ISSN:
1618-2650
Source:
Springer Online Journal Archives 1860-2000
Topics:
Chemistry and Pharmacology
Description / Table of Contents:
Summary A multielement PIXE method has been developed to analyse water residue obtained by evaporation technique. In this analysis, 250 ml of water sample mixed with 200 mg of cellulose powder is evaporated on steam bath in a platinum dish. From the residue thus obtained standard pellets are made for proton irradiation to excite characteristic X-rays. Proton irradiations were performed with 2.5 MeV beams with 20 nA intensity and the characteristic X-rays were detected with a high resolution Si(Li) detector and processed by standard electronics. A synthetic standard of cellulose matrix for concentration calibration was prepared by adding different elements from atomic absorption standards and homogeneously mixing them with the matrix with methanol. Using the present methodology, for a 20 μC irradiation, it is possible to analyse quantitatively 10–15 different elements (K, Ca, Ti, Cr, Mn, Fe, Ni, Cu, Zn, Br, Sr, Pb, etc.) in water samples. The procedure thus developed has been applied to study the concentration profiles of heavy elements in the municipal water supplies in the city of Dhaka and the results are compared with recommended levels of heavy elements in drinking water. Various aspects of the method and the implications of the data reported here have been discussed.
Notes:
Zusammenfassung 250 ml des Wassers wurden mit 200 mg Cellulosepulver gemischt und eingedampft. Aus dem Rückstand wurden Tabletten für die Protonenbestrahlung gepreßt. Die Bestrahlung wurde mit 2,5 MeV und 20 nA durchgeführt; die charakteristischen Röntgenstrahlen wurden mit Hilfe eines hochauflösenden Si(Li)-Detektors gemessen und elektronisch aufgearbeitet. Synthetische Standards für die Cellulosematrix wurden aus AAS-Standards hergestellt (Mischung mit Methanol). Mit dem beschriebenen Verfahren konnten bei 20-μC-Bestrahlung 10–15 verschiedene Elemente (K, Ca, Ti, Cr, Mn, Fe, Ni, Cu, Zn, Br, Sr, Pb, u.a.) in Wasserproben bestimmt werden. Die Methode wurde zur Untersuchung der Konzentrationsprofile von Schwermetallen im Leitungswasser der Stadt Dhaka eingesetzt, die mit den für Trinkwasser empfohlenen Konzentrationen verglichen wurden. Verschiedene Gesichtspunkte des Verfahrens und der erhaltenen Resultate werden diskutiert.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF00489394
Permalink