Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 1975-1979  (3)
  • Chemistry  (3)
Material
Years
Year
Keywords
  • 1
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 22 (1978), S. 727-749 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: High molecular weight linear polymers and their concentrated solutions were investigated over a wide range of frequencies and amplitudes of oscillatory deformation. At definite critical deformation and stress amplitudes, the resistance to deformation drops abruptly as a result of the rupture of continuity of polymer specimens in the region of action of the highest shear stresses. The lowest critical values of deformation rate amplitudes are inversely proportional to the initial viscosity and correspond quantitatively to the critical shear rates at which the spurt occurs during the flow of polymeric systems in ducts. The spurt effect is due to the transition of the polymer systems to the forced high-elastic state, in which they behave like quasi-cured polymers whose deformability is always limited. Up to the critical values of the stress amplitudes, narrow-distribution high molecular weight linear flexible-chain polymers behave like Hookean bodies, whereas the broad-distribution polymers show a sharply defined nonlinear behavior which asymptotically passes to a spurt. The amplitude dependence of the dynamic characteristics of the high molecular weight linear polymers, as well as their non-Newtonian behavior, is due to polymolecularity. An increase in deformation amplitudes reduces the frequency at which the spurt, and hence the transition of the polymer systems to the high-elastic state, is observed. Therefore, under conditions of oscillatory deformation the physical state (fluid or high-elastic) is determined not only by the frequency but also by the value of deformation. In the high-elastic state region (estimated at low amplitude deformation), the critical deformation amplitude is frequency independent and has an unambiguous relationship with the molecular mass of the chain (Me) between the entanglements. For the bulk polymers studied, the spurt in the high-elastic state occurs at stress amplitudes of the order of 105 N/m2 irrespective of frequency, molecular mass, or polymolecularity. In concentrated polymer solutions, in the high-elastic state the critical stress amplitudes decrease with reducing polymer content, whereas the critical deformation amplitudes increase.
    Additional Material: 12 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 22 (1978), S. 751-767 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: During the flow of high molecular weight, narrow-, and broad-distribution polybutadienes and polyisoprenes rheo-optical measurements were conducted of extensional stresses acting along the flow axis in the preentrance and entrance regions of the duct and of their subsequent relaxation in the duct. The extensional stresses increase in the preentrance region, reach their maximum values at a distance of two or three tenths of the duct width from its edges, and then relax. The position of the maximum extensional stress is independent of polymer characteristics, shear stresses in the duct, and shape of the entrance and dimensions of the rectangular duct. The dependence of the maximum extensional stress on the shear stress of the duct wall can be assumed to be linear for small values. The length of the stress relaxation zone depends on the shear stress at the duct wall and the molecular mass distribution. It is independent of the molecular masses in narrow-distribution polymers. For the polymers investigated, a generalized dependence was obtained for the reduced duct length over which the extensional stresses relax to zero from the reduced deformation rate. This dependence takes into account the characteristic polymer relaxation times and the value of the molecular mass of the chain between the fluctuation entanglement. A considerable decrease in the duct's length-to-width ratio leads to an increase in the maximum values of the extensional stresses. A decreases in the duct entrance angle causes a reduction in the rate of increase of extensional stresses, the maximum values, and the acceleration of the relaxation processes in the duct. A decrease in the ratio of the width of the preentrance region to the duct width leads to a reduction in the maximum in extensional stresses. It is shown that one of the causes for the instability of the polymer flow in the ducts can be the rupture of polymers due to their extension in the preentrance and entrance regions. Calculations were done that describe satisfactorily the relationship between the values of the maximum extensional stresses and the shear rate and stresses on the duct wall.
    Additional Material: 16 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 22 (1978), S. 665-677 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The relationship was investigated between birefringence and oscillatory shear deformation of linear high molecular mass polymers exemplified by narrow- and broad-distribution polybutadienes and polyisoprenes. Polymer deformation at different frequencies and amplitudes was carried out in an annular gap. The stress field uniformity was not below 95%. It was shown that in oscillatory deformation of polymers in the fluid and high-elastic states, birefringence contains a time-independent steady component and an oscillatory component with a frequency equal to that of the assigned oscillation. A linear interrelation was found to exist between the amplitude of the oscillatory component of birefringence and that of the shear stresses, with a proportionality factor equal to the stress-optical coefficient of the polymers. The phase of the oscillatory component of birefringence coincides with that of the shear stresses. Measurements of the steady component of the birefringence make it possible to find the steady component of the first normal stress difference resulting from the assignment of shear oscillations to the polymer. On the basis of the experimental data obtained for polybutadienes and polyisoprenes, and the literature data for polystyrene solutions, a master curve was constructed that generalizes the dependence of the steady component of the first normal stress difference in the linear and nonlinear deformation regimes on the product of the square of the deformation amplitude and the storage modulus measured at low amplitudes. This dependence is valid in the linear and nonlinear deformation regimes. It is invariant with frequency, amplitude deformation, molecular mass, and molecular mass distribution of the polymers. It is shown by visual observation of deformation that the abrupt drop in resistance of polymer to shear in large-amplitude deformation is due to polymer rupture near the surface of the inner cylinder and is accompanied by a slip-stick process. This is the phenomenon of spurt early observed in capillary viscometers at high shear stresses and recently investigated in coaxial cylinder devices at large amplitude deformation.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...