Conclusions
Castings having a thickness up to 65 mm and an apparent density slightly higher than that of similar specimens slip-cast in plaster of Paris molds were formed by the electrophoretic method from high-concentration suspensions of quartz glass.
At a thickness of 30 mm the maximum length of the sheets cast by this method was 1000 mm.
The rate of electrophoretic forming is considerably higher than that of slip casting in plaster of Paris molds.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature cited
A. S. Berkman, in: Trans. Ceramics Institute [in Russian], No. 20, GIKI, Leningrad (1948), pp. 6–12.
I. S. Kainarskii and K. B. Malinovskii, in: Trans. Khar'kov Polytechnical Institute. Series Chemical Technology [in Russian], Vol. 8, No. 3 (1956), pp. 181–189; Vol. 31, No. 1, KhPI, Khar'kov (1959), pp. 59–69.
I. S. Kainarskii and K. B. Malinovskii, Steklo i Keram., No. 4, 26–30 (1958).
J. M. Andrews, A. H. Collins, and D. C. Cornish, Proceed. British Ceram. Soc., No. 12, 211–229 (1969).
M. Aveline, L'Industrie Ceram., No. 581, 19–31 (1966).
I. S. Kainarskii, A. G. Karaulov, and G. E. Gnatyuk, Ogneupory, No. 6, 50–54 (1966).
Yu. E. Pivinskii, Ogneupory, No. 7, 49–57 (1971).
Yu. E. Pivinskii, Steklo i Keram., No. 9, 30–33 (1969).
Yu. E. Pivinskii, Steklo i Keram., No. 1, 28–32 (1971).
Additional information
Translated from Ogneupory, No. 10, pp. 56–59, October, 1973.
Rights and permissions
About this article
Cite this article
Solomin, N.V., Tsarev, V.F. & Pivinskii, Y.E. Electrophoretic forming of products from aqueous suspensions of quartz glass. Refractories 14, 655–658 (1973). https://doi.org/10.1007/BF01285684
Issue Date:
DOI: https://doi.org/10.1007/BF01285684