ISSN:
1573-4862
Schlagwort(e):
residual stress
;
x-ray diffraction
;
stainless steel
;
fatigue
;
martensite
Quelle:
Springer Online Journal Archives 1860-2000
Thema:
Elektrotechnik, Elektronik, Nachrichtentechnik
,
Mathematik
Notizen:
Abstract The progress of fatigue damage in type 304L solution treated stainless steel was studied by surface residual stress measurements and measurements of the formation of martensite, as determined from x-ray diffraction techniques. The specimen was subjected to tension-tension (R=0.1) cycling in air at a maximum stress σmax=422 MPa, which was approximately 160% off the yield stress. The initial longitudinal residual stress distribution was determined for 13 locations along the gage length and found to vary around −80±17 MPa (compression). After several fatigue cycles, the residual stress changes to approximately +115±17 MPa (tension). At about 7% of the life (N/N f =0.07), the variation of the residual stress along the gage length reaches a minimum. With additional cycling, the residual stress first drops, reaching a minimum at approximately 10% of the life (100±8 MPa), then increases to a maximum at between 20 and 40% of the life (125±18MPa), followed by a marked relaxation to a minimum of 90±18 MPa at approximately 65% of the life. The surface martensite content of the sample continuously increases from its initial value of around 0.6%, first slowly up to 10% of the total fatigue life, and more rapidly thereafter to final failure. On the basis of additional measurements of the residual stress and martensite content as a function of depth below the surface, surface layer hardening of austenite and martensite is suggested as the principal reason for the residual stress development.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1007/BF00567093
Permalink
