Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Electronic Resource  (3)
  • 2000-2004  (1)
  • 1985-1989  (2)
  • 1
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Publishing Ltd
    Plant, cell & environment 8 (1985), S. 0 
    ISSN: 1365-3040
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Biology
    Notes: Abstract. Vegetative plants of soybean [Glycine max (L.) Merr. cv. Wells II] grown in a greenhouse and agitated periodically on a gyratory shaker had shorter stems, less leaf area, and lower leaf and plant dry weight than did undisturbed greenhouse-grown (GG) plants after 16 d of treatment. Outdoor-grown (OG) plants, which were subjected to additional environmental stresses including ultraviolet radiation, wind loading, and uncontrolled temperature and humidity fluctuations, were smaller and had less dry weight than GG controls, but growth was not inhibited further by gyratory shaking. Periodic shaking of GG soybeans resulted in the same plant and leaf dry weight as for OG soybeans. Response of GG plants to mechanical stress depended on light intensity, with minimum growth reduction occurring under full light (FL) level, and maximum growth reduction occurring under lower light levels (24–45% FL). Reduction in dry weight gain due to mechanical stress corresponded to a decrease in relative growth rate (RGR). Decreases in net assimilation rate and leaf area ratio contributed equally to the lower RGR of shaken plants, indicating that seismic stress inhibits dry weight accumulation by decreasing both the photosynthetic efficiency and the assimilatory surface of soybean.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Oxford UK : Blackwell Science Ltd
    Journal of oral rehabilitation 28 (2001), S. 0 
    ISSN: 1365-2842
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Medicine
    Notes: The aim of dental adhesive restorations is to produce a long lasting union between the restoration and the tooth structure. This bond depends on many variables including the geometry of the preparation and the type of bonding agent or luting cement. It is therefore suggested that the topography of the tooth surface may influence the wettability and the bonding quality of adhesive systems. This study measured the surface roughness and wettability of enamel and dentine after preparation with different dental burs. The mesial and distal surfaces of 15 extracted sound human premolar teeth were prepared with a tungsten carbide crown bur, a diamond bur and a tungsten carbide finishing bur and finished in enamel or dentin, respectively. The prepared surfaces were analysed with a surface profilometer and scanning electron microscopy (SEM). The contact angle of distilled water on each of the prepared surfaces was used as the measure of wettability. The differences in average surface roughness (Ra) were significant between the rotary instrument groups, as revealed by a two-way ANOVA test. No differences were detected between enamel and dentine surfaces prepared with the same type of dental bur. The smoothest surfaces were those completed with tungsten carbide finishing burs. The diamond bur preparations were intermediate in the roughness assessment and the tungsten carbide crown burs gave the roughest surfaces. There were no significant differences in the contact angle measurements for the various groups. It was concluded that the surface roughness of enamel and dentine prepared by different rotary instruments had no significant influence on the wettabilty of distilled water on these surfaces.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1612-1112
    Keywords: Gas chromatography-mass spectrometry ; Coal liquefaction products ; Nitrogen bases ; Selective derivatisation ; Quantitative analysis
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Summary The estimation of primary aromatic amines (PAA) and other basic nitrogen compounds in coal liquefaction products is described. Aqueous acid extraction was used to isolate basic nitrogen fractions which were analyzed by gas chromatography (GC) and mass spectrometry (MS). Selective chemical derivatization in conjunction with single-ion GC-MS was used to distinguish between the PAA and the isomeric aza heterocycles. The relative merits of the proprietary methylating reagent ‘Methyl-8’ (dimethylformamide dimethylacetal) and a more conventional fluoroacylating reagent for the selective derivatization of PAA are evaluated. Quantitative aspects of the analyses are discussed.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...