Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Polymer and Materials Science  (10)
  • BHK-21/C13 cells in monolayer culture  (2)
  • Finite elements  (2)
  • 11
    ISSN: 0197-8462
    Keywords: millimeter-wave radiation ; BHK-21/C13 cells in monolayer culture ; quantitative autoradiography ; ribonucleic acid (RNA) synthesis ; protein synthesis ; Life and Medical Sciences ; Occupational Health and Environmental Toxicology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Physics
    Notes: A method has been devised whereby both the thermal and possible athermal biological effects resulting from microwave radiation can be assessed. Monolayer cultures of BHK-21/C13 cells were grown on microwave-transparent polystyrene coverslips, placed directly on the open end of a wave guide, and irradiated for 1 hour. In experiments seeking athermal biological effects of millimeter waves, culture medium was continuously recirculated over the cells to prevent temperature increases greater than 0.1 °C. Incorporation of 3H-uridine into RNA and of 3H-methionine into protein was quantified by measurement of optical densities of the autoradiographs in contiguous rectangular regions corresponding to portions of the cell monolayer immediately above the wave guide aperture and lying along its longer axis. Since power density was shown to vary with position along this axis according to a cosine2 relationship, it was possible to assess the extent of microwave effects on macromolecular synthesis at power densities ranging from zero at each edge to twice the average power density at the center of the waveguide.Monolayer cultures maintained at 37.2 °C by recirculation of the medium did not show microwave-induced changes in synthesis of RNA and protein (41.8 or 74.0 GHz at average power densities of 320 or 450 mW/cm2, respectively). Since macromolecular synthesis was examined both during and after irradiation, our results exclude both transient and persistent athermal biological effects of acute exposure to millimeter waves. In contrast, irradiation of cultures incubated in a small volume of nonrecirculated medium resulted in 1) marked heating of the monolayer, 2) a graded decline in macromolecular synthesis with increasing incident power, and 3), in some cases, destruction of the cell monolayer in the region immediately above the center of the waveguide aperture.
    Additional Material: 12 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 12
    Electronic Resource
    Electronic Resource
    Chichester : Wiley-Blackwell
    International Journal for Numerical Methods in Fluids 20 (1995), S. 169-185 
    ISSN: 0271-2091
    Keywords: Finite elements ; Multiblock ; Quadratic elements ; Equal-order ; Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: A new multiblock pressure-based finite element algorithm has been developed. This methodology implements quadratic interpolation for both the elemental velocity and pressure fields. A direct streamline upwinding scheme previously developedby the authors is used to model the non-linear inertia effects. Details of the algorithm and its multiblock foundation are provided along with validating test cases. The results presented clearly demonstrate the accuracy of this new approach and the differences in the pressure field for an element using quadratic versus the traditional bi linear approximation of the pressure field.
    Additional Material: 15 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 13
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Chemistry Edition 20 (1982), S. 241-244 
    ISSN: 0360-6376
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: A simplified approximation method for the treatment of dead-end and high conversion polymerization kinetics is presented. The method is based on the treatment of dead-end polymerization first described by Tobolsky. In appropriate circumstances, by contrast with Tobolsky's method, this method provides measurements of kd and kp/kt1/2 without recourse to the measurement of the monomer conversion at infinite time.Kinetic studies of free radical polymerizations are normally confined to measurements of initial rates. At low conversions the predictions of the general mechanism for chain-growth polymerization involving initiation, propagation, and termination steps are generally obeyed. Thus the polymerization rate should be first order in the vinyl monomer and half-order in the initiator concentrations.At high conversions, however, large deviations which can be ascribed to various effects can occur; for example, (1) the effect of the increasing viscosity of the polymerization medium on the termination rate constant kt, and possibly also on the propagation rate constant kp, which have been considered by North1 and Cardenas and O'Driscoll,2 or (2) depletion of the initiator as the polymerization progresses. This depletion will occur in all polymerizations but its significance will depend on the magnitude of the rate constant for initiator decomposition (kd) and the period of polymerization. Appropriate conditions will lead to limiting monomer conversion even after infinite polymerization time; this phenomenon has been called dead-end polymerization by Tobolsky.3Free radical polymerizations to high conversion are particularly important in the industrial context when initial kinetics are obviously inadequate. Suitable treatment of the conversion/time relationship is highly desirable.Senogles and Woolf4 have examined the polymerization of n-lauryl methacrylate at 60°C with 2-azobisisobutyronitrile as initiator under dead-end conditions.Here we propose a modification of Tobolsky's treatment of such polymerizations by using an approximation for the exponential decay in the initiator concentration. This method permits easy manipulation of the experimental data and the estimation of values for the kinetic parameters in favorable circumstances without recourse to the measurement of the conversion at infinite time or the evaluation of complicated functions of the monomer conversion. The method thus allows the duration of the laboratory experimentation to be significantly shortened and the complexity of the subsequent data analysis to be considerably reduced.
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 14
    Electronic Resource
    Electronic Resource
    Chichester : Wiley-Blackwell
    International Journal for Numerical Methods in Fluids 17 (1993), S. 463-475 
    ISSN: 0271-2091
    Keywords: Finite elements ; Streamline upwind ; Quadratic elements ; Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: A direct streamline upwind method has been developed for convection-dominated flow problems utilizing quadratic elements. The approach presented retains the curve-sidedness feature offered by these elements. This facilitates the use of boundary conforming elements in domains that possess extreme curvature such as turbomachinery bladed components, for which the method is particularly suited. Three test cases are solved to evaluate the stability and diffusive characteristics of the numerical solution. The results presented clearly demonstrate that the proposed method does not exhibit any non-physical spatial oscillations, nor does it suffer from the traditional problem of excessive numerical diffusion.
    Additional Material: 15 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...