Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 70 (1999), S. 1700-1709 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A three-wave heterodyne O-mode reflectometer was developed and tested in experiments on the T-10 tokamak. Three launched waves are obtained by frequency splitting due to amplitude modulation with a p-i-n diode. Source frequencies from 36 to 78 GHz were used in the experiments. The ability of the reflectometer to measure simultaneously density profile characteristics, such as the time evolution of the relative phase and the unambiguous time delay of the reflected wave together with small-scale density fluctuation characteristics such as the radial and poloidal correlation lengths, was demonstrated with T-10 experimental data. The reflectometer can provide important information about fine changes in the density profile during sawteeth and low-m magnetohydrodynamics oscillations. Poloidal correlation measurements make it possible to measure transverse turbulence velocities and velocity shear. It was shown that both types of correlation measurements enable one to distinguish different types of turbulence according to the values of their correlation lengths, and that probing the plasma from several poloidal directions simultaneously greatly enhances the potential of reflectometry for the investigation of turbulence physics. In particular, it was found that different turbulence types may be either poloidally symmetrical or have much higher amplitude on the low field side of the discharge. Probing with several poloidal directions also enables one to make toroidal correlation measurements over long distances at certain resonant q values after one or two turns of magnetic field line around the major tokamak axis. In fact, correlations near 40% were observed experimentally. Such measurements may give additional information about turbulence characteristics on the one hand and allow radial q profile measurements on the other hand. In addition, the capabilities of reflectometry may be enhanced with the application of a proposed holography approach. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: Reflectometry will be used on ITER to measure the density profile in the main plasma and divertor regions, and to measure the plasma position and shape in order to provide a standby reference for the magnetic diagnostics in long pulse discharges. The high temperatures of the ITER core and the resultant significant relativistic downshift of the second-harmonic electron cyclotron absorption imply that both low-field side O-mode and high-field side lower cut-off (X−l mode) systems are required to access the full plasma profile. A low-field side upper cut-off (X−u mode) system will also be required for measurements of the scrape-off layer. For measurements of the plasma position and shape, an O-mode system is optimum due to the large range of magnetic field along the plasma periphery and the wide range of possible plasma configurations achievable on ITER. A robust real-time calibration technique of the whole transmission line is required. It is likely that an accurate estimate of the position of the plasma will require the simultaneous use of signals from the profile reflectometer. For the divertor, profiles with peak densities in the range 1019–1022/m3 are to be measured with a target resolution of 3 mm. The large density range will necessitate the use of more than one system. Installing these reflectometers on ITER incurs additional difficulties such as the routing of the millimetre wave radiation around the complicated first wall and divertor structures and design of antennas able to operate through the first wall and blanket. © 1997 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1562-6938
    Source: Springer Online Journal Archives 1860-2000
    Topics: Physics
    Notes: Abstract An improved confinement regime with an external transport barrier (H-mode) is obtained during electron-cyclotron resonance heating of a plasma in the T-10 tokamak. A characteristic feature of this regime is a spontaneous density growth accompanied by a drop in the intensity of Dα line and an increase in βp by a factor of ∼1.6. The threshold power for the L-H transition is close to that predicted by the ITER scaling. The best characteristics of the H-mode are achieved with decreasing q L to 2.2. It is shown that the external transport barrier arises for electrons, whereas the heat transport barrier insignificantly contributes to improved confinement.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...