Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 1990-1994  (8)
  • 1840-1849
  • 1994  (8)
Material
Years
  • 1990-1994  (8)
  • 1840-1849
Year
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 76 (1994), S. 3656-3668 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have studied the thermal stability of Si1−yCy/Si (y=0.007 and 0.014) heterostructures formed by solid phase epitaxial regrowth of C implanted layers. The loss of substitutional C was monitored over a temperature range of 810–925 °C using Fourier transform infrared absorbance spectroscopy. Concurrent strain measurements were performed using rocking curve x-ray diffraction to correlate strain relaxation with the loss of substitutional C from the lattice. Loss of C from the lattice was initiated immediately without an incubation period, indicative of a low barrier to C clustering. The activation energy as calculated from a time to 50% completion analysis (3.3±5 eV) is near the activation energy for the diffusion of C in Si. Over the entire temperature range studied, annealing to complete loss of substitutional C resulted in the precipitation of C into β-SiC. The precipitates are nearly spherical with diameters of 2–4 nm. These precipitates have the same crystallographic orientation as the Si matrix but the interfaces between the Si and β-SiC precipitates are incoherent. During the initial stages of precipitation, however, C-rich clusters form which maintain coherency with the Si matrix so the biaxial strain in the heterostructure is partially retained.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 76 (1994), S. 257-263 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The reaction kinetics of Ti films on SiO2 were investigated using Rutherford backscattering spectrometry, x-ray diffraction, Auger electron spectroscopy, and transmission electron microscopy. Consistent with earlier studies, the reaction results in the formation of a TiOw/Ti5Si3/SiO2 stack at temperatures in the range 700–820 °C. As the silicide layer grows, the concentration of O in TiOw increases, with the reaction ceasing at w∼1.2. In addition, the reaction rate depends on the initial Ti thickness, as thicker Ti films possess faster reaction rates. Applying current diffusion-controlled kinetic growth models, we find nominal agreement with our data at each thickness and predict activation energies in the range 3.0–3.4 eV. However, such a model is unable to account for either the Ti thickness dependence or the slowing and eventual cessation of silicide formation as the oxide composition approaches its limiting value. We implement a model which takes into account the reduction in the thermodynamic driving force for Ti5Si3 formation due to the incorporation of oxygen into the overlying Ti. This model predicts a silicide growth relationship of the form kt= (1/2)x2+ax2f∑∞n=3(1/n)(x/xf)n, with k independent of Ti thickness and given by k=k0 exp(−ΔE/kBT). The final Ti5Si3 thickness, xf, is determined by the initial Ti thickness, the stoichiometries of each phase formed and the final oxide composition. This model yields a more accurate fit to our data than if we assume parabolic growth since it predicts the eventual cessation of the reaction as x approaches xf. We find ΔE=2.9±0.1 eV. Our model also seems to explain the dependence on initial Ti thickness.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 75 (1994), S. 3936-3943 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Kinetics and electrical properties of solid-phase epitaxial regrown (SPEG) layers of Sb-implanted strained Si1−xGex alloys are reported. Two sets of Si1−xGex epilayers with compositions of x=0.08 and 0.18, molecular beam epitaxy grown on Si(100) substrates, were implanted at room temperature with Sb+ ions at an energy of 200 and 100 keV, respectively, and doses of 1014 and 1015 ions/cm2. A set of Si(100) samples was also implanted as a reference. The samples were annealed at temperatures of 525, 550, and 575 °C for durations between 5 s and 10 min. For the higher-dose Sb-implanted Si0.92Ge0.08 layer (1015 cm−2) ion backscattering measurements in the channeling mode show a decrease in the regrowth rate compared to Sb-implanted Si(100). The activation energy of the SPEG process for the Si0.92Ge0.08 alloy was 2.9±0.2 eV, higher than the value of 2.4±0.2 eV obtained for pure Si. For the alloy with 18% Ge the SPEG rate for the 1015 cm−2 dose was much smaller compared to the sample with 8% Ge. For the lower-dose implantation (1014 cm−2) the regrowth rates for Si0.92Ge0.08 and pure Si were very close, and the activation energies were 2.8±0.2 and 2.7±0.2, respectively. It was also found that the SPEG rate in a rapid thermal annealing was significantly higher than that for a sample heated in a conventional furnace.