Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 77 (1995), S. 1317-1319 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Specific contact resistances measured at elevated temperatures for Ni ohmic contacts to 6H-SiC were reported. The specific contact resistances were measured with the linear transmission line method at both room temperature and at 500 °C and yielded values 〈5×10−6 Ω cm2 at both temperatures. The trend shows a decreasing contact resistance at higher temperatures. The annealed metal film is a nickel silicide with substantial mixing of C throughout the silicide layer. © 1995 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 62 (1987), S. 875-878 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The epitaxial growth and characterization of the structural, morphological, interfacial, and electrical properties of lattice-matched Ca0.43Sr0.57F2 on GaAs(100) are reported here. The ∼200 nm films were grown at 500 °C on the GaAs(100) substrates that had been cleaned by annealing at 600 °C. Nomarski optical microscopy, transmission electron microscopy (TEM), scanning electron microscopy, and reflection high-energy electron diffraction results showed that the films were smooth and crackfree, with good crystalline quality. TEM showed evidence of two general types of extended defects in the film which occur at or near the film/substrate interface region. Film resistivity was found to be (3.6±0.75)×1013 Ω cm, and the breakdown field strength was (5.8±1.4)×105 V/cm. However, the breakdown in this case represented a nondestructive conduction process, as opposed to the catastrophic and irreversible change observed in previous studies. The dielectric constant of the films was measured to be 7.43±0.22. Capacitance-voltage measurements indicated that there could be a high density of surface states at the interface that pin the Fermi level within the gap region.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...