ISSN:
0947-5117
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
Description / Table of Contents:
Influence of plastic deformation on the hydrogen diffusivity and solubility in austenitic Fe- and Ni-basic alloysThe measurements of diffusivity and solubility were performed on as received and up to 50% cold worked high alloyed austenitic materials Inconel 600, Inconel 690, Incoloy 800 and AISI 321 by means of an electrochemical permeation method and a hydrogen determination technique (LECO RH 402).With increasing nickel content of the materials the hydrogen diffusivity increases whereas the activation energy of diffusion and the hydrogen solubility decrease.A marked change of the diffusion behaviour is observed in the case of cold worked samples depending on the alloy composition. An increase of diffusivity by about two orders of magnitudes was measured for AISI 321 as a result of α-martensite transformation.The cold working of the other alloys results in a decrease of the diffusivity by a factor of 2.7 maximally and a higher hydrogen content after effusion of the solved hydrogen. This refers to a higher hydrogen trapping. It is assumed that hydrogen atoms are trapped at the cores of dislocations and at microcracks formed during charging.
Notes:
Es wird das Diffusions- und Löslichkeitsverhalten von Wasserstoff in den hochlegierten austenitischen Werkstoffen 2.4816, 2.4642, 1.4558, 1.4541 im unverformten und bis zu 50% kaltverformten Zustand mit einer elektrochemischen Permeationsmethode und Wasserstoffanalysenmeßtechnik (LECO RH 402) untersucht.Mit steigendem Nickelgehalt wird eine Zunahme der Diffusionskoeffizienten, eine Abnahme der Aktivierungsenergien und eine Abnahme der Löslichkeit beobachtet. Eine Kaltverformung der Werkstoffe führt in Abhängigkeit von der Zusammensetzung zu einem veränderten Diffusionsverhalten. Im Werkstoff 1.4541 kommt es infolge von Martensitbildung zu einer Erhöhung des Diffusionskoeffizienten um 2 Größenordnungen. Bei den anderen Werkstoffen führt die Kaltverformung zu einer Erniedrigung des Diffusionskoeffizienten max. um den Faktor 2,7 und zu höheren Restwasserstoffgehalten nach Effusion des gelösten Wasserstoffs. Als Ursache werden Trapvorgänge an Versetzungskernen und an den während der Beladung entstandenen Rissen angesehen.
Additional Material:
8 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/maco.19950460202
Permalink