Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    Contributions to mineralogy and petrology 96 (1987), S. 151-162 
    ISSN: 1432-0967
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geosciences
    Notes: Abstract The Agnew nickel sulfide deposit is spatially associated with a lenticular body of ultramafic rocks which shows a concentric zonation in metamorphic mineralogy. Olivine + tremolite + chlorite + cummingtonite ±enstatite assemblages occur at the margin of the ultramafic lens, giving way to olivine + anthophyllite, olivine + talc and olivine + antigorite assemblages successively inwards. These rocks are interpreted as having crystallized from komatiitic lavas, and exhibit a spectrum of compositions from those of original flow tops to pure olivine adcumulates. The relative modal abundances of metamorphic olivine, tremolite and chlorite reflect original proportions of cumulus olivine and komatiite liquid in the protolith. Peak metamorphic conditions are estimated at 550° C, based on garnet-biotite thermometry, at a maximum pressure of 3 kb. This temperature falls within the narrow range over which metamorphic olivine may co-exist with enstatite, anthophyllite, talc or antigorite depending upon the fugacity of water in the metamorphic fluid. The observed mineralogical zonation is therefore attributed to infiltration by CO2-rich fluids, generated by decarbonation of talc-carbonate rocks formed during pre-metamorphic marginal alteration of the ultramafic lens. Metamorphic fluids were essentially binary mixtures of water and CO2, with minor H2S having a maximum partial pressure less than 1 percent of total pressure. Enstatite-bearing assemblages formed in the presence of CO2-rich fluids at fluid: rock volume ratios close to one, while anthophyllite, talc and antigorite bearing assemblages formed in the presence of progressively more water-rich fluids at progressively lower fluid-rock ratios.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Springer
    Contributions to mineralogy and petrology 105 (1990), S. 704-714 
    ISSN: 1432-0967
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geosciences
    Notes: Abstract Spinifex-textured komatiites at Honeymoon Well, Western Australia, show evidence of partial melting and recrystallization of original igneous textures. Their textures and mineral compositions differ markedly from those typical of komatiites. Spinifex olivine plates are bent and broken, while interstitial space between spinifex and cumulus olivine is occupied by polygonal aggregates of clinopyroxene, orthopyroxene, minor olivine and plagioclase. Similar granular pyroxene-plagioclase aggregates occur as diffuse veins cutting spinifex zones and cumulate zones of the flows and, in places, form the matrix to a breccia containing corroded fragments of spinifex rock. Thermometry based on the two pyroxene assemblages yields temperatures of 1055° to 1141° C, just below the low-pressure komatiite solidus. Mineral compositions are different from those of typical komatiites: clinopyroxenes are Al-poor and Cr-rich, olivines are unusually iron-rich and depleted in Cr and Ca, and the low-Ca pyroxene is bronzite rather than the more typical pigeonite. We interpret these observations as the results of thermal metamorphism, partial remelting and subsequent slow crystallization of originally normal spinifex-textured komatiite flows. The rocks in question occupy a 40–70 m interval sandwiched between two olivine-rich units: an underlying 90 m-thick olivine adcumulate layer, forming part of the cumulate zone of a basal 160 m-thick flow, and an overlying 1 km-thick extrusive body composed mostly of olivine mesocumulate and adcumulate and capped in turn by spinifex-textured flows. Thermal modelling shows that a sinusoidal temperature profile of cool flow tops and hot flow centres would exist within this sequence shortly after eruption. Conductive thermal relaxation of this profile could reheat spinifex zones to the extent of inducing partial melting and textural reconstitution. Such reheating is largely dependent on the time interval between the emplacement of successive flows. Calculations suggest that at Honeymoon Well the emplacement interval must have been of the order of 10 years or less. Textural reconstitution may have contributed to the development of the thick orthocumulate sequences characteristic of komatiites in the Agnew-Wiluna belt.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...