Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Physics Edition 13 (1975), S. 799-813 
    ISSN: 0098-1273
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: A study has been carried out of the changes in the x-ray diffraction patterns which occur when oriented fibers or tapes of poly(trimethylene terephthalate) (3GT) and poly-(tetramethylene terephthalate) (4GT) are subjected to mechanical tensile stress. Although the polymers show very different behavior in detail, in both cases comparatively large reversible lattice strains are observed (∼ several %). The diffraction pattern of 3GT changes monotonically with increasing macroscopic strain, suggesting that the lattice responds immediately to the applied stress, and deforms as though it were a coiled spring. In 4GT, on the other hand, there is no detectable change in the x-ray diffraction pattern at low macroscopic strains, i.e., low values of the applied stress. At higher stresses, changes in the pattern occur which suggest a definite change in the crystal structure. Finally at the highest values of applied stress, the lattice deformations cease to increase. A preliminary discussion is presented of the relationship of these x-ray diffraction results to the mechanical stress-strain behavior.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Chemistry Edition 14 (1976), S. 1609-1616 
    ISSN: 0360-6376
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Because of the allylic nature of propylene, the vinyl chloride-propylene system exhibits polymerization behavior markedly different from that of vinyl chloride, even at relatively low propylene concentrations. Propylene acts as a degradative chain-transfer agent, and as a result, both the polymerization rate and the molecular weight of the resultant copolymers are lower than those of the homopolymer, decreasing with increasing propylene content. Even at propylene concentrations as low as 10% the rate of polymerization is proportional to the initiation rate, indicating kinetic control by the propylene. The reactivity ratios of these monomers given by Cain were verified. The reciprocal intrinsic viscosity of the copolymer was found to be linearly related to the monomer feed composition.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 0360-6376
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Plasma-polymerized oils, films and powders obtained from ethylene, acetylene, butadiene, and benzene were characterized by flash pyrolysis and gas chromatography (P/GC). None of the pyrograms resembled those of commercial polyethylene, polybutadiene, or polystyrene. Each of the plasma-polymer pyrograms did exhibit essentially the same fragments up to C8, albeit in a different distribution, indicating that all samples are structurally similar. Analysis of the P/GC data shows these materials to contain a random arrangement of side chains, crosslinks, double bonds, and aromatic structures. Changes in the fragment distribution were obvious when the sample was a powder, solid film, or oily film produced from the same monomer. It was shown that powder products generally have a higher concentration of branches and/or crosslinks than the oil or film products. There are also differences in the pyrograms of products of the same form derived from dissimilar monomers. The results obtained from P/GC generally support those derived from infrared or NMR measurements performed earlier.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Physics Edition 13 (1975), S. 1269-1274 
    ISSN: 0098-1273
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Earlier work showed that heating causes poly(diethylsiloxane) to undergo a first-order transition from a semicrystalline solid to a more mobile viscous - crystalline material. The latter is composed of two phases and analogies between polymer and liquid crystal morphology and behavior have been made. The viscous - crystalline phase in PDES appears to be unique since the literature is devoid of other documented examples. In this study, spin - lattice and spin - spin relaxation times were measured over a wide temperature range. They show a glass transition at 138°K, a crystal - crystal transition at 206°K, and a transition around 250°K which results from translational motion of the polymer chains with respect to each other. This motion is observed in the amorphous phase at a lower temperature than in the crystalline phase. Translational motion in the crystalline phase is observed on melting of the crystallites. The spin - spin data permitted monitoring of the molecular motions in each phase and the data suggest that these phases exert some influence on the molecular motions of each other. The viscous - crystalline phase in PDES may represent a unique model for studying and understanding “precrystalline” behavior and structure in amorphous solids.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Physics Edition 14 (1976), S. 1161-1167 
    ISSN: 0098-1273
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: A new crystalline form of isotactic poly(pentene-1) was obtained from dilute solution in amyl acetate. We have designated it as form III. The morphology and structure of isothermally crystallized samples were investigated by electron microscopy and electron and x-ray diffraction. This crystalline modification can be indexed on an orthorhombic unit cell (cell dimensions: a = 21.20 ± 0.05 Å, b = 11.48 ± 0.05 Å, c = 14.39 ± 0.05 Å (fiber axis) and probable space group P212121).
