Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Nephrotoxicity  (2)
  • acid site concentration  (2)
  • cloud point  (2)
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    Archives of toxicology 65 (1991), S. 537-541 
    ISSN: 1432-0738
    Keywords: Sodium dichromate ; Nephrotoxicity ; Hepatotoxicity ; Lipid peroxidation ; Phenobarbital
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine
    Notes: Abstract A comparison of the effects of intraperitoneal and subcutaneous routes of administration of sodium dichromate on nephrotoxicity in rats was studied. Dichromate when injected subcutaneously (SC group) produced a higher degree of nephrotoxicity than when administered intraperitoneally (IP group). It caused severe progressive proteinuria followed by polyuria and glucosuria, reaching maximum levels at 3 days after treatment in the SC group, whereas it produced mild proteinuria without glucosuria in the IP group. The dose-dependent increases in blood urea nitrogen (BUN) and creatinine concentrations, shown in the SC group, were not observed in the IP group. However, between the two groups, there were no great differences in either the urinary excretion rate of chromium or the electrophoretic patterns of urinary protein in the day 1 urine specimens. Pretreatment of phenobarbital (PB) had no remarkable effect on the dichromate-induced nephrotoxicity. In contrast, it potentiated dichromate-induced hepatotoxicity, the indices of which were the elevation in serum alanine aminotransferase (ALT) activity and hepatic lipid peroxide formation. These results suggest that the dependence of dichromate-induced nephrotoxicity on the route of administration is related to the chemical forms of chromium reaching the kidney, and the necrotizing property of dichromate results from its metabolic fate in vivo.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Springer
    Archives of toxicology 66 (1992), S. 646-651 
    ISSN: 1432-0738
    Keywords: Sodium dichromate ; Nephrotoxicity ; Glutathione ; Ascorbate ; Carbohydrate metabolism
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine
    Notes: Abstract Ascorbate treatment 30 min prior to sodium dichromate (20 or 30 mg/kg, s.c.) shows higher potency than that of glutathione (GSH) in protecting against both the metabolic disturbance and nephrotoxicity induced by dichromate. However, ascorbate treatment after 2 h of dichromate intoxication had no effect on dichromate-induced blood urea nitrogen (BUN) elevation 3 days after intoxication. In contrast, dichromate-induced glucosuria, which reached maximum levels at 3 days after treatment, was significantly decreased by GSH or N-acetyl cysteine (NAC) treatment, even if its administration was after 24 h of dichromate intoxication. Pretreatment with GSH depletors such as diethyl maleate (DEM) and buthionine sulfoximine (BSO) had no effect on dichromate-induced nephrotoxicity. GSH levels in the liver and kidney were not affected at 3 h after dichromate treatment. However, dichromate significantly increased tissue GSH levels with a marked increase in liver per kidney GSH ratio at 24 h after treatment, if food was withheld subsequent to dichromate treatment, indicating that GSH biosynthesis resulted from the accelerated protein breakdown. These results suggest that GSH-mediated dichromate reduction is not a kinetically favorable pathway in vivo; however, GSH plays an important role in protection against dichromate-induced nephrotoxicity. In addition, the cellular metabolism of dichromate in the early period after treatment is important in the pathogenesis of its nephrotoxicity.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1573-904X
    Keywords: nonionic surfactants ; cloud point ; cloud point boosters ; poloxamers ; poloxamines ; liquid formulation
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Purpose. To determine the cloud point of a variety of nonionic surfactants and to search for means to raise the surfactant cloud point in liquid formulations. Methods. Cloud points of nonionic surfactants were determined visually in a water bath. Organic compounds, many of which have been used as pharmaceutical excipients, were tested initially for effect on the cloud point of poloxamine 908. Four effective cloud point boosters (CPBs) from different structural classes were further tested on additional surfactants. Results. A number of compounds can raise the cloud point of nonionic surfactants. These cloud point boosters are classified into two categories: nonionic and ionic. The nonionic CPBs include poly(ethylene glycols), propylene glycol, methanol, ethanol, isopropanol, and 2-hydroxypropyl-β-cyclodextrin. They are effective at molar concentrations. The ionic CPBs include anionic and cationic surfactants, charged phospholipids, long chain fatty acids, and bile salts. They are effective at millimolar concentrations. Conclusions. The cloud point of nonionic surfactants used in liquid formulations can be modulated through the proper choice of excipient.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 1573-904X
