Digitale Medien
Oxford, UK
:
Blackwell Publishing Ltd
Fatigue & fracture of engineering materials & structures
17 (1994), S. 0
ISSN:
1460-2695
Quelle:
Blackwell Publishing Journal Backfiles 1879-2005
Thema:
Maschinenbau
Notizen:
Abstract— The plastic deformation of thin-walled cylinders has been experimentally examined for the loading conditions of ±1% axial strain with hoop stresses of approximately 0, 1/4, 1/2 and 3/4 of the initial uniaxial yield stress.Two materials similar to those used in the pipework of PWR nuclear plant in the U.K. have been tested, namely 304S11 stainless steel and En6 low-carbon steel. The results of the tests were to be compared with the allowable stresses and deformations specified in the ASME Boiler and Pressure Vessel Code, Section III. The code specifies that a prescribed combination of primary stresses must not exceed 1.5Sm, where Sm is a stress value defined for each material.The results indicate that the limit of 1.5Sm is excessively low for both materials and that in particular, the stainless steel could tolerate 5Sm. Although the En6 steel is more prone to ratchetting than the stainless steel, the results suggest that it too could tolerate a higher primary stress than the code allows. Both materials are shown to satisfy the proposed ASME ratchet strain limit of 5% hoop strain after 10 cycles of ±1% axial strain range, for any value of internal pressure.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1111/j.1460-2695.1994.tb00248.x
Permalink
| Bibliothek |
Standort |
Signatur |
Band/Heft/Jahr |
Verfügbarkeit |
