Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 2000-2004  (7)
  • 1995-1999  (21)
Material
Years
Year
  • 1
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The improvement of potential confinement was attained in the GAMMA 10 tandem mirror [Phys. Rev. Lett. 55, 939 (1985); Proceedings of the 13th International Conference on Plasma Physics and Controlled Nuclear Fusion Research, Washington, 1990 (International Atomic Energy Agency, Vienna, 1991), Vol. 2, p. 539] by axisymmetrization of heating systems for the plasma production, heating, and potential formation. A significant increase of the density and diamagnetism by the potential confinement was observed. In the previous experiment, it was difficult to increase the central cell density higher than 2.7×1018 m−3. One of the possible mechanisms is the density clamping due to the eigenmode formation of the ion–cyclotron-range of frequency (ICRF) waves in the axial direction. With high harmonic ICRF waves (RF3), the experiments to overcome this problem have been performed. In preliminary experiments with RF3 and NBI the maximum density of 4×1018 m−3 was attained. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Conductivity and ion density of a plasma channel induced by a mildly relativistic electron beam (300 kV, ∼2 kA, 10–50 ns) have been experimentally investigated under various gas pressures. Pressures of filling gas (air) in this experiment ranged from 10 mTorr to 100 mTorr. The net currents of the beam-induced plasma channel were measured by four Rogowski coils located along the propagating region, while the electron beam currents were measured by a Faraday cup. The inductive plasma currents observed at the above pressure regimes have been characterized by magnetic decay time. Plasma-channel conductivity and ion density induced by the beam are measured along the propagating axial positions under various gas pressures. The numerical result of the ion density is also obtained at the charge neutralization time when the ion density is just the same as the electron beam density, and the digitizing experimental data of the beam current Ib(t) and voltage Vd(t) have been used. As expected, in both numerical and experimental results the ion density increases to a peak value of about 3.0×1011 cm−3 and 3.3×1011 cm−3, respectively, at 50 mTorr and slowly decreases for both cases as the gas pressure increases from 50 mTorr to 100 mTorr. Moreover, the results of ion density predicted by the theoretical model developed here are also found to be in remarkably good agreement with experimental and numerical results at pressure regimes from 10 mTorr to 100 mTorr. © 1998 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Neutron diagnostics are applied to a deuterium plasma mixed with protons in the central cell of the GAMMA 10 tandem mirror [Inutake et al., Phys. Rev. Lett. 55, 939 (1985)]. The deuterium ions are heated with a slow ion cyclotron wave tuned to the fundamental deuterium resonance near the mid-plane of the central cell while the plasma is sustained with the fundamental resonance heating of protons in the minimum-B anchor cells. The measurement is based on in situ calibration to determine the transmission efficiency through machine walls and the counting efficiency of the detection system for neutrons emitted from 252Cf with energy close to that in the deuterium–deuterium (D–D) fusion reaction. The observation shows that the count rate of neutrons increases with diamagnetism, and this relation is accounted for in terms of fusion reaction between deuterium ions with a transverse temperature exceeding 10 keV. Discrepancies among ion temperatures determined with different diagnostics are mostly attributed to insufficient knowledge of the profiles of plasma parameters. The results indicate that the neutron measurement can be added as a powerful diagnostic tool for hot ions if combined with more detailed profile measurements. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 86 (1999), S. 1958-1964 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The crystallization of Ba-ferrite/sapphire(001) films of various thicknesses has been studied using synchrotron x-ray scattering, field emission scanning electron microscope, and atomic force microscope. In films thinner than 1000 Å, Ba-ferrite amorphous precursor was crystallized into perpendicular grains keeping the magnetically easy c-axis normal to the film plane during annealing to 750 °C. In films thicker than 1000 Å, however, acicular grains keeping the c-axis parallel to the film plane were grown on top of the perpendicular grains. The behavior of the saturation magnetization and the intrinsic coercivity was consistent with the thickness dependence of the crystallization. We attribute the thickness dependence of the crystallization to the substrate effect, which prefers the growth of the epitaxial, c-axis oriented perpendicular grains near the film/substrate interfacial area. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: Semiconductor ion detectors are developed and characterized for the purpose of the use for high-output and wide-energy-sensitive upgraded ion diagnostics. In particular, the theoretical basis for the simulation of the semiconductor ion-energy response along with its experimental verification using monoenergetic ion beams is investigated. High-output-current semiconductor signals ranging from one to three orders of magnitude larger than those from widely employed commercially available silicon-surface-barrier detectors are attained in the ion-energy region above 0.2 keV. These data are found to be well fitted by the developed simulation results. In order to observe ion signals alone under the complicated condition of the simultaneous incidence of ions, electrons, and x rays, we develop an upgraded electrostatic ion-energy spectrometer, having specific structures with obliquely positioned multiple grids. The combination of the installation of such a low-ion-energy-sensitive semiconductor detector and this novel-structured ion spectrometer provides a new electrostatic large-output and low-energy-sensitive ion spectrometer having no signal disturbances from the other plasma species and giving no perturbations to ambient plasma-confining magnetic fields. Accordingly, this novel compact-sized electrostatic ion spectrometer using a single-channel semiconductor collector provides temporal-evolution data on ion-energy spectra during a single plasma shot alone; therefore, this spectrometer is usefully applicable to the opportunities of the observations of ion parameters in both divertor and hot-core regions. