ISSN:
1089-7623
Source:
AIP Digital Archive
Topics:
Physics
,
Electrical Engineering, Measurement and Control Technology
Notes:
The DIII–D Thomson scattering system has been expanded to measure divertor plasma temperatures from 1 to 500 eV and densities from 0.05 to 8×1020 m−3. To complete this system, a difficult stray light problem was overcome to allow for an accurate Rayleigh scattering density calibration. The initial stray light levels were over 500 times higher than the expected Rayleigh scattered signal. Using a charge-coupled device (CCD) camera, various portions of the vessel interior were examined while the laser was fired through the vessel in air at atmospheric pressure. Image relaying, exit window tilting, entrance and exit baffle modifications, and a beam polarizer were then used to reduce the stray light to acceptable levels. The CCD camera gave prompt feedback on the effectiveness of each modification, without the need to reestablish vacuum conditions required when using the normal avalanche photodiode detectors (APD). Once the stray light was sufficiently reduced, the APD detectors provided the signal time history to more accurately identify the source location. We have also found that certain types of high reflectance dielectric coatings produce 10–15 times more scatter than other types of more conventional coatings. By using low-scatter mirror coatings and these new stray light reduction techniques, we now have more flexibility in the design of complex Thomson scattering configurations required to probe the central core and the new radiative divertor regions of the DIII–D vessel. © 1997 American Institute of Physics.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1063/1.1147679
