Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Chichester : Wiley-Blackwell
    Journal of Chemical Technology AND Biotechnology 66 (1996), S. 251-264 
    ISSN: 0268-2575
    Keywords: anaerobic digestion ; anhybrid reactors ; organic solvents ; biodegradation ; trace elements ; population composition ; granular structure ; Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Process Engineering, Biotechnology, Nutrition Technology
    Notes: The performance of anaerobic hybrid reactors treating an organic solvent-containing synthetic pharmaceutical wastewater was evaluated under various wastewater volumetric loading rates and influent compositional changes. The biodegradation, toxicity and treatability of the target C3 and C4 solvents, tert-butanol, isopropanol, isobutanol, sec-butanol and ethyl acetate, were examined. At a hydraulic retention time (HRT) of 2 days and volumetric loading rates ranging from 3·5 to 4·5 kg COD m-3 day-1, the reactors achieved total and soluble COD removal efficiencies of 97-99% in less than five times the HRT. These removal rates were achieved following the introduction of target solvents not previously supplied to the reactors. However, inadequate removal of tert-butanol resulted in a decrease in the soluble COD removal efficiency to 58%. Bacterial enrichments from the reactor biomass using tert-butanol as the sole substrate proved unsuccessful, confirming that tert-butanol is poorly degradable anaerobically. Inclusion of a trace metal cocktail in the feed did not affect steady-state reactor performance, but was beneficial during changes in the influent composition. After 405 days of operation, the matrix-associated biomass contributed only a minor fraction (2-4%) of the total biomass present in both reactors. On takedown, the retained biomass present in the matrix-free section of both reactors was found to be granular in nature, despite the omission of trace elements from the influent to one of the AHRs. The specific methanogenic activity profile of the granular sludge from the trace element limited AHR was, however, significantly lower (α = 0·05) than that of the reference AHR.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Weinheim : Wiley-Blackwell
    Journal of High Resolution Chromatography 23 (2000), S. 81-88 
    ISSN: 0935-6304
    Keywords: Monolithic chromatography columns ; capillary electrochromatography (CEC) ; micro high performance liquid chromatography ; sol-gel based columns for chromatography ; fritless capillary chromatography columns ; Chemistry ; Analytical Chemistry and Spectroscopy
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: ---Particle-loaded (3 μm, octadecylsilica) monolithic sol-gel columns have been prepared and selected characteristics measured. Several electrical properties may be calculated from simple current measurements in the column as a whole. Resistivity in the packed segment is approximately three times that in open segments, resulting in a 60% increase in field strength in the packed regions compared to the capillary with no packing. The surprisingly high specific permeability of these sol-gel columns is characteristic of 8-μm particles, which allows their operation in the microLC mode at pressures as low as 69 kPa where their efficiency is about 50,000 plates per meter and in the CEC mode where efficiency is about 106,000 plates per meter at 5 kV. There is a relatively rapid loss of efficiency with increasing linear velocity beyond 0.2 mm/s in microLC mode, which may be due to additional diffusion processes in the inter-particulate voids. A rapid loss of efficiency above 0.5 mm/s is also observed in the CEC mode, for the same reasons. Chromatographic retention behavior in either separation mode is characteristic of conventional octadecylsilica particles, indicating that analytes have significant access to the surface within the pores of the immobilized bonded phase.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...