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: For the purpose of plasma-ion-energy analyses in a wide-energy range from a few hundred eV to hundreds of keV, upgraded semiconductor detectors are newly fabricated and characterized using a test-ion-beam line from 0.3 to 12 keV. In particular, the detectable lowest-ion energy is drastically improved at least down to 0.3 keV; this energy is one to two orders-of-magnitude better than those for commercially available Si-surface-barrier diodes employed for previous plasma-ion diagnostics. A signal-to-noise ratio of two to three orders-of-magnitude better than that for usual metal-collector detectors is demonstrated for the compact-sized semiconductor along with the availability of the use under conditions of a good vacuum and a strong-magnetic field. Such characteristics are achieved due to the improving methods of the optimization of the thicknesses of a Si dead layer and a SiO2 layer, as well as the nitrogen-doping technique near the depletion layer along with minimizing impurity concentrations in Si. Such an upgraded capability of an extremely low-energy-ion detection with the low-noise characteristics enlarges research regimes of plasma-ion behavior using semiconductor detectors not only in the divertor regions of tokamaks but in wider spectra of open-field plasma devices including tandem mirrors. An application of the semiconductor ion detector for plasma-ion diagnostics is demonstrated in a specially designed ion-spectrometer structure. © 1997 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: The energy response of a new semiconductor detector in the ASDEX Upgrade Tokamak for plasma x-ray tomography studies is characterized using synchrotron radiation from a 2.5 GeV positron storage ring at the National Institute for High Energy Physics in Japan. This international collaborating research clarifies a fairly good agreement between the x-ray energy response data and our recently proposed theoretical predictions for such a semiconductor x-ray-detector response. The x-ray response for several positions on the active area of the detector unit is studied; a good uniformity observed guarantees that the detector can employ any sized and shaped collimator for the x-ray tomography regardless of any correction factor coming from the response nonuniformity on the detector active area. Operational conditions of the detector for the ASDEX Upgrade plasma diagnostics are optimized using its capacitance measurements as a function of an applied bias as well as the numerical evaluations of the detector response; these are also directly verified by the synchrotron-radiation experiments. © 1997 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A new x-ray spectrometer using the principle of a photoelectron spectroscopy method is developed for the purpose of the observations of plasma-electron temperatures in the range of a hundred of eV. X-ray photoelectron spectroscopy is a widely utilized method for surface-physics analyses; here, we employ a parallel-plate energy analyzer. This new type spectrometer is calibrated using synchrotron radiation from a 2.5 GeV positron storage ring at the Photon Factory (KEK). Theoretical calculations for photoelectron spectra from plasmas with various electron temperatures are carried out using the calibration data. This spectrometer is set up at the central cell of the GAMMA 10 tandem mirror for the measurements of potential-confined electron temperatures. Experimentally observed spectra are compared with the calculated spectra as well as the data from the other x-ray detection method. © 1995 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: The first results of simultaneous observations of temporally and spatially resolved electron temperatures (Te) in both circularly shaped central-cell and elliptically shaped anchor regions are reported in the GAMMA 10 tandem mirror. A data set is provided using a novel matrix-type x-ray semiconductor detector. The detector has seven "matrix columns" for the measurement of plasma x-ray profiles along with six "matrix rows" for simultaneous analyses of six different x-ray-energy ranges by the fabrication of six different thicknesses of SiO2 semiconductor surface layers from 1 to 495 nm as ultrathin and unbreakable "x-ray absorption filters." Such a matrix idea enables us to analyze x-ray tomography data in the Te region down to a few tens of eV. Simultaneous application of the x-ray detectors in the central-cell and the anchor region gives information on not only detailed electron behavior in each region but also the mutually communicating relation between the two regions: The role of the anchor-region plasmas in magnetohydrodynamic plasma stabilization in the central-cell plasmas is confirmed by the data from these detailed simultaneous electron observations. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: For the purpose of the developments of wide-energy-range-sensitive x-ray detectors, we have designed and fabricated a new-type multilayer semiconductor x-ray detector. This new-type detector has been characterized using synchrotron radiation from a 2.5-GeV positron storage ring at the Photon Factory of the National Laboratory for High Energy Physics (KEK). This new detector is essentially composed of four layers of commercially available photodiodes. Each photodiode is made from a 300-μm thick, and a 10×10-mm square-shaped wafer. For the common affiliation of these individual photodiodes, the quantum efficiency normalized by the photon energy η/E begins to decrease at 8 keV, and then η/E decreases down to 26% at 20 keV. On the other hand, for our newly designed detector a flat response even in the 10–20-keV energy regime (beam line 15C at the Photon Factory) is observed, and even at 100 keV η/E〈30% is still anticipated. This new x-ray detector has various advantages: (i) A compact, and (ii) outgas-free detector for a high-vacuum use, along with (iii) a high degree of immunity to ambient magnetic fields. Furthermore, (iv) the combination of the x-ray signal outputs from each detector layer provides information on the x-ray emitting electron energies. These properties are quite suitable for the use of the fusion-oriented plasma x-ray diagnostics under intense-magnetic field and high-vacuum conditions so as to interpret wide-band x-ray emitting electron-velocity distribution functions from the x-ray data. © 1995 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...