Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 1995-1999  (10)
  • 1990-1994  (7)
  • 1
    Electronic Resource
    Electronic Resource
    Westerville, Ohio : American Ceramics Society
    Journal of the American Ceramic Society 82 (1999), S. 0 
    ISSN: 1551-2916
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Phase equilibria in the Bi2O3-CaO system have been examined over the temperature range of 650°-1050°C in oxygen at a pressure of 1 atm. Direct electron microprobe analysis has been used to determine the compositions of several phases with fixed Bi:Ca ratios and to determine the extents of compositional ranges of the three solid solutions in the system. The face-centered-cubic solid solution (FCCss) phase extends from pure Bi2O3 to a maximum CaO content of 27 mol% at 816°± 4°C. In the bismuth-rich portion of the diagram, the FCCss phase is replaced by monoclinic Bi2O3 (which dissolves essentially no CaO) and a rhombohedral solid solution (Rhss) phase with 12 mol% CaO. The eutectoid is located at 6 mol% CaO and 684°± 3°C. A calcium-rich FCCss phase also coexists at a eutectoid with a Rhss phase (23.5 mol% CaO) and Bi2CaO4 at 766°± 3°C. There are two two-phase regions between the FCCss and Rhss phases that have a closure temperature that is estimated to be ∼840°C. The Rhss phase exists between these two-phase regions. The minimum CaO content of this solid solution is 12 mol%, and its maximum CaO content is 23.5 mol%; however, the extent of solid solution is highly temperature dependent at 〉700°C. All liquids with 0-23 mol% CaO may coexist with a FCCss phase. The stability field of the rhombohedral phase does not reach the solidus, and there is a thermal maximum on the liquidus that is estimated at ∼880°C at which a FCCss phase and a liquid phase, each with 17 mol% CaO, coexist. Liquid with 23 mol% CaO, a FCCss phase, and a body-centered-cubic solid solution (BCCss) phase with 27 mol% CaO coexist at a eutectic near 866°C. The BCCss phase has a maximum composition range of 27-42 mol% CaO, although the range is dependent on temperature. At temperatures below 816°± 4°C, the BCCss phase is replaced by a FCCss phase and Bi6Ca4O13. At 970 ± 3°C, the BCCss phase with 42 mol% CaO melts incongruently to CaO and a liquid. Thus, only three phases-FCCss, BCCss, and CaO-coexist with liquids in the Bi2O3-CaO system. However, several other phases are identified in the subsolidus region: Bi14Ca5O26, which is replaced by a Rhss phase and Bi2CaO4 at 745°± 5°C; Bi2CaO4, which decomposes to a FCCss phase and Bi6Ca4O13 at 776°± 3°C; Bi6Ca4O13, which is replaced by a BCCss phase and Bi2Ca2O5 at ∼878°± 3°C; and Bi2Ca2O5, which decomposes to a BCCss phase and CaO at 931°± 5°C.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Springer
    Archives of virology 142 (1997), S. 1021-1028 
    ISSN: 1432-8798
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine
    Notes: Summary.  We have determined the primary sequence of the 5′ noncoding region (5′ NCR) and putative helicase regions (NS-3) of hepatitis G virus (HGV) and GB virus C (GBV-C) that were isolated in Japan from suspected cases of nonA-nonB and/or nonA-nonB-nonC viral hepatitis by using RT-PCR, and we compared the newly isolated sequences with three established isolates. The addition of a "G" residue was found at the 5′ terminus of all 8 Japanese isolates. These isolates were more clearly distinguished from the prototype viruses by comparison with the 5′ NCR sequence than by comparison with the NS-3 region. Our results suggested that at least three distinct genomic variants of HGV exist. Genotyping of HGV by using RT-PCR based on the sequence of the 5′ NCR seems highly feasible.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1432-8798
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine
    Notes: Summary.  The genomes of nine GBV-C/HGV isolates from Japanese chronic hepatitis patients were fully sequenced and characterized. They shared 85% nucleotide sequence homology with previously characterized isolates from the US and West Africa. Homology studies and phylogenetic analyses showed that the Japanese isolates formed a third group distinct from the established groups 1 and 2. The genetic distances between the three groups of GBV-C/HGV were very similar to the distances between the two classical swine fever virus (CSFV) serotypes, which suggested that they might belong to a separate GBV-C/HGV serotype. Plot similarity analysis comparing the three groups exposed relatively conserved terminal non-coding regions. Hairpin structures predicted in the Japanese isolates are probably involved in viral replication. The region coding E1-E2-NS-2 showed the least similarity (80%); in HCV the similarity here is only 50% due to its hypervariablity. NS-3 and NS-5b that respectivity encode the helicase/protease and RNA-dependent RNA polymerase, had a high degree of amino acid homo- logy, suggesting a high degree of functional constraint in this region. The NS-5b nucleotide sequence was highly conserved perhaps because of constraints from RNA secondary structure and/or an open reading frame in the negative strand.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Springer