    Keywords: nanocrystals ; submicron crystals ; suspensions ; steam sterilization ; physical stability ; surfactants ; cloud point ; ethyl diatrizoate
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Purpose. To study the effects of formulation variables on the physical stability of a submicron crystal (nanocrystal) suspension under steam sterilization conditions. Methods. Suspensions of ethyl diatrizoate nanocrystals were prepared by wet milling in the presence of the surfactant poloxamine 908. Particle size distribution and zeta potential were measured by photon correlation spectroscopy. Results. On heating, the mean particle size of the nanocrystal suspension remained essentially unchanged up to 110°C, the cloud point of the stabilizing surfactant, but increased significantly above that temperature. The increase in particle size was a result of particle aggregation rather than crystal growth. Adding a cloud point booster to the suspension significantly minimized the particle aggregation at high temperatures. The purity of poloxamine 908 and the tonicity agent and buffer salt used also affected the heat stability of the suspension, the latter agents apparently through altering the surfactant cloud point. Conclusions. The aggregation of the ethyl diatrizoate nanocrystalline suspension under steam sterilization conditions was a result of phase separation of the stabilizing surfactant at its cloud point. When formulated with a cloud point booster to prevent the phase-separation, the suspension maintained its physical stability under steam sterilization without any significant change in particle size distribution.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Catalysis letters 57 (1999), S. 209-215 
    ISSN: 1572-879X
    Keywords: 1-butene ; skeletal isomerization ; mesoporous material ; acid site concentration ; monomolecular reaction
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract On the skeletal isomerization of 1-butene, mesoporous materials with mesopores too large to expect any shape selectivity have been used in order to investigate the effects of the concentration of acid sites on the conversion of 1-butene and the selectivity for isobutene. The concentrations of acid sites can be varied through the control of the Si/Al ratio. The conversion of 1-butene increases with increasing the aluminium content of mesoporous materials, while the selectivity for isobutene decreases. The results of ammonia TPD, IR measurement of 1-butene adsorption, and TG analysis of used catalysts indicate that distant location of activated 1-butene molecules induces the monomolecular reaction over the mesoporous materials with low aluminium content, resulting in high selectivity for skeletal isomerization. On the mesoporous material with high aluminium content, however, the high concentration of activated 1-butene molecules accelerates the multimolecular oligomerization and, thus, reduces the selectivity.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    ISSN: 1572-879X
    Keywords: 1-butene ; skeletal isomerization ; fluorine-modified alumina ; acid site concentration ; monomolecular reaction
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract γ-alumina catalysts modified with different weight loadings of fluorine have been used for skeletal isomerization of 1-butene in order to investigate the effects of the fluorine loading level on the conversion of 1-butene and the selectivity to isobutene formation. Increasing the actual loading of fluorine up to 0.012 wt% led to an increase in conversion of 1-butene over fluorine-modified γ-alumina catalysts, while the high selectivity to isobutene remains almost unchanged. On the other hand, a clear trend of increasing 1-butene conversion with a decreasing selectivity to isobutene is observed for the γ-alumina catalysts with higher loadings of fluorine. An analysis of the results from the thermal analysis, NH3 temperature-programmed desorption, infrared and the 1-butene sorption measurments clearly indicates that the number of strong acid sites in the modified γ-alumina catalysts is greatly enhanced at fluorine loadings higher than 0.012 wt%, leading to the acceleration of 1-butene oligomerization followed by cracking to light hydrocarbons. Therefore, the 1-butene isomerization selectivity from fluorine-modified γ-alumina catalysts can be understood in terms of a competition between the monomolecular and bimolecular reaction pathways, which highly depend on the concentration of strong acid sites.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...