Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 17 (1971), S. 575-584 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: A study was made of the atomizing characteristics of convergent-type pneumatic nozzles. Drop-size correlations were obtained for the following ranges: drop size, 6 to 350 μ, mass median diameter; mass flow ratio, 0.06 to 40; relative velocity, 250 ft./sec. to sonic velocity; and viscosity. 1 to 50 cp. The technique employed was to spray cool a molten wax, and melts of wax-polyethylene mixtures. The most important operating variables in pneumatic atomization are the dynamic force of the atomizing gas, and the mass flow ratio of air to liquid. The cumulative volume drop-size distribution of spray from a pneumatic nozzle was fitted by a modified logistic equation. Empirical correlations developed in the study can be used to design nozzles or to predict drop size for sprays produced by the types of nozzles studied. In particular, this study provides new experimental data on the performance of pneumatic atomizers in producing relatively large drops.
    Additional Material: 16 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 20 (1974), S. 670-678 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Diffusion rates were measured at 25°C and 1 atm by a steady state method in pellets of nonporous nickel oxide particles in order to determine the effects of sintering and chemical reduction. Sintering led to a striking decrease in diffusion flux; tortuosities above 100 were found for highly sintered (porosity 0.03) pellets. Reduction caused a sharp increase in diffusion rate when the original pellet was highly sintered. For an originally unsintered pellet the diffusion rate decreased with extent of reduction.These phenomena were explained quantitatively by using: (1) the random pore model to predict tortuosity factors for an unsintered, unreduced pellet, and (2) the extent of pore interconnections and the fractional reduction to treat the effects of sintering and reduction. In this way an approximate, predictive equation was derived which contained no arbitrary parameters and which required for application only data on porosity and extent of chemical reduction.
    Additional Material: 11 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 0935-9648
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 47 (1995), S. 174-180 
    ISSN: 0006-3592
    Keywords: ultrafiltration membranes ; protein fouling ; BET measurements ; Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Membrane morphology is compared to protein depostion under passive adsorption and ultrafiltration conditions. Solute resistance of protein deposits for membranes of varying roughness, structure, and permeability can vary dramatically with operating conditions. Using Brunauer-Emmett-Teller adsorption isotherm (BET), study of the internal area and accessibility of several uttrafiltration membranes to protein deposition allows better understanding of the fouling mechanisms and interpretation of adsorbed protein quantities. © 1995 John Wiley & Sons, Inc.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 42 (1993), S. 260-265 
    ISSN: 0006-3592
    Keywords: fouling ; ultrafiltration ; protein aggregates ; field emission scanning electron microscopy (FESEM) ; Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The factors contributing to protein aggregation in albumin ultrafiltration were investigated as a function of operation conditions. The nature of protein deposits was examined by electron microscopy. Protein aggregation appears to occur as a result of rapid supersaturation of protein molecules and high solvent velocity (shear) in the concentrated layer near the membrane surface. The shear occurring in the solvent flow on the membrane surface probably unfolds protein molecules and thus promotes flocculation due to collision between particles. © 1993 John Wiley & Sons, Inc.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    Surface and Interface Analysis 20 (1993), S. 1061-1066 
    ISSN: 0142-2421
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Physics
    Notes: A GaAs/AlAs superlattice growth by metal-organic chemical vapour deposition is being proposed as the single crystalline multilayer reference material for sputter depth profiling. This material was characterized by transmission electron microscopy experiments, which showed that the interface between GaAs and AlAs is atomically flat. The preliminary depth profiling experiments were carried out by AES and SIMS.The AES experiments were performed using a Perkin-Elmer SAM 660 scanning Auger microprobe and the SIMS experiments were carried out using a VSW multitechnique XPS/SIMS surface analysis system.The AES and SIMS sputter depth profiling experiments proved that the depth resolution was found to be almost constant for each interface when an Ar+ beam was used for sputtering. Therefore the sputtering-induced roughness is very small for this material with Ar+ beam profiling, the depth resolution deteriorated as a function of depth, indicating oxygen ion beam-induced surface roughening.For both AES and SIMS, the depth resolution improved for ion beams with lower kinetic energy and more glancing angles of incidence.
