Bibliothek

feed icon rss

Ihre E-Mail wurde erfolgreich gesendet. Bitte prüfen Sie Ihren Maileingang.

Leider ist ein Fehler beim E-Mail-Versand aufgetreten. Bitte versuchen Sie es erneut.

Vorgang fortführen?

Exportieren
Filter
Materialart
Erscheinungszeitraum
  • 1
    Digitale Medien
    Digitale Medien
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 70 (1999), S. 85-91 
    ISSN: 1089-7623
    Quelle: AIP Digital Archive
    Thema: Physik , Elektrotechnik, Elektronik, Nachrichtentechnik
    Notizen: The design and fabrication of a low-cost, highly sensitive, fully automated vibrating sample magnetometer for dc magnetization measurements is described. Harmonic detection of magnetic multipole moments is demonstrated experimentally in an inhomogeneously magnetized nickel sample at room temperature and in a gadolinium sample across the magnetic phase transition. A method is presented to nullify the earth's effective field even without any shielding. More significant, the setup uses only one lock-in amplifier for signal detection, vibration excitation, and temperature measurement and control. First principles calculations give an absolute determination of the instrumental conversion factor that agrees with the experimental calibration factor. The setup is stable from 77 to 300 K, the overall sensitivity is ≤5×10−6 emu, and the reproducibility is ≤1%. © 1999 American Institute of Physics.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 2
    Digitale Medien
    Digitale Medien
    Springer
    Journal of materials science 19 (1984), S. 509-517 
    ISSN: 1573-4803
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract A method which allows calculation of recovery rates and work hardening coefficients for creep from simple constant velocity compression experiments is described. Stressing rates and straining rates are computed from the measured load-time curves, and these quantities are then fitted to the universal form of the Bailey-Orowan equation for creep. The techniques were applied to B2 crystal structure Fe-39.8 at % Al intermetallics and the directionally solidified eutectic alloyγ/γ′-α compression tested between 1200 and 1400 K. The recovery rates were found to be functions of nominal strain rate, stress, and temperature; the hardening coefficients were dependent only on temperature. Hardening coefficients for the aluminides are small (〈0.002 of the elastic modulus) and are believed to be due to the lack of dislocation barriers. A more typical value for the hardening coefficient (∼ 0.05 of the elastic modulus) was observed inγ/γ′-α. Recovery rates and hardening coefficients can be described in terms of stress and temperature, and the equations used to estimate creep rates.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 3
    Digitale Medien
    Digitale Medien
    Springer
    Journal of materials science 19 (1984), S. 509-517 
    ISSN: 1573-4803
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract A method which allows calculation of recovery rates and work hardening coefficients for creep from simple constant velocity compression experiments is described. Stressing rates and straining rates are computed from the measured load-time curves, and these quantities are then fitted to the universal form of the Bailey-Orowan equation for creep. The techniques were applied to B2 crystal structure Fe-39.8 at % Al intermetallics and the directionally solidified eutectic alloyγ/γ′-α compression tested between 1200 and 1400 K. The recovery rates were found to be functions of nominal strain rate, stress, and temperature; the hardening coefficients were dependent only on temperature. Hardening coefficients for the aluminides are small (〈0.002 of the elastic modulus) and are believed to be due to the lack of dislocation barriers. A more typical value for the hardening coefficient (∼ 0.05 of the elastic modulus) was observed inγ/γ′-α. Recovery rates and hardening coefficients can be described in terms of stress and temperature, and the equations used to estimate creep rates.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 4
    ISSN: 1573-4803
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract An electron-beam melting and centrifugal splat-quenching technique for the production of microflakes of Ti-6A1-4V (wt%) alloy quenched at an average cooling rate of about 105 K sec−1 is described. The effect of substrate angle on the shape, size, microstructure and average cooling rate of the flakes of major sieve fractions is discussed. Morphologies of particles of minor sieve fractions are dealt with briefly.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 5
    Digitale Medien
    Digitale Medien
    Springer
    Journal of materials science 9 (1974), S. 1521-1535 
    ISSN: 1573-4803
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract The literature pertaining to the microstructural and crystallographic features of thermoelasticity, pseudoelasticity and memory effects associated with martensitic transformations is reviewed. The interrelations between the various effects are described. An introduction to the mechanical behaviour and the thermodynamic parameters is given.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 6
    Digitale Medien
    Digitale Medien
    Springer
    Journal of materials science 9 (1974), S. 1536-1544 
    ISSN: 1573-4803
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract The macroscopic mechanical behaviour (stress-strain-temperature relations in tension, compression and internal friction) associated with pseudoelasticity and the memory effects is extensively reviewed. The particular features of the tension and compression curves (the stress to induce or reorient the martensite, total elongation, reversibility and hysteresis) are analysed and their dependence on temperature and crystal orientation is discussed.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 7
    Digitale Medien
    Digitale Medien
    Springer
    Journal of materials science 9 (1974), S. 1545-1555 
    ISSN: 1573-4803
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract The pertinent thermodynamic relations, nucleation and growth and the influence of stress are considered and applied to thermoelasticity and the memory effects.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
Schließen ⊗
Diese Webseite nutzt Cookies und das Analyse-Tool Matomo. Weitere Informationen finden Sie hier...