    Journal of thermal analysis and calorimetry 46 (1996), S. 521-528 
    ISSN: 1572-8943
    Keywords: methacrylamide-montmorillonite intercalation ; thermal stability
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Thermal stability of methacrylamide intercalated octadecylammonium montmorillonite (OD-M/MA) is limited by rapid desorption of methacrylamide (MA) at 140°C. It was improved by γ-irradiation. The irradiation intercalation complex OD-M/MA γ shows significant shift of the whole desorption process towards higher temperatures. However, part of the adsorbed organic material is released at 50°C signalizing presence of some volatile fractions. Decomposition products of the intercalated material and long-chain alkylamides in the acetone extract indicate complex reactions between MA and octadecylammonium chains. An additional swelling of the silicate structure occurs after γ-ray initiation and is probably related to the reaction products with a certain degree of cross-linking in the interlayers.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 25 (1990), S. 4847-4851 
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract Powders of saponite/acriflavine complex (SAC) saponite/carbon black mixture (SKM) and saponite itself (Sap) were pressed into small discs (20 mm diameter × 3 mm), followed by heat treatment at 1073 to 1473 K under nitrogen or argon. Their chemical resistance to 10% NaOH, conc. HCl, conc. HNO3 and conc. H2SO4 solutions at room temperature was examined on the basis of weight loss. The resistance of the three samples to NaOH solution was found to increase with increasing heat-treatment temperature, and both SAC and Sap after heating to 1473 K exhibited only a slight weight loss even after soaking for 20 d. On the whole, SAC had the highest resistance among three. The three samples were more resistant to acid solutions than NaOH, the resistance of both SKM and Sap increasing with increasing heat-treatment temperature. The amorphous component and forsterite crystal in the samples after heating to high temperature were preferentially attacked by NaOH and acid solutions, respectively. These results are discussed on the basis of X-ray diffraction, SEM observation, carbon content, etc.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 9 (1990), S. 693-695 
    ISSN: 1573-4811
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 31 (1996), S. 3403-3407 
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract A silver chelate of 2-(4-thiazolyl)-benzimidazole, dodecyltrimethylammonium cation and hexadecylpyridinium cation have been intercalated between montmorillonite, and the resulting samples were subjected to examination of their thermostabilities by thermogravimetry and carbon dioxide evolution analysis up to 500 °C in air. The degradation behaviour of the intercalant was significantly changed by intercalating between the montmorillonite layers. Two quaternary ammonium cations were released from the montmorillonite both at the same temperature, which was higher than those for the quaternary ammonium cations themselves. This relation was also observed in the case of 2-(4-thiazolyl)-benzimidazole. The improvement of the thermostability after intercalation can be attributed to the bonding between the intercalant and the host montmorillonite layers.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract Rice hull was moulded into a tube (outer diameter: 54 mm; inner diameter: 17 mm, length: c. 170 mm) by use of an extruder and then carbonized in nitrogen atmosphere below 1000 °C. Ash content of the hull was 16 wt%, of which c. 94 and 4 wt% were SiO2 and K2O, respectively. Carbon yield and shrinkage of the mould after carbonization at 1000 °C were 42 wt%, and 43 vol%, respectively. The bulk density increased with rising of carbonization temperature to reach to 0.93 g ml−1 at 1000 °C via 0.82 g ml−1 at 500 °C. The largest compressive strength of 3.6 MPa was obtained after carbonization at 1000 °C. No micropore was developed after carbonization, and the total pore volume measured by a mercury porosimeter was 0.25–0.31 ml g−1 after carbonization. These data were compared with those of charcoal.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 31 (1996), S. 4307-4310 
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract Toluene solutions of hydrophobic smectite (SAN) and polypropylene (PP) were mixed thoroughly. Trimethylsilylated SAN was also used to examine the effects of the surface modification. In both the smectites, the resulting mixtures were transparent but the stacked layer structures were retained, with expansion of the interlayer distance from 2.26 nm to ∼5 nm. The PP containing the fine SAN filler particles was prepared after removal of toluene, followed by mixing with the PP to produce a 3 wt% SAN content. The SAN particles were more finely dispersed in the resulting composites than was achieved by conventional mechanical mixing, but the mechanical properties were not improved remarkably. The trimethylsilylation conferred no favourable effect on the mechanical properties of the composite.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 15 (1996), S. 1481-1483 
    ISSN: 1573-4811
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...