ISSN:
0003-3146
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Physics
Description / Table of Contents:
Die molekulare Orientierung kreisförmiger Platten aus isotaktischem Polypropylen wurde anhand der optischen Doppelbrechung und des Infrarot-Dichroismus untersucht. Die Proben wurden zwischen vorgeheizten Pressplatten und ohne Verwendung von Gleitmitteln an der Pressplattenoberfläche einachsig komprimiert. Die Orientierung war inhomogen über den Querschnitt der Scheiben und vom Radius abhängig. Die Makromoleküle der kristallinen Bereiche in der Nähe der Plattenoberfläche waren überwiegend radial ausgerichtet, wobei in der Mite des Querschnitts die Orientierung axial war. Die mittlere Orientierung der Ketten surde zwischen diesen beiden Extremfällen almählich gedreht, wobei der Orientierungsfaktor den Nullpunkt durchschritt und damit das Vorzeichen wechselte. Die Entstehung dieses Orientierungsprofils wird mit den „springbrunnenähnlichen“ Strömungslinien, welche bei der Deformation gebildet werden, erklärt. Der mechanische Bruch der in radiale bzw. tangentiale Richtung gezogenen Proben erfolgte meistens in der Mitte des Querschnitts. Dieses überraschende Resultat wird der beobachteten axialen Kettenorientierung in der mittleren Probenebene zugeschrieben.
Notes:
The molecular orientation in isotactic polypropylene disks compressed uniaxially in the solid state using non-lubricated press platens was studied by measuring optical birefringence and infrared dichroism. The orientation profile was inhomogeneous through the disk thickness and was dependent on the radial distance from the disk axis. The results indicate that, near the disk surface, the polymer chains in the crystalline regions are oriented parallel to the radial direction, while the chain direction becomes gradually perpendicular to the disk surface near the mid-thickness at the disk. There is consequently a continuous rotation of the chain direction in the crystalline phase between these extremes, with the orientation factor going through zero. The formation of this orientation profile is explained by the observed fountain-flow conditions during the compressive deformation. Mechanical failure of the specimens cut in the radial and in the tangential directions was usually initiated at the mid-plane of the disks. This unusual behavior was attributed to the predominantly perpendicular orientation of the macromolecules in the polymer crystallites near the mid-plane of the oriented disks.
Additional Material:
10 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/apmc.1993.052050114
Permalink