Library

Notes: This paper presents some experimental results which demonstrate restraint of fatigue crack growth in an Al–Mg alloy by wedge effects of fine particles.Fatigue test specimens were machined from a JIS A5083P-O Al–Mg alloy plate of 5 mm thickness and an EDM starter notch was introduced to each specimen. Three kinds of fine particles were prepared as the materials to be wedged into the fatigue cracks, i.e. magnetic particles and two kinds of alumina particles having different mean particle sizes of 47.3 μm and 15.2 μm. Particles of each kind were suspended in an oil to form a paste, which was applied on the specimen surface covering the notch zone prior to the fatigue tests. In order to make some fracture mechanics approaches, in situ observations of fatigue cracks were performed for the two cases using a CCD microscope, with a magnification of ×1000. The crack length and the crack opening displacement (COD) at the notch root, δ, were measured.First it was ensured by control tests that the wedge effect of the oil itself was negligible. Then it was found that the large size alumina particles were not effective in restraining crack growth because the paste was difficult to make due to the large particle size and the particles could not enter the cracks properly.However, both of the magnetic particles and the small size alumina particles effectively restrained crack growth, especially the latter which produced 143–350% increase in the lifetime to failure.From the in situ observations, in the case of the small size alumina particles, a pronounced retardation of crack growth was observed immediately after the crack length exceeded 0.4 mm, and this is considered to be due to the range of COD value, δmax − δmin , being strongly affected by the wedge effects of the particles. The crack retardation effect continues almost through the entire lifetime if the alumina paste is re-applied at specified intervals, while the effect is apparently lost after the crack length exceeds ∼2 mm when such re-painting is not continued.After the fatigue tests, some macro- and microfractographic analyses were performed using a CCD microscope, a SEM and an EPMA (electron probe microanalyser), in order to examine the mechanism of fatigue crack restraint by the wedge effects of the fine particles. From those analyses, it was reasoned that the fine particles that entered a fatigue crack are subjected to cyclic pressures between the crack faces and then form a kind of wedge which causes significant levels of crack closure that restrain crack growth.