Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Letters Edition 14 (1976), S. 653-659 
    ISSN: 0360-6384
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Letters Edition 15 (1977), S. 671-674 
    ISSN: 0360-6384
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Chemistry Edition 14 (1976), S. 37-44 
    ISSN: 0360-6376
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Styrene was polymerized in emulsion with initiation by γ-rays at a dose rate of 0.6 Mrad/hr. Polymerization rates were as expected from previous reports by others. No branching or crosslinking was detectable, and the Mw/Mn ratio of the polystyrene did not change significantly during the course of the polymerization reaction. The molecular weight of the product polymer decreased with increasing conversion, in contrast to the behavior of chemically initiated emulsion polymerizations. Monomer-free polystyrene does not degrade under the same radiation conditions, and the progressive decrease of polymer molecular weight with conversion is shown to result from the presence of monomer.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 20 (1976), S. 1467-1473 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: A simple, inexpensive glass viscometer can be constructed to time the rate at which a rod falls into a liquid held in a concentric closed-end glass cylinder. This equipment can be used to measure absolute values of apparent viscosities of Newtonian and non-Newtonian fluids. Calibration is not required. The technique is an adaptation of a method used previously with polymer melts at elevated temperatures. The present article describes the modifications needed for lower-viscosity fluids, such as paints, and validates the flow analysis with results of study of a characterized Newtonian fluid.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Die Makromolekulare Chemie 100 (1967), S. 91-99 
    ISSN: 0025-116X
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Description / Table of Contents: Neue Dicarbonsäuren, die ein oder zwei 1,3,4-Oxadiazol-Ringe im Molekül enthalten, wurden durch Reaktion zwischen Orthoestern und Säurehydraziden gebildet. Diese Dicarbonsäuren haben die folgenden Strukturen: und R = Phenylen oder Alkylen und n = 1-4Die Polyamide von p-Xylylendiamin mit diesen Dicarbonsäuren wurden ebenfalls hergestellt. Diese Polymeren sind unlöslich in m-Kresol, aber löslich in konz. Schwefelsäure. Die Schmelzpunkte dieser Polyamide liegen über 350deg;C. Mit aliphatischen Polyamiden wurden Copolyamide mit hohen Molgewichten erhalten.
    Notes: Novel dicarboxylic acids containing one or two 1,3,4-oxadiazole rings in a molecule were synthesized by the reaction between orthoesters and acid hydrazides These dicarboxylic acids have the following structures: and where R represents a phenylene or an alkylene group and n = 1-4.The polyamides from p-xylylenediamine with these dicarboxylic acids were also prepared. The polymers are generally insoluble in m-cresol but soluble in conc. sulfuric acid. The melting points were estimated at above 350°C. Copolyamides of high molecular weights with aliphatic polyamides were obtained.
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Biopolymers 20 (1981), S. 1921-1927 
    ISSN: 0006-3525
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: The Dnp-pNA derivatives of more than 30 tetrapeptides were synthesized and subjected to CD measurements in MeOH. The CD spectra were analyzed on the basis of exciton chirality theory and were found to be useful for estimating β-turn preference of the parent tetrapeptides based on the following facts: (1) when a compound of the series takes the βturn conformation, a pair of strong CD bands with opposite sign are observed at 305 and 350 nm, and (2) when it is in a random or nonfolded conformation, no significant bands are observed at the wavelengths. The intensity of the 350-nm band reflects especially well the βturn preference. The CD spectra can be classified into two groups according to the sign of the band at 350 nm, and the groups seem to correspond to the type of βturn. By summarizing the results obtained, some generalizations concerning the sequence-conformation relationship are proposed.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    Journal of Biomedical Materials Research 37 (1997), S. 100-107 
    ISSN: 0021-9304
    Keywords: Diopside ; biocompatibility ; osteogenic cell (MC3T3-E1) ; biomechanical strength ; apatite wollastonite-containing glass-ceramic (AWGC) ; Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Medicine , Technology
    Notes: Diopside was prepared by sintering a powder compact composed of CaMgSi2O6 at 1573K for 2 h. In order to clarify the biocompatibility of Diopside, the cytotoxicity of Diopside against the osteogenic cell line MC3T3-E1 and the bone-Diopside interface strength were examined. On both the 14th and 21st days of incubation of MC3T3-E1 cells with Diopside, ALP activities were not significantly lower than those of the CTRL. TEM photographs of MC3T3-E1 on Diopside after 14 days of incubation showed active secretion of crystals from osteoblast-like cells. Scanning electron microscopic analysis showed that the cells on Diopside formed multiple cell layers similar to those on the CTRL both 14 and 21 days after incubation. These results showed that Diopside had no cytotoxic effect on MC3T3-E1. The pulling test showed that failure loads of Diopside were significantly lower than those of AWGC. Histologically, there was no fibrous tissue or foreign body reaction at the bone interface. SEM-EPMA showed that Diopside had attached to the bone via a calcium-phosphorus layer. SEM back-scattered electron imaging showed that the Diopside plate had degraded to a porous state 12 weeks after implantation. These findings indicate that Diopside is a biodegradable ceramic. © 1997 John Wiley & Sons, Inc. J Biomed Mater Res, 37, 100-107, 1997.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...