Library

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Biopolymers 19 (1980), S. 1451-1474 
    ISSN: 0006-3525
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Internal Brownian motions of clean φ29 and λ-DNAs have been studied using photon-correlation techniques at both visible (λ0 = 632.8 nm) and uv (λ0 = 363.8 nm) wavelengths. The present dynamic light scattering data, which extend to K2 = 19 × 1010 cm-2, can in every case be satisfactorily simulated by a Rouse-Zimm model polymer with an appropriate choice of the three model parameters. The effects of pH, salt concentration, single-strand breaks, and molecular weight on those model parameters have also been investigated. Intact clean DNAs exhibit surprisingly little variation with pH from 7.85 to 10.25, with salt concentration from 0.01 NaCl to 5.4M NH4Cl, or with molecular weight or GC content. The single-strand breaks have no effect at pH 9.46, but produce dramatic changes in the model parameters at pH 10.0 and 10.25, indicating the introduction of titratable joints at those pHs. The failure of either single-strand breaks or a large change in GC content to alter the model parameters in the neutral pH range is a strong indication that local denaturation is not required for those flexions and torsions that dominate the relaxation of fluctuations in the scattered light. The Langevin relaxation time for the slowest internal mode of a particular Rouse-Zimm model derived from the dynamic light scattering data is compared with pertinent literature data extrapolated to the same molecular weight. The present algorithm for determining model parameters from the light-scattering Dapp vs K2 curve actually yields a Langevin time in fairly good agreement with the literature value. For unknown reasons the light-scattering D0 values generally exceed those obtained from the molecular weight and sedimentation coefficient by about 20%.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...