Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: The detailed study of the performance of full scale x-ray optics often requires the illumination of large areas. This paper describes a beam expander facility at the Daresbury Synchrotron Radiation Facility. It combines monochromatization and beam expansion in one dimension. The beam expansion is obtained from an extremely asymmetric reflection in a large single crystal of Si. An expansion of a factor of 50 was obtained in one dimension. The expanded beam of ∼85 mm is limited only by the crystal size. The facility is installed in a 12-m-long hutch. A specific application, in which a high throughput x-ray telescope will be studied, is described in detail.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Copenhagen : International Union of Crystallography (IUCr)
    Applied crystallography online 21 (1988), S. 252-257 
    ISSN: 1600-5767
    Source: Crystallography Journals Online : IUCR Backfile Archive 1948-2001
    Topics: Geosciences , Physics
    Notes: High-resolution X-ray diffraction studies of the perfection of state-of-the-art multilayers are presented. Data were obtained using a triple-axis perfect-crystal X-ray diffractometer. Measurements reveal large-scale figure errors in the substrate. A high-resolution triple-axis set up is required, therefore, to obtain structural information about the layers. Measurements of reflectivity from parallel layers are presented as well as measurements of the angular distribution of the layer normal over the illuminated spot. These measurements are supplemented with measurements of scattering obtained in the total external reflection regime.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1572-9508
    Source: Springer Online Journal Archives 1860-2000
    Topics: Physics
    Notes: Abstract It is shown that compact designs of multifocus, conical approximations to highly nested Wolter I telescopes, as well as single reflection concentrators, employing realistic graded period W/Si or Ni/C multilayer coatings, allow one to obtain more than 1000 cm2 of on-axis effective area at 40 keV and up to 200 cm2 at 100 keV. The degree of concentration is defined by a focusing factor i.e., the effective area divided by the half power focal area. For the cases studied, this is 400 at 40 keV and 200 at 100 keV for a 2 arcmin imaging resolution. This result is quite insensitive to the specifics of the telescope configuration provided that mirrors can be coated to an inner radius of 3 cm. Specifically we find that a change of focal length from 5 to 12 m affects the effective area by less than 10%. In addition the result is insensitive to the thickness of the individual mirror shell provided that it is smaller than roughly 1 mm. The design can be realized with foils as thin (≤0.4 mm) as used for ASCA and SODART or with closed, slightly thicker (∼1.0 mm) mirror shells as used for JET-X and XMM. The effect of an increase of the inner radius is quantified on the effective area for multilayered mirrors up to 9 cm. The calculated Field of View (full width at half maximum), ranges from 9 arcmin at 1 keV to ≥5 arcmin at 60 keV. Finally, the continuum sensitivity of the design assuming a signal to noise ratio of 5 and a 10% energy bandwidth has been calculated. For a balloon flight observation of 104 sec. with a telescope having 2 arcmin imaging resolution the point source sensitivity is ∼3 · 10−6 photons/cm2/s/keV up to 70 keV for a W/Si coated telescope and up to ∼100 keV for a Ni/C coated telescope. For a satellite observation time of 105 sec and an imaging resolution of 1 arcmin the sensitivity is ∼10−7 photons/cm2/s/keV which demonstrates the great potential of this hard X-ray imaging telescope in the energy range up to 100 keV.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Springer
    Experimental astronomy 6 (1995), S. 129-142 
    ISSN: 1572-9508
    Keywords: hard x-rays ; x-ray telescopes ; all-sky surveys
    Source: Springer Online Journal Archives 1860-2000
    Topics: Physics
    Notes: Abstract We discuss a hard x-ray telescope for the range 25–70 keV based on a one-dimensional lobster-eye telescope and x-ray supermirror coatings. This approach enables wide field-of-view imaging. A telescope suitable for a large balloon payload, with a 50×100 cm frontal area, could have an effective area of 50–100 cm2 and a 100×100 field of view, and thereby detect AGN that are 0.5 milliCrab in the soft x-rays in a 104 second exposure. 29% of the sky could be surveyed to this limit in a 2-week balloon flight, reaching 6 times fainter than the HEAO A-4 all-sky survey.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...