Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-1: Polymer Chemistry 6 (1968), S. 1431-1440 
    ISSN: 0449-296X
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: By irradiation with gamma rays styrene was grafted onto hydrochloric acid lignin. When the graft polymers were subjected to nitrobenzene oxidation, the vanillin yields indicated two kinds of reaction occurring in the grafting. Polystyrene branches were separated from the graft polymers, and their M̄n were determined osmometrically. At grafting ratios of up to 100 the vanillin yields diminished proportionately with increasing grafting, and the M̄n of the branches, 5000, was unchanged. At grafting ratios of more than 100 the vanillin yields were constant, independent of the ratios, but the M̄n values of the branches increased with grafting. Paper chromatography of the aromatic acids obtained by oxidation of methylated lignin and the graft polymer indicated that isohemipic and metahemipic acids were more abundant in the acid fraction of the graft polymer than in the lignin itself. A qualitative mass analysis of the gaseous products evolving from the irradiated lignin showed the presence of hydrogen molecules only. Gamma-ray radiation brought about no change in the yields of vanillin. It was therefore concluded that radiation grafting on lignin at grafting ratios of less than 100 proceeded through the addition of the styrene polymer radicals to the aromatic nuclei of the lignin and that then branches propagated from the aliphatic part of the lignin, where C—H bond scission had been caused by the irradiation. The grafting sites of lignin would be C-5 and C-6 of the guaiacyl nucleus and, probably the β and γ carbon atoms of the aliphatic side chain of the lignin.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-1: Polymer Chemistry 9 (1971), S. 855-866 
    ISSN: 0449-296X
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Graft copolymerization of methyl methacrylate onto lignosulfonate in aqueous medium was investigated. It was found that the H2O2-Fe(II) redox system is very effective for the grafting (Ea = 4.4 kcal/mole). The H2O2/Fe2+ ratio was the most important factor in the graft copolymerization and characteristics of the resultant graft copolymers. In most cases, polymerization for 100 min at 30°C was enough to obtain 80% conversion and 50-60% grafting efficiency. The resultant polymer mixture was subjected to extraction alternately with acetone and water, and the graft copolymer was isolated free from homopolymer and unreacted lignosulfonate. With increasing H2O2/Fe2+ ratio, the grafting ratio showed a maximum at 4, whereas the yield of graft copolymer and number of poly(methyl methacrylate) branches for every building unit of lignosulfonate increased up to a ratio of 4, both values, however, remaining constant above 4. The graft copolymer obtained for the case H2O2/Fe2+ = 4 consisted of one part of lignosulfonate and five parts of poly(methyl methacrylate). The number of branches in the graft copolymer was 6 × 10-3/OCH3 or one every 167 guaiacyl nuclei.
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...