    Additional Material: 10 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    Surface and Interface Analysis 23 (1995), S. 851-857 
    ISSN: 0142-2421
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Physics
    Notes: Because the chemical states of the elements in SrTiO3 thin film on Si are reduced by argon ion beam bombardment, it was impossible to sputter depth profile the chemical states of SrTiO3 thin film by argon ion beams. In this paper, it is reported that the undistorted chemical states of Ti and Si at the SrTiO3/Si interface can be determined with oxygen ion beams at the appropriate 70° angle of incidence, with which either metallic Ti is not oxidized or Ti in SrTiO3 is not reduced. Under the sputter depth profiling conditions, the chemical state of Ti at the SrTiO3/Si interface could be successfully characterized and the effects of post-annealing at high temperature on the chemical state of Ti were studied. A significant number of Ti atoms in the metallic state were observed at the SrTiO3/Si interface without any post-annealing but all of them were oxidized to the Ti4+ chemical state after 2 h post-annealing at the temperatures above 600°C under oxygen flow. The dielectric properties of SrTiO3 thin films on Si were well correlated to the oxidation state of Ti and the broadening of the interface SiO2 layer induced by post-annealing at high temperature.
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 17 (1973), S. 95-103 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Measurements were taken of the viscoelastic properties of six polymer melts by mean of the Weissenberg rheogoniometer and the Han slit/capillary rheometer. Polymers in vestigated were three high-density polyethylenes of different polydispersity, a low-density polyethylene, a polypropylene, and a polystyrene. The range of shear rates tested was from about 5.0 × 10-3 to 10 sec-1 with the Weissenberg rheogoniometer, from about 10 to 102 sec-1 with the slit rheometer, and from about 102 and 103 with the capillary rheometer: the temperature of measurement was 200°C. The three different apparatuses give consistent results over almost six decades of shear rates, yielding satisfactory correlations of shear viscosity to shear rate and of normal stress difference to shear rate.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    ISSN: 0044-8249
    Keywords: Ab-initio-Rechnungen ; Annulene ; Aromatizität ; Bindungslängenalternanz ; Dichtefunktionalrechnungen ; Chemistry ; General Chemistry
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Bognor Regis [u.a.] : Wiley-Blackwell
    Journal of Polymer Science Part A: Polymer Chemistry 36 (1998), S. 1755-1765 
    ISSN: 0887-624X
    Keywords: 1-(trifluoromethyl)-2,3,5,6-benzenetetracarboxylic dianhydride ; amide acid ; poly(amic acid) ; isomeric unit ; nuclear magnetic resonance spectroscopy ; Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Two different poly(amic acid)s were synthesized by the polycondensations of 1-(trifluoromethyl)-2,3,5,6-benzenetetracarboxylic dianhydride (CF3DAN) with p-phenylene diamine and benzidine. In addition, an amide acid model compound was prepared from CF3DAN and aniline. Isomeric units in the poly(amic acid)s as well as the amide acid were investigated by 1H and 13C-nuclear magnetic resonance (NMR) spectroscopies. Spectroscopic results indicate that the major isomeric component was a CF3-meta-isomeric unit centered on the aromatic carbon substituted with the trifluoromethyl group. In particular, the amide acid compound was determined to be composed of 80 mol % CF3-meta-isomer and 20 mol % H-meta-isomer. Therefore, for the poly(amic acid)s, the minor isomeric component is speculated to be a H-meta-isomeric unit rather than a para-isomeric unit. The result might result mainly from the strong electron-withdrawable and bulky trifluoromethyl substituent in the CF3DAN monomer. The strong electron withdrawability might significantly enhance the reactivities of the adjacent carbons in the monomer to the nucleophilic attack of the amino nitrogen in the aniline and diamines, and consequently overcome the role of the bulkyness, ultimately leading to the amide acid and poly(amic acid)s rich with the CF3-meta-isomeric unit. In addition, a portion of the imide form was detected in the dried AN-CF3DAM-AN amide acid. Thus, the formation of imide linkage might be involved in a small portion for the dried poly(amic acid)s. © 1998 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 36: 1755-1765, 1998
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...