ISSN:
1741-2765
Source:
Springer Online Journal Archives 1860-2000
Topics:
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
Notes:
Abstract An experimental investigation was conducted to determine the degree of sensitivity of commerically pure copper to strain rate and to note the effect of this sensitivity on the velocity of propagation of shearing strain in copper. Thin-walled cylindrical specimens of copper were loaded in torsion to eliminate the effects of radial inertia. All specimens were annealed and then cold worked in torsion to obtain necessary specimen uniformity. Quasi-static tests were performed on short-length specimens to determine the shearing stress-strain curve of copper at a very low strain rate. The strain-rate sensitivity of copper at low strain rates, from 3×10−4/sec to 5/sec, was tested by loading short specimens at a very slow continuous rate and then suddenly increasing the strain rate. A quasi-static test was also performed to determine the effect of creep on prestressed copper. Dynamic tests involving strain rates up to 500/sec were performed on long specimens with a torsional impact machine. Specimens were tested under stress-free and prestressed initial conditions. The prestressed specimen was loaded at a slow, continuous rate before impact to avoid the undesirable effects of creep which would have occurred with a static preload. Results from the quasi-static tests showed that copper is noticeably sensitive to strain rate in the low strain-rate regions, but that the sensitivity becomes almost constant as the strain rate is increased. Results from the dynamic tests showed that large strains propagated at speeds which agreed well with speeds predicted by the strain-rate-independent theory of plastic-wave propagation. The lower-level strains in the prestressed specimen, however, propagated at much higher speeds than are predicted by the strain-rate independent. Because radial-inertia effects were not present, this discrepancy in measured and predicted speeds for low-level strains must be due to the strain-rate sensitivity of copper.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF02327714
Permalink
