860-2000
Topics:
Biology
,
Medicine
Description / Table of Contents:
Summary The current-voltage characteristic of a K. depolarized node is regarded as stationary when the increasing impressed voltage varies by less than 3 mV/sec in the direction of polarization. The stationary characteristic has the following properties: 1. It is a curve of the 3rd. degree and, consequently, consists of 3 separate branches. A high-ohmic branch lies between resting potential and break-down voltage, i.e. −90 mV, and a low-ohmic branch lies above +22 mV. In the transition region, between resting potential and +22 mV, the two branches of positive resistance transfer and form the transition branch. The size of the transition region is constant and independent of the depolarization amplitude above 30 mM/l [K.]0. 2. The high-ohmic branch is linear and its gradient is independent of the depolarization amplitude. The low-ohmic branch is linear at high [K.]0 above +50 mV. Its slope increases with increasing depolarization amplitudes (between 0 and 50 mV at 40%). The transition branch includes a point of inflection. The differential resistance at the point of inflection is dependent upon the positive branch gradient and upon the depolarization amplitude. The transition branch becomes negative above 15 mM/l [K.]0. 3. Using simple correlations, the negative resistance, for all conditions of [K.]0 depolarization, can be fairly accurately calculated where the rectifier characteristic of the preparation is known. 4. The stationary characteristic during a Varatridin depolarization shows, in principle, the same properties. As a result of the investigation, we deduced the following points: 1. A transition region of constant size exists. Within this the positive resistances transfer and the negative resistance is thus formed. 2. The value of the negative resistance depends upon the positive resistances and the depolarization amplitude.
Notes:
Zusammenfassung Die Strom-Spannungscharakteristik des K-depolarisierten Schnürrings kann als stationär betrachtet werden, wenn die eingeprägte Meßspannung um weniger als 3 mV/sec in Polarisationsrichtung ansteigt. Die stationäre Kennlinie zeigt folgende Eigenschaften: 1. Als Kurve 3. Grades kann sie in drei Abschnitte eingeteilt werden. Ein hochohmiger Ast liegt zwischen Ruhepotential und −90 mV, der Durchschlagspannung, ein niederohmiger oberhalb +22 mV. Im Übergangsbereich zwischen dem Ruhepotential und +22 mV gehen beide Äste positiven Widerstandes ineinander über und bilden den Übergangsast. Der Übergangsbereich ist bei [K.]0〉30 mM/l konstant, also auch unabhängig von der Depolarisationsamplitude. 2. Der hochohmige Ast ist linear und seine Neigung unabhängig von der Depolarisationsamplitude. Der niederohmige Ast wird erst bei hohen [K.]0 oberhalb +50 mV linear; seine Steilheit nimmt mit zunehmender Depolarisationsamplitude zu (zwischen 0 und 50 mV um 40%). Der Übergangsast weist einen Wendepunkt auf. Der kleinste Wert des differentiellen Widerstandes im Übergangsbereich ist von der Neigung der positiven Äste sowie von der Depolarisationsamplitude abhängig und wird oberhalb 15 mM/l [K.]0 negativ. 3. Einfache lineare Zusammenhänge erlauben es, den negativen Widerstand eines Präparates für alle K.-Depolarisationszustände näherungsweise vorauszuberechnen, wenn die Gleichrichtercharakteristik bekannt ist. 4. Die stationäre Kennlinie während einer Veratridindepolarisation zeigt neben einigen im Detail beschriebenen Unterschieden grundsätzsätzlich die gleichen Eigenschaften wie die K.-Kennlinie. Als wichtigstes Resultat der Untersuchungen betrachten wir die Feststellung, daß 1. ein Übergangsbereich konstanter Spannung vorhanden ist und 2. die Größe des negativen Widerstandes durch die positiven Widerstände, durch den Übergangsbereich und die Depolarisationsamplitude bestimmt ist.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF00343657
Permalink