Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Dielectric constant and dissipation factor of six types of dielectrics were measured during irradiation in a Co60 source. Tests were made at seven frequencies ranging from 100 cycles/sec. to 100 kcycles/sec. by use of the Schering bridge technique. Polystyrene and polyethylene exhibited no change in loss properties when γ-irradiated to doses as high as 7.7 × 107 and 3.5 × 107 r, respectively. Poly(methyl methacrylate) decreased slightly in dielectric constant and was essentially unchanged in dissipation factor after 5.7 × 107. TFE underwent the most drastic changes. At a very low dose (106 r) the dissipation factor had increased three orders of magnitude (at 100 cycles/sec.) and one order of magnitude (at 100 kcycles/sec.). After peaking, the loss factor decreased slowly. After removal of the source, the loss factor decreased more; then increased rapidly upon admission of air. Both this and the original increase in dissipation factor are indicative of a dipole with a long relaxation time, in which oxygen plays a role. FEP Teflon increased somewhat less than TFE, and the peak was not reached until a dose of 3 × 107 r. Very little effect was produced by the admission of air after irradiation. Dielectric constant decreased with radiation dose. The dissipation factor and dielectric constant of Rayolin N decreased with dose, until a plateau was reached. Very little effect was seen after irradiation, even upon the admission of air. The changes which took place during the radiation period were, as in the case of the other materials, greater at the lower frequencies than they were at the higher frequencies.
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 21 (1981), S. 1171-1172 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The viscosities of suspensions of glass fibers in an aqueous solution of sucrose have been studied by use of a capillary viscometer. In the aligned condition in the capillary, the viscosity depends little on shear rate within the range studied or on fiber length, but increases with increasing volume fraction of the fibers. The entrance effect was found to depend strongly on fiber volume fraction and fiber length: this indicates that the suspensions are relatively resistant to flow during the initial stages while alignment takes place.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...