ISSN:
1572-9567
Keywords:
flash method
;
melts
;
radiation correction
;
slags
;
three-layer analysis
;
thermal conductivity
;
thermal diffusivity
Source:
Springer Online Journal Archives 1860-2000
Topics:
Physics
Notes:
Abstract A high-temperature measuring system has been developed to undertake measurements of thennal difusivity and specific heat up to 1900 K. The overall design allows measurements on solids to be undertaken using the accepted standard techniques and analytical procedures. The specific design for molten materials and especially slags is based on the differential threelayer technique utilizing a special cell which can be accomodated in the system. In this method, the liquid specimen is sandwiched between an upper inner platinum crucible and a lower outer platinum crucible, to provide a three-layered sandwich. A laser pulse irradiates the surface of the upper platinum crucible and the temperature response of the surface of the lower platinum crucible is observed. For the purpose of accurate measurement of specimen thickness at the measuring temperature, two runs are performed in which the thicknesses arel andl+°Dl, wherel is unknown butΔl can be set accurately with a built-in micrometer. The thermal difusivity is obtained through a curve-fitting method by a personal computer using a three-layer analysis with a correction for the radiative component based on the transparent body assumption. Following verification of the basic performance, using solids of known properties and water and ethanol, a continuous casting mixture has been evaluated. The initial results on the fluids are in good agreement with those in the literature.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF01448227
Permalink
