Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Industrial & engineering chemistry 62 (1970), S. 25-53 
    ISSN: 1520-5045
    Source: ACS Legacy Archives
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1365-2222
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Medicine
    Notes: Rationale Asthmatic airway remodelling is characterized by myofibroblast hyperplasia and subbasement membrane collagen deposition. We hypothesized that cytokines and growth factors implicated in asthmatic airway remodelling are increased in bronchoalveolar lavage (BAL) fluid of asthmatics after segmental allergen challenge (SAC), and that these growth factors and cytokines increase α-smooth muscle actin (α-SMA) and collagen III synthesis by human lung fibroblasts (HLFs).Methods Transforming growth factor (TGF)-β1, TGF-β2, IL-4 and IL-13 levels were measured in BAL fluid from 10 asthmatics and 9 non-asthmatic controls at baseline and then 1 day, 1 week and 2 weeks after SAC. Confluent cultures of HLFs were stimulated by exogenous addition of TGF-β1, TGF-β2, IL-4 or IL-13 (concentration range 0.01–10 ng/mL) over 48 h. Collagen III was measured in culture supernates and α-SMA in cell lysates by Western blot.Results At baseline, there was no difference in BAL fluid concentrations of TGF-β1, IL-4 and IL-13 between asthmatics and controls; however, non-asthmatics had higher concentrations of total TGF-β2. In asthmatics, BAL fluid concentrations of all four factors increased significantly 1 day after SAC. TGF-β1, TGF-β2 and IL-13 concentrations returned to baseline by 1 week after SAC, but BAL fluid IL-4 concentration remained elevated for at least 2 weeks. TGF-β1, TGF-β2 and IL-4 significantly increased α-SMA in fibroblasts, but only IL-4 caused corresponding increases in collagen III synthesis. IL-13 had no direct effects on collagen III synthesis and α-SMA expression.Conclusions Because IL-4 caused a dose-dependent increase in α-SMA and collagen III synthesis, it may be an important cytokine mediating asthmatic airway remodelling. TGF-β1 and TGF-β2 may also play a role in airway remodelling by stimulating phenotypic change of fibroblasts to myofibroblasts. Additionally, collagen III synthesis appears to be independent of myofibroblast phenotype and is apparently regulated by different growth factors and cytokines.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1432-1041
    Keywords: Atrial natriuretic peptide ; Hypertension ; SCH 42354 ; blood pressure ; neutral metalloendopeptidase ; pharmacodynamics ; pharmacokinetics
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Medicine
    Notes: Abstract SCH 42354, a neutral metalloendopeptidase (NEP) inhibitor, is the pharmacologically active form of the prodrug SCH 42495. It exerts antihypertensive effects by potentiating atrial natriuretic peptide (ANP) activity through inhibition of its hydrolysis by NEP. The objective of this study was to characterize the pharmacokinetics (PK) and pharmacodynamics (PD) of SCH 42354 in hypertensive males. SCH 42495 12.5 to 400 mg was administered orally to hypertensive men twice daily in a double-blind, placebo controlled multiple-dose parallel group design. Plasma SCH 42354 concentration and diastolic blood pressure (DBP) data were used to develop a PK-PD model using two approaches. In the first (non-integrated) approach, the “link” model was used to predict effect-site concentrations, and was applied to data obtained at the 300 and 400 mg BID doses only; data at the other (lower) doses were not amenable to modeling because of high variability. Effect-site concentration and DBP data were then fit to a sigmoid Emax PD model. For the 300 mg BID dose, PD parameters were: maximum effect (Emax), 8.1mmHg; no-drug effect (Eo), 3.6 mmHg; concentration corresponding to 50% of maximum response (EC50), 0.87 μg·ml−1; and gamma, 3.9. In the second (time-integrated) approach, plasma SCH 42354 concentration and effect data obtained over the entire dose range were integrated with respect to time. Average plasma concentration and DBP data were then fit to a simple Emax PD model. PD parameters obtained over the dose range were: Emax, 10.3 mmHg; Eo, 2.0 mmHg; and EC50, 0.7 μg·ml−1. These were similar to the estimates obtained from the first approach, demonstrating that the integrated (average) data allow PK-PD modeling over the (entire) dose range. The analysis showed that, at steady-state, a 400 mg BID dose of SCH 42495 produced an approximate 10 mmHg decrease in DBP in hypertensive males; the average plasma SCH 42354 concentration attained at this dose was approximately 1.8 μg·ml−1.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 19 (1984), S. 2057-2063 
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract Growth of Nb3Sn layers in multifilamentary composites has been investigated and their superconducting critical temperatures are measured using both resistive and inductive techniques. The growth parameters are discussed in the light of the analytical models of Reddi et al. Results show that for the composites studied, the rate controlling step for Nb3Sn growth is diffusion of tin through grain boundaries of Nb3Sn with the time exponent n determined by both the initial grain size and grain growth. T c measurements show that for composites with a higher filament number, the width of superconducting transition is broader with no significant change in the onset T c.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Theoretical and applied genetics 80 (1990), S. 537-541 
    ISSN: 1432-2242
    Keywords: Brassica campestris ; B. juncea ; B. napus ; Diplotaxis siifolia ; Intergeneric hybrid
    Source: Springer Online Journal Archives 1860-2000
    Topics: Biology
    Notes: Summary Attempts were made to obtain intergeneric hybrids between Diplotaxis siifolia, a wild species, and cultivars of Brassica (B. campestris, B. juncea, and B. napus). The crosses showed unilateral incompatibility. When the wild species was used as female parent, pollen germination and pollen tube growth were normal, but hybrid seeds aborted due to post-fertilization barriers. Reciprocal crosses (cultivars as female parent) showed strong pre-fertilization barriers; although pollen grains showed germination, pollen tubes failed to enter the stigma. Hybrids were realized in two of the crosses, D. siifolia x B. juncea and D. siifolia x B. napus, through ovary culture. The hybrids were multiplied in vitro by multiplication of axillary shoots, or somatic embryogenesis. Detailed studies were carried out on the hybrid D. siifolia x B. juncea. F1 hybrids had shrivelled anthers and were pollen sterile. Amphiploids of this hybrid showed 60% pollen fertility and produced seeds upon self-pollination as well as backcross pollination with the pollen of B. juncea.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...