Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 1420-9136
    Keywords: Rock failure ; fractal ; percolation ; rock modulus ; damage parameter ; rock mechanics
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geosciences , Physics
    Notes: Abstract The elastic properties of a physical model representing a damaged rock matrix were studied using a square lattice deformed under tensile stress. The elastic modulusM of such a system varies in agreement with percolation theory as|x−x c | f , wherex is the damage parameter andx c the threshold value of the damage parameter,f≃3.6. Atx≃x c the scale dependence ofM can be expressed asM∼L −f/v , whereL is the size of the sample andv the correlation exponent in percolation theory. The experimental results are of interest in assessing elastic properties in earthquake focal zones and fault zones in general.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Springer
    Pure and applied geophysics 140 (1993), S. 79-94 
    ISSN: 1420-9136
    Keywords: Stick-slip ; rock friction ; instability ; precursor ; earthquake
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geosciences , Physics
    Notes: Abstract Stick-slips have been studied in the laboratory on granite, labrodorite and sandstone samples of two different sizes. Different roughness was achieved on the sawcut surfaces by finishing them with different grinding compounds ranging from grit 40 to grit 1000. Stick-slips occurred as a result of 1) slowly increasing the shear and normal stresses, 2) superimposing a sinusoidal stress modulation (0.1 and 10 Hz) on the slowly increasing stresses, 3) triggering by a stress impulse when the shear stress was well below the levels where stick-slips occurred without the impulse, and 4) foreshocks. Stick-slips triggered by impulses or foreshocks occurred “long” after the beginning of the triggering events, i.e., long in comparison with elastic wave travel times through the sample. All triggered events were very rich in high frequencies (corner frequency of ∼100 kHz). The untriggered stick-slips did not contain much energy at the high frequencies (corner frequency of ∼10 kHz). The dynamic friction coefficients for the triggered stick-slips were smaller than for the untriggered events. The “long” delay between the onset of the trigger and the stick-slip, and the high frequencies may be a consequence of corrosion of asperities. The ultimate triggering and the rate of corrosion are likely related to the interplay of the normal and shear stresses as they load and unload the fault surface. The consistent shape of the high frequency spectra is probably due to sample resonances which are excited rather than being characteristic of the details of the stick-slips. If these laboratory observations are directly applicable to earthquake seismology, the spectra of earthquakes which were triggered by other earthquakes should be anomalously rich in high frequencies.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...