ISSN:
1089-7666
Source:
AIP Digital Archive
Topics:
Physics
Notes:
The occurrence of reverse flow in a channel when a bluff body is kept at the entry is already known. In the earlier investigations, attention was focused on the generation of the reverse flow with bluff bodies, such as flat plate and other geometries, having the same width as the channel. The separation of the shear layers from the obstruction at the front end and the interaction of the shear layers at the rear end are mainly responsible for the reverse flow. To gain further insight into the phenomenon, the effects of the width of the obstruction at the front and that of placing another at the rear end in tandem with the front one are examined in this study. It is observed that the reverse flow occurs even when the width of the flat plate (b) is less than the channel width (w); the lower limit being b/w=0.6. At this b/w the reverse flow velocity is small, but it increases progressively with b/w until a maximum of about 30% of the forward velocity is attained for b/w≥2.0. However, reverse flow as high as 0.6 times the free-stream velocity is obtained when another plate is kept close to the rear end in addition to the front plate. Further increase in the reverse flow to 0.83 times the free-stream velocity has been achieved by replacing the flat plate model at the rear with a semicircular scoop. © 1994 American Institute of Physics.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1063/1.868376
