Bibliothek

feed icon rss

Ihre E-Mail wurde erfolgreich gesendet. Bitte prüfen Sie Ihren Maileingang.

Leider ist ein Fehler beim E-Mail-Versand aufgetreten. Bitte versuchen Sie es erneut.

Vorgang fortführen?

Exportieren
  • 1
    Digitale Medien
    Digitale Medien
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 73 (1993), S. 4332-4343 
    ISSN: 1089-7550
    Quelle: AIP Digital Archive
    Thema: Physik
    Notizen: Time-resolved reflectivity measurements have been used to investigate the morphology of an evolving amorphous-crystalline interface during solid phase epitaxial regrowth of an ion-implanted polycrystalline silicon film. Isothermal electron beam heating was used to produce partly regrown specimens for cross-sectional transmission electron microscopy analysis, and this has enabled a direct correlation to be established between the interface shape and the observed reflectivity transients. Using a thin-film optical model of an evolving rough interface, this correlation has enabled interface shapes to be inferred from the reflectivity at higher temperatures, where it is difficult to achieve partial regrowth. For undoped material, smaller grain sizes have been found to lead to rougher interfaces, with regrowth rates typically 20 times slower than for single crystal. At 620 °C, the presence of high concentrations of arsenic results in a smoother interface, but as the regrowth temperature is increased, the interface becomes rougher. The complex interplay between doping, temperature, and initial microstructure is investigated at temperatures up to 850 °C.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 2
    Digitale Medien
    Digitale Medien
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 59 (1991), S. 829-831 
    ISSN: 1077-3118
    Quelle: AIP Digital Archive
    Thema: Physik
    Notizen: A new mechanism of misfit dislocation nucleation is demonstrated. Deliberate contamination with approximately 0.003 monolayers of Cu and subsequent annealing at 600 °C is shown by transmission electron microscopy, photoluminescence, and defect etching to produce dislocation half loops in a 1.1 μm layer of Si0.93Ge0.07 on a silicon substrate.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 3
    Digitale Medien
    Digitale Medien
    Springer
    Journal of materials science 13 (1978), S. 657-665 
    ISSN: 1573-4803
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract Samples of gallium arsenide from liquid encapsulated Czochralski grown ingots, doped with either tellurium or selenium to carrier concentrations ∼ 1018 cm−3 revealed shallow pits (S-pits) by etching. Although the S-pits were randomly distributed throughout the matrix, areas of high densities were associated with dislocations. This observation was utilized to identify the types of defects which became S-pits when etched. Transmission electron microscope specimens of etched material were examined in the dislocation regions, and showed directly that faulted loops with Frank partials b=1/3a 0 〈111〉 containing precipitate particles could become S-pits. It was further deduced from the combined optical and electron microscope observations that both faulted {111} and unfaulted {110} dislocation loops became S-pits provided they contained precipitate partices.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 4
    Digitale Medien
    Digitale Medien
    Chichester [u.a.] : Wiley-Blackwell
    Surface and Interface Analysis 26 (1998), S. 461-470 
    ISSN: 0142-2421
    Schlagwort(e): W/TiN/Ti/Si contact structure ; MULSAM ; TEM ; Chemistry ; Polymer and Materials Science
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Physik
    Notizen: The W/TiN/Ti/Si contact structures needed for ultra-large-scale integrated circuits have been studied using cross-sectional transmission electron microscopy (TEM) and multi-spectral Auger electron microscopy. Access to the Ti/Si interface for chemical characterization using SEM, Auger and electron energy-loss imaging and spectroscopy has been achieved by using a novel method of bevelled polishing of the silicon substrate material. Cross-sectional TEM was used to calibrate the depth scale in the MULSAM image sets, so allowing measurements of the thicknesses of various interfacial layers and the penetration of the ohmic contacts into the silicon. The TiN layer, providing adhesion of the tungsten as well as acting as a diffusion barrier, appears to have a domed shape, which penetrates the tungsten overlayer to a greater extent in the contact centres. The results of this work, combined with earlier, related, studies, enable a three-dimensional characterization of the bottom and sidewall structures in these contacts. © 1998 John Wiley & Sons, Ltd.
    Zusätzliches Material: 8 Ill.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
Schließen ⊗
Diese Webseite nutzt Cookies und das Analyse-Tool Matomo. Weitere Informationen finden Sie hier...