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 75 (1994), S. 3959-3963 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Interdiffusion and reaction in Cu/PtSi/Si(100) structures have been investigated. During annealing Cu migrates across the intermediate PtSi layer and reacts with Si to form Cu silicides, with no indication of PtSi decomposition or a Cu-PtSi reaction. The diffusion of Cu through PtSi proceeds nonuniformly when PtSi is exposed to air before Cu deposition. Uniform transport is observed when the sample is prepared in situ without breaking vacuum. Cu silicides grow linearly with time, while the rates are independent of the thickness of the transport medium. The results indicate that Cu silicide formation is not controlled by Cu diffusion through the interposed PtSi layer.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 65 (1994), S. 2559-2561 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Thin heteroepitaxial films of Si1−x−yGexCy have been grown on (100)Si substrates using atmospheric pressure chemical vapor deposition at 625 °C. The crystallinity, composition, and microstructure of the SiGeC films were characterized using Rutherford backscattering spectrometry, secondary-ion-mass spectrometry, and cross-sectional transmission electron microscopy. The crystallinity of the films was very sensitive to the flow rate of C2H4 which served as the C source. Films with up to 2% C were epitaxial with good crystallinity and very few interfacial defects. Between 800 and 900 sccm of 10% C2H4 in He, the C content increased dramatically from 2% to 10% and the as-grown films changed from crystalline to amorphous. In order to establish deposition conditions for the crystalline-amorphous phase transformation, one SiGeC film was deposited as the 10% C2H4 flow was increased linearly from 500 to 1500 sccm during growth. When the C content reached ∼4%, the film developed considerable stacking defects and disorder, and at around 11% C, the film became amorphous. © 1994 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 75 (1994), S. 377-381 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Pure Si(100) and Si1−xGex (x〈0.20) layers, epitaxially grown on Si(100) substrates, were implanted at room temperature with Sb+ ions at an energy of 100 keV and a dose of 1013 cm−2, which was found to be below the critical value for amorphization. Spreading resistance profiling and Hall-effect measurements show that a p-type region was formed in the Si1−xGex alloy layers upon annealing at 500 °C, in spite of the fact that the implanted ion (Sb) is a donor. Only higher-temperature anneals transformed the implanted layer into the expected n-type doping. A p-type region was also formed following Xe implantation, indicating that these results can be attributed to the radiation damage without dependence on the electronic structure of the ion. This phenomenon does not exist at all in pure Si. Rutherford backscattering (channeling) measurements show that the amount of defects formed in the Si1−xGex alloy layer during the implantation process increased with the Ge content, in good agreement with Monte Carlo simulations. These results can explain the observation that the level of the p-type doping increased with the Ge content in the alloys.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 5 (1994), S. 481-484 
    ISSN: 1573-4838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine , Technology
    Notes: Plasma-spraying of metallic impiant surfaces is an established method for the application of hydroxylapatite (HA) coatings. Carbon fibre reinforced thermoplastics show different thermal and mechanical properties, compared with titanium substrates. In this paper first results of the influence of the established coating method on carbon fibre reinforced thermoplastics are presented. First investigations of the tensile adhesion strength, tested with a newly developed testing device, showed that the adhesion between the HA coating and the carbon fibre reinforced polyetheretherketone (PEEK) composite is very low. Macromechanical bending tests showed a change to initial tensile instead of compression failure of the coated composite substrate. Micromechanical bending tests in a scanning electron microseope (SEM) hot tensile stage (Raith GmbH) revealed crack propagation within the ceramic coating and in the coating-substrate interface before the total failure of the composite substrate occurred.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Springer
    Journal of radioanalytical and nuclear chemistry 188 (1994), S. 211-217 
    ISSN: 1588-2780
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Energy, Environment Protection, Nuclear Power Engineering
    Notes: Abstract Experiments with Triton X-100 as a model surfactant were performed under steadystate conditions, using deoxygenated solutions as well as those saturated with N2O, O2 or N2O/O2 mixtures. The Triton X-100 decomposition yield was dependent on the O2 content of the irradiated system. Oxygen promoted surfactant decomposition in aqueous solution containing only Triton X-100.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...