Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 1573-8493
    Source: Springer Online Journal Archives 1860-2000
    Topics: Technology , Process Engineering, Biotechnology, Nutrition Technology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1435-1528
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Conclusion Measurement of the viscosities of polystyrene and cyclolinear polyphenylsiloxane depending on their concentrations has revealed critical concentrations of these polymers to exist corresponding to the formation of a fluctuating continuous supermolecular network in the solutions. It has been shown on the example of polystyrene solutions that changing from a good to a poor solvent has little effect on the value of the critical concentration. Calculation of the critical concentration with the use of the parameters employed in the free volume theory after the Pezzin method shows good agreement with the critical concentrations determined from the shape of the viscosity vs. concentration dependences of polystyrene solutions. A method is described for producing polymer aerogels by sublimation of the frozen solvent from polymer solutions. It is shown that to obtain aerogels with very high specific surface areas from crystallized solutions is necessary to fulfil at least two conditions: 1. to freeze them quickly; 2. to sublimate the solvent in vacuo at a sufficiently low temperature. Special attention is drawn to the fact that the effectivity of sublimation drying should be estimated by the specific surface area of the preparations obtained as a result of drying. Mesurement of the specific surface areas of aerogels obtained under appropriate conditions from polymer solutions of different concentrations shows that with a poor solvent the aerogels have specific surface areas one decimal order lower. Hence it is concluded that solutions of polymers in poor solvents should yield stronger and less permeable polymeric systems. In all the cases studied the dependence of the specific surface area of the aerogel on the concentration of the polymer in the solution has a distinct maximum which corresponds to the critical concentration determined viscometrically. This is evidence of the correspondence between the structure of the aerogels and the structure of the initial solutions, at least, at concentrations in the region of their critical and above-critical values. Sublimation of the solvent from frozen polymer solutions results in contraction of the samples, which is the most considerable at polymer concentrations below critical. This is also connected with the relatively low specific surface areas of aerogels obtained from solutions of low concentrations.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The experimental results of the Viscoelastic properties of linear polymers of narrow molecular weight distribution (MWD) and of their mixtures have been analyzed and generalized. Based on the study of the properties of polymers of narrow MWD, we propose a classification of high molecular weight compounds. It specifies a distinct boundary between oligomers and polymers, assuming that the most important feature of polymers is the manifestation of large high-elastic recoverable deformations of entropy character. For polymers to be characterized, not the absolute molecular weight is essential, but the molecular weight referred to the boundary values. The corresponding state for polymers is attained at temperatures 100°C away from the glass temperature. The transition from the fluid to the high-elastic state with increasing deformation rate (or frequency for cyclic deformation) has been studied. Transition to the high-elastic state takes place over a narrow stress range (0.1-1.0 dynes/cm2), independent of molecular weight, whereas the critical deformation rates (frequencies), like viscosity, depend greatly on molecular weight. An increase in the amount of deformation shifts, to u certain extent, this transition to lower Kites of deformation (frequencies). In the region of deformation rates (frequencies) corresponding to the high-elastic state, the effect of large deformations during shear manifests itself largely in the tear-off of polymers Iron, the confining surfaces and in specimen rupture. Polydispersity has a strong effect on the properties of polymeric systems. As the rate of deformation is increased, the transition proceeds successively from the higher molecular weight components. This relaxational transition is tantamount to a change of the structure for polymeric systems. It is responsible for non-linear, particularly, non-Newtonian behavior of such systems. The transition to the high-elastic state and all the related phenomena are observed also in concentrated solutions of high molecular weight polymers. The long-term durability of un-cured rubbers in the high-elastic state is described by the same relationships.
    Additional Material: 11 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 1435-1536
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Description / Table of Contents: Zusammenfassung Mit Viskositätsmessungen und mittels Bestimmung der spezifischen Oberfläche an Aerogelen, erhalten durch “Sublimation” des Lösungsmittels aus Lösungen Polymerer, wurde die Existenz einer kritischen Konzentration für Polystyrol und zyklisches lineares Polyphenylsiloxan festgestellt, hervorgerufen durch Aufbau struktureller Netzwerke. Theoretisch vorausgesagte und experimentell gefundene Werte für die kritischen Konzentrationen stimmen überein. Bedingungen für die Präparation von definierten Aerogelen mit durch Sublimationstrocknung erzielter Oberfläche wurden festgelegt. Die Abhängigkeit der spezifischen Oberflächen von Aerogel von der Polymerkonzentration in Lösung zeigt ein ausgeprägtes Maximum bei der kritischen Konzentration, die man aus den Viskositätsmessungen findet.
    Notes: Summary Critical concentrations of polystyrene and cyclolinear polyphenylsiloxane solutions corresponding to rising of structural networks have been determined by viscosity measurements and by measurements of specific surface of aerogels obtained by solvent sublimation. Theoretical and experimental values of critical concentrations coincide. Conditions for preparation of aerogels with developed surface by sublimation drying have been determined. Dependence of aerogel specific surface on polymer concentration in solutions shows distinct maximum at critical concentration found by viscosimetric method.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...