ISSN:
0271-2091
Schlagwort(e):
Vertical
;
Eddy
;
Viscosity
;
Galerkin
;
Method
;
Hydrodynamic
;
Model
;
Eigenfunction
;
Currents
;
Roughness length
;
Engineering
;
Engineering General
Quelle:
Wiley InterScience Backfile Collection 1832-2000
Thema:
Maschinenbau
Notizen:
The three dimensional linear hydrodynamic equations which describe wind induced flow in a sea are solved using the Galerkin method. A basis set of eigenfunctions is used in the calculation. These eigenfunctions are determined numerically using an expansion of B-splines.Using the Galerkin method the problem of wind induced flow in a rectangular basin is examined in detail. A no-slip bottom boundary condition with a vertically varying eddy viscosity distribution is employed in the calculation. With a low (of order 1 cm2/s) value of viscosity at the sea bed there is high current shear in this region. Viscosities of the order of 1 cm2/s) value of viscosity at the sea bed there is high current shear in this region. Viscosities of the order of 1 cm2/s near the sea bed together with high current shear in this region are physically realistic and have been observed in the sea.In order to accurately compute the eigenfunctions associated with large (of order 2000 cm2/s at the sea surface to 1 cm2/s at the sea bed) vertical variation of viscosity, an expansion of the order of thirty-five B-splines has to be used. The spline functions are distributed through the vertical so as to give the maximum resolution in the high shear region near the sea bed.Calculations show that in the case of a no-slip bottom boundary condition, with an associated region of high current shear near the sea bed, the Galerkin method with a basis set of the order of ten eigenfunctions (a Galerkin-eigenfunction method) yields an accurate solution of the hydrodynamic equations. However, solving the same problem using the Galerkin method with a basis set of B-splines, requires an expansion of the order of thirty-five spline functions in order to obtain the same accuracy.Comparisons of current profiles and time series of sea surface elevation computed using a model with a slip bottom boundary condition and a model with a no-slip boundary condition have been made. These comparisions show that consistent solutions are obtained from the two models when a physically relistic coefficient of bottom friction is used in the slip model, and a physically realistic bottom roughness length and thickness of the bottom boundary layer are employed in the no-slip model.
Zusätzliches Material:
10 Ill.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1002/fld.1650030105
Permalink
