ISSN:
0360-6376
Keywords:
Physics
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
Notes:
Experimental conditions have been defined for the steady-state combustion of vertically positioned polymer rods burning at the top surface. Temperature and composition profiles through solid and gas phases of the system, polymer consumption rate, and flame height were measured, and the response of these parameters to changes of the oxygen concentration in the environment were determined. Measurements showed that unreacted oxygen diffused from the environment to the burning surface and was absorbed into the polymer, forming a well defined oxygen-rich layer. Concentration of chemically bound oxygen at the surface of this layer were high, e.g., with polypropylene ca. 26 wt-%, and identical with the stoichiometry of the gases leaving the surface and serving as fuel for the flame. The composition of the gas phase at the surface indicated the conversion of 11.4% of the hydrocarbon fuel to CO, CO2, and H2O. An energy balance for the system confirmed that fuel production in this surface layer takes place via simultaneous oxidative and pyrolytic degradation of the polymer, with exothermic processes supplying the energy for endothermic processes. Conductive and radiative contributions from the gas phase were found to play a minor role in maintaining fuel formation. The rate of degradation of a polymer to fuel, normalized to the area of the burning surface, was found to be independent of polymer supply rate and to increase with the oxygen concentration in the environment. The degradation process was successfully modeled in TGA experiments at temperatures and oxygen concentrations representative of the burning surface. The existence of an oxidative surface layer was confirmed and the TGA degradation rate related to the surface-to-volume ratio of the polymer sample. Compositional analysis of a methane diffusion flame of a geometry identical to that of the polymer flame, revealed the presence of unreacted oxygen throughout the preheating zone and at the surface of the burner. Conversion of fuel to final combustion products at the surface was 6.3%. Temperature and composition changes as a function of oxygen concentration in the environment were determined and compared with the polymer diffusion flame. It was concluded that a polymer flame, because of its autogenerative fuel production, possesses only one degree of freedom, viz., the oxygen concentration in the environment, in contrast to the conventionally fueled diffusion flame for which fuel supply rate is an additional independent parameter. Due to this single degree of freedom, the sensitivity of the polymer flame to environmental influences is increased. Effects caused by these extrinsic factors will be the subject of a separate report.
Additional Material:
20 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/pol.1975.170130305
Permalink