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Physics Edition 14 (1976), S. 1485-1493 
    ISSN: 0098-1273
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The universal calibration for gel permeation chromatography (GPC) has been applied to amylose and dextrans. The molecular weight distribution of amylose has been measured starting from known data on dextrans. The agreement found between the molecular weight averages resulting from GPC and those obtained by other methods justifies the procedure followed. The GPC measurements were performed with dimethylsulfoxide as the elution solvent and deactivated silica gel (Porasil) as the column-filling material.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Physics Edition 15 (1977), S. 1647-1654 
    ISSN: 0098-1273
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The infrared spectra of polyethylene single crystals suspended in liquid are reported and compared to dried mats of the same material. In order to observe the polyethylene bands, liquids with partial windows in complementary regions of the spectra were chosen. Any remaining bands of the suspending media were removed by substraction of the spectrum of the pure liquid. The crystalline bands of suspended polyethylene are much sharper than those of the dried material, indicating a decrease in lateral crystalline order upon drying. Drying also results in a change in the type and distribution of conformations associated with amorphous and fold structures, as determined by the observed frequencies of the methylene wagging mode.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Physics Edition 15 (1977), S. 333-353 
    ISSN: 0098-1273
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Deformation bands formed at the yield point in tensile tests on oriented high-density polyethylene have been studied by optical microscopy and wide-angle x-ray (WAXS) diffraction. The observations of the rotation of the optical extinction direction are shown to obey a simple scheme proposed previously by us: the principal directions of the refractive index ellipsoid within the deformation bands are everywhere parallel to the principal axes of the plastic strain ellipsoid, zero strain referring to the isotropic state. This result is similar to that obtained previously for polyethylene terephthalate (PET) and polypropylene despite the much higher crystallinity obtained with polyethylene. Independent measurements of the molecular reorientation in the deformation bands made using wide-angle x-ray scattering broadly confirm the optical measurements. The results taken together suggest that the material within the band, whether crystalline or not, becomes realigned about the new direction of maximum elongation as if controlled by the deformation of an effective molecular network.
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Physics Edition 15 (1977), S. 981-986 
    ISSN: 0098-1273
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Photoconductivity measurements were carried out on plasma polymerized styrene (PPS) in vacuo, in air, and in subsequently re-evacuated conditions. Samples with two gold electrodes (Au-PPS-Au) and gold-aluminum electrodes (Au-PPS-Al) were used. Positive short circuit photocurrents in the direction of illumination were observed in both types of specimens. In the case of Au-PPS-Au, photocurrent threshold was about 1.6 eV in vacuo for the virgin film, which is attributed to the energy of hole generation in bulk. Residual free radicals were assumed to be the acceptors in this mechanism. In the case of Au-PPS-Al, electron injection from aluminum was thought to be a more likely mechanism, with an estimated barrier height of approximately 2.6 eV.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Physics Edition 15 (1977), S. 1537-1556 
    ISSN: 0098-1273
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Investigations of the particle morphology of poly(vinyl chloride) produced under quiescent conditions during radiation-induced bulk polymerization over the temperature range -30 to 70°C were carried out. The observations were mainly confined to the early stages of polymerization. For polymerization temperatures below about 20°C, the systems remain predominantly homogeneous during the entire polymerization and the polymer particles increase in size linearly with conversion. At higher temperatures the polymer particles rapidly settle and become cemented together. The findings are discussed in the light of the kinetic data on vinyl chloride polymerization, and a process of particle formation and growth, resembling that recently proposed by Fitch for emulsion systems, was formulated. Primary particles are initially formed by the coiling up of single macromolecules or single macroradicals and, subsequently, they increase in size by sweeping up growing free radicals from the liquid monomer phase. The free radicals which escape capture give rise to new primary particles, but their number progressively decreases as the number of the dispersed particles increases. Simultaneously, the polymer particles undergo flocculation which in a short time results in the formation of large agglomerates. As the volume of the resulting agglomerates increases, the flocculation rate decreases and, eventually, becomes so low that the flocculation does not proceed further. At low temperatures the flocculation almost ceases when the agglomerates are still small enough for sedimentation to occur only very slowly. However, this is not the case at higher temperatures. The addition of substances such as alcohols, brings about a reduction in the flocculation rate and, hence, in the size of the agglomerates formed at the end of the flocculation process. In this way, one can also obtain at high temperatures agglomerates of small sizes which remain dispersed for a long time.
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...