Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Physics of Plasmas 6 (1999), S. 2791-2796 
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: In the present study recycling and transport in the edge plasma of Alcator C-Mod [I. H. Hutchinson et al., Phys. Plasmas 1, 1511 (1994)] is modeled and analyzed with the multi-fluid code UEDGE [T. D. Rognlien et al., J. Nucl. Mater. 196–198, 347 (1992)]. Matching the experimental plasma density profiles in the scrape-off layer (SOL) requires a spatially dependent effective anomalous diffusion coefficient D⊥ growing rapidly towards the wall. The midplane pressure of neutral gas, Pmid, is a key parameter that reflects the magnitude of anomalous transport of plasma from the core. Recycling of plasma on the main chamber wall appears to be quite significant, especially in the case of high Pmid∼0.3 mTorr when the main wall provides ∼70% of recycling neutrals in the main chamber. In the upper SOL (well above the x point) draining of particles by the poloidal flow is weak and thus the particle balance is predominantly radial. For the radial heat transport it is found that energy flux carried by radial plasma convection and by charge-exchange (CX) neutrals is quite significant in SOL. In the high Pmid case, heat conduction by CX neutrals along with radial heat convection by plasma carries most of the power flux (∼75%) across the last closed flux surface. Even in the low Pmid case, heat conduction by CX neutrals dominates the radial heat flux far out in the SOL. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Physics of Plasmas 5 (1998), S. 3373-3376 
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Particle balance is examined in a large set of representative Alcator C-Mod [I. H. Hutchinson et al., Phys. Plasmas 1, 1511 (1994)] diverted plasmas using measurements of neutral gas pressures and ionization source strengths in the main chamber, and parallel plasma flow into the divertor. It is inferred that plasma flow in the scrape-off layer (SOL) is dominated by transport to the main chamber walls rather than by flow into the divertor. It follows that (i) the effective diffusion coefficient for anomalous cross-field particle transport in the SOL must rapidly grow with distance from the magnetic separatrix to account for the measured density profiles, (ii) a significant fraction of the power from the core plasma can be convected rather than conducted into the SOL, and (iii) the neutral pressure at the outer midplane is governed more by cross-field plasma transport than by wall–plasma separation or divertor/limiter geometries. © 1998 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Physics of Plasmas 8 (2001), S. 4427-4434 
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The effect of flowing metal walls on the resistive wall instabilities is analyzed for a general cylindrically symmetric diffusive pinch configuration. Two types of liquid metal flow are analyzed: a uniform flow which is poloidally symmetric, and a two-stream flow consisting of two opposite streams splitting at the top and merging at the bottom. It is found in both configurations that when the liquid wall flow velocity exceeds a critical value, the resistive wall mode is stabilized. However, for the two-stream flow the critical velocity is several times smaller than that for the uniform flow. Still in a realistic experiment one needs a flow velocity of a few tens m/s to stabilize the resistive wall mode. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...