ISSN:
0021-8995
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
,
Physics
Notes:
Two commercial styrene-butadiene (SBR) latexes were used to prepare a model filled material consisting of glassy SBR filler particles about 1000 Å in diameter embedded in a rubbery SBR matrix crosslinked by γ-radiation. When transparent specimens of this material were extended, voiding occurred, as evidenced by stress whitening and greatly enhanced X-ray scattering intensity. More voids were formed at higher rates of extension, but voids disappeared when specimens were relaxed. The effects of filler content and cure time of the matrix on the size and number of voids formed were determined by low-angle X-ray scattering for a constant extension rate and a constant extension ratio λ = 1.6. The number of voids measured by X-ray scattering intensity decreased rapidly with time over the 3-h period of measurement. The number of voids remaining 1 h after extension increased about 40 times as filler content was increased from 15% to 50%. Increasing the cure time from 24 to 96 h increased the number of voids about four times. In contrast, the radius of gyration of the voids formed (250-350 Å) did not depend strongly on time, nor did it depend strongly on the filler content or the cure time of the matrix. Stress relaxation measurements made under the same conditions as X-ray scattering measurements showed effects typical of filled materials. However, the relaxation of stress (which followed a power law decay) was much slower than the decay of the number of voids as measured by X-ray scattering intensity.
Additional Material:
15 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/app.1981.070261219
Permalink
