ISSN:
0006-3592
Keywords:
Chemistry
;
Biochemistry and Biotechnology
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Biology
,
Process Engineering, Biotechnology, Nutrition Technology
Notes:
It has been shown that the rate of enzymatic saccharification of cellulosic materials including “pure” cellulose (Whatman CF-11 cellulose), newsprint, lignocellulose (prehydrolyzed to remove hemicelluloses), and wood can be substantially increased by simultaneous wet milling. An enhanced hydrolysis rate was sustained above that observed for ball milling: providing a more extensive saccharification. The cellulosic substrates were wet milled with a variety of grinding elements, such as sand, glass beads, and stainless-steel beads, agitated in a shaker bath. Simultaneous hydrolysis was achieved with a 2% substrate slurry in a 0.1M acetate buffer at 45°C and pH 5. The effectiveness of this process was dependent upon the lignified matrix of the cellulose microfibrils, the grinding elements, and the oscillation frequency of the shaker bath. Wet milling “pure” cellulose for 48 hr, with 3.5 mm glass beads and 200 oscillations/min (opm), yielded 1031 mg reducing sugar/g substrates (93% saccharification) as compared to 483 mg (44%) for the ball-milled sample and 253 mg (23%) for the unmilled material. With the lignified substrates stainless-steel beads (3.5 mm) were more effective than glass. For lignocellulose 529 mg sugar/g substrate (93% saccharification) could be obtained by wet milling with cellulase for 24 hr. This was about three times greater than that of the ball milled (169 mg, 30%) and 10 times greater than that of the unmilled (52 mg, 9%) substrates. The method was also effective for wood particles (60 mesh) giving 143 mg sugar/g wood (approximately 38% saccharification) in 48 hr, whereas the ball-milled sample gave only 79 mg (21%) and the unmlilled substrate 38 mg (10%). These observations can be explained on the basis of the current crystalline theory for the morphology of the cellulosic microfibrils. The advantage of wet milling and simultaneous hydrolysis apparently depends on a continuous generation of accessible sites and sustained rapid hydrolysis rate as the saccharification proceeds, where in the pretreated substrates the hydrolysis rate slow down as the active sites are reduced.
Additional Material:
5 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/bit.260220511
