Bibliothek

feed icon rss

Ihre E-Mail wurde erfolgreich gesendet. Bitte prüfen Sie Ihren Maileingang.

Leider ist ein Fehler beim E-Mail-Versand aufgetreten. Bitte versuchen Sie es erneut.

Vorgang fortführen?

Exportieren
  • 1
    Digitale Medien
    Digitale Medien
    Springer
    Oxidation of metals 28 (1987), S. 329-345 
    ISSN: 1573-4889
    Schlagwort(e): Nickel-silicon alloys ; silica ; adhesion ; spallation ; ion implantation ; healing layer
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract An investigation of the oxidation of nickel-silicon alloys has been carried out in order to ascertain the mode of development of partially or fully protective SiO2 layers. The addition of 1% Si has little effect on the oxidation rate of nickel at 1000°C but is sufficient for partial-healing layers of amorphous SiO2 to be established. These layers are incorporated into the inner part of the duplex NiO scale but do not react with the oxide to form a double oxide. Increasing the silicon concentration to 4% or 7% facilitates the development of apparently continuous amorphous SiO2 layers at the base of the NiO scale, resulting in reduced rates of oxidation. However, these layers develop imperfections, possibly microcracks resulting from oxide growth stresses, and are unable to prevent some continued transport of Ni2+ ions into the NiO scale and oxygen into the alloy, particularly for Ni-4% Si. Although the formation of SiO2-healing layers can reduce the rate of oxidation of nickel, they provide planes of weakness that result in considerable damage under the differential thermal contraction stresses during cooling. In particular, severe scale spalling occurs for Ni-4% Si and Ni-7% Si as failure occurs coherently within the SiO2 layer.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 2
    Digitale Medien
    Digitale Medien
    Springer
    Oxidation of metals 18 (1982), S. 295-314 
    ISSN: 1573-4889
    Schlagwort(e): Nickel-manganese alloys ; oxidation ; solid solution scales ; internal oxidation
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract Ni-Mn alloys containing up to 38% Mn have been oxidized in pure oxygen between 873 and 1273 K and the parabolic rate constants measured. The scale morphologies and oxide compositions are interpreted in terms of modifications to the scale on pure Mn caused by the presence of Ni. The scales are composed predominantly of two layers at all temperatures, giving the sequences of phases alloy/cubic monoxide (Ni, Mn)O/ternary spinel, with the cubic (Ni, Mn)O layer always having the greater thickness. There is limited evidence for a third, very thin, outer layer in the scales on all alloys at 873 K and for Ni-38%Mn at 1073 K, which is tentatively considered to be Mn2O3, giving layers in the order alloy/cubic monoxide/ternary spinel/Mn2O3, by analogy with the scale formed on pure Mn. The distribution of the alloy components in the scale is discussed in relation to the Ni-Mn-O phase diagram and in terms of recent theoretical treatments of solid solution scale formation on binary alloys, as far as the available diffusion data allow. The occurrence of internal and intergranular oxidation and the formation of a Mn-depleted zone coincident with the band of uniform internal oxide are considered briefly.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 3
    ISSN: 1573-4889
    Schlagwort(e): Intergranular oxidation ; nickel-aluminum alloys ; internal oxidation
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract The development of intergranular oxides in dilute Ni-Al alloys containing 0.55–4.10% Al in Ni-NiO packs and in 1 atm oxygen at 800–1100°C has been examined. In the Ni-NiO packs, preferential intergranular oxide penetration as well as internal oxidation occurs in every case, except in the higher aluminum-containing alloys at 1100°C. Several different types of intergranular oxide morphology were observed, depending on alloy aluminum concentration and on temperature. The oxides in the more dilute alloys are thin and relatively continuous and are accompanied by preferential penetration of internal oxide particles in the adjacent grains. Thicker intergranular oxides are precipitated in the more concentrated alloys while, in some situations, numerous fine oxide particles are formed well ahead of the main intergranular oxide. The intergranular oxidation is facilitated by high stress development in the specimens due to increases in volume as internal and intergranular oxides are formed. These stresses create microvoids in the grain boundaries immediately ahead of the advancing internal and intergranular oxides, resulting in preferential nucleation and growth of further intergranular oxides. This is the case particularly at the lower temperatures where other stress-relief processes cannot operate. The resulting relatively continuous, incoherent intergranular oxide-metal interface allows a high flux of oxygen to the advancing intergranular oxide front. Preferential intergranular oxidation is much less extensive in the presence of a thickening external NiO scale, due to accommodation of the volume increases on internal oxide formation by vacancies injected into the alloy from the growing cationdeficient scale.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 4
    Digitale Medien
    Digitale Medien
    Springer
    Oxidation of metals 10 (1976), S. 341-345 
    ISSN: 1573-4889
    Schlagwort(e): α-Al2O3 ; platinum ; oxidation ; adhesion
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract The influence of externally located platinum on the isothermal stability of α-Al2O3 scales formed at high temperatures has been examined. It has been observed that a nickel-base alloy forms an external scale of α-Al2O3 during oxidation at 1200°C, but this scale breaks down isothermally, enabling a faster-growing Cr2O3-rich scale to develop. However, in the presence of platinum metal alongside the specimen in the furnace hot zone, the breakdown of the α-Al2O3 scale is postponed for a substantial period of time. It appears that platinum, as the volatile species PtO2, is incorporated into the growing α-Al2O3 scale where it either influences the stress relief mechanism at temperature or reduces oxidation growth stress generation and thus significantly enhances the isothermal stability of the scale.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 5
    Digitale Medien
    Digitale Medien
    Springer
    Oxidation of metals 23 (1985), S. 77-106 
    ISSN: 1573-4889
    Schlagwort(e): cobalt-chromium ; oxidation ; internal oxidation ; annealing
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract The influence of an initial preinternal oxidation treatment in Co/CoO on the subsequent oxidation behavior of a series of dilute Co-Cr alloys (containing 0–1.5 wt. % Cr) in 105 and 103 Pa oxygen at 1473–1623 Khas been investigated. Particular emphasis has been placed on determining the solubility and mobility of Cr3+ ions in CoO. Use has been made of subsequent annealing in argon $$(p_{O_2 } - 10^{ - 1} {\text{ }}Pa)$$ .
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
Schließen ⊗
Diese Webseite nutzt Cookies und das Analyse-Tool Matomo. Weitere Informationen finden Sie hier...