Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 1995-1999  (3)
  • 1985-1989  (7)
  • 1975-1979  (3)
Material
Years
Year
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 86 (1999), S. 664-670 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have developed magnetic resonance force microscopy for quantitative measurements of magnetic fields. A microscopic particle attached near the end of a microcantilever serves as the field sensing probe. We have demonstrated two-dimensional field mapping with a lateral resolution of 3.2 μm and a field resolution of 0.19 mT (1.9 G). The instrument holds considerable promise for field mapping with spatial resolution better than 0.1 μm at room temperature. Applications include field mapping of magnetic recording heads. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 79 (1996), S. 6448-6450 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We report on magnetic force microscopy (MFM) images of a thin-film magnetic recording head taken using batch micromachined silicon tips coated with nanocomposite Fe60(SiO2)40 and Fe70(SiO2)30 films. The small Fe grain size (〈10 nm) and dilute Fe volume fraction (0.29–0.4) of these granular films produce tip coatings of low remanence and essentially zero coercivity, reduced by the superparamagnetic properties of these films. We have used these tips to obtain MFM images of the write field of the head with high spatial and magnetic-field resolution. In comparison to images taken using commercial Co85Cr15-coated tips, these MFM images show reduced tip memory effects and clearly delineate the gap field from the pole pieces. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 54 (1989), S. 1477-1479 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have used the squeezable electron tunneling junction technique for testing the electrical properties of the surfaces of YBa2Cu3Ox (YBCO) thin-film electrodes. As deposited and annealed, the surfaces of the electrodes were insulating at 4 K. Several methods were used to improve the electrical properties of the electrodes' surfaces including rapid thermal annealing, oxygen sputter etching, and thin Ag coating treatments. The greatest improvement occurred after a deposition of a 5 nm Ag coating and subsequent rapid thermal anneal of one set of YBCO films. Under these conditions it was possible to make a superconducting Josephson point contact between the surfaces of the electrodes. We think that the Ag acts as a normal-metal proximity layer effectively shunting the degraded electrodes' surfaces.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 55 (1989), S. 1463-1465 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have used the break junction method to measure the tunneling gap of a thallium-based high-temperature superconductor crystal in liquid helium at 4 K. The crystal was predominantly Tl2CaBa2Cu2O7 and had a superconducting onset temperature of 105 K. Tunneling data showed a symmetric gap about zero bias between two well-defined conductance peaks in the conductance versus voltage curve. The gap is consistent with a Bardeen–Cooper–Schrieffer energy gap (Δ) of 30 meV assuming a superconductor-insulator-superconductor electrode configuration. In addition, a supercurrent could be detected when the break junction was operated in a point-contact mode at temperatures as high as 95 K.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 51 (1987), S. 540-541 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have observed the Josephson effect in a YBaCuO break junction. Critical currents as high as 10 mA were measured at 4 K for break junctions with a point contact within the fracture of a sample. The junction was susceptible to microwave radiation showing Shapiro steps with the ratio of V/f of 2.04±0.05 μV/GHz compared to the pair tunneling value of h/2e=2.068 μV/GHz. These steps were clearly visible in the current-voltage characteristics at tempertures up to 85±5 K.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 57 (1986), S. 990-992 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: Piezoelectric bimorphs constructed from lead titanate-zirconate (PZT) ceramic bonded to a brass sheet have been tested at cryogenic temperatures to determine their suitability for use in a low-temperature micropositioner. Experimental data are presented on bimorph sensitivity (displacement per volt) as a function of the number of temperature cycles. Results indicate that bimorphs of this type cannot be calibrated because of irreversible changes in the bending characteristics that occur while cycling from room temperature to 4 K.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 59 (1988), S. 2535-2538 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A bathysphere consisting of an inverted Dewar flask for submersible operation in cryogenic fluids is used to measure the resistance of superconductors, including high-Tc superconducting copper oxides, as a function of temperature from 4 to 300 K. We describe the cryostat incorporating the bathysphere and present data on NbTi (44% Ti) and YBa2Cu3O7−δ with respective superconducting transitions temperatures of 9.5 and 91.5 K. There are several advantages of the bathysphere method. The cryostat is of simple, compact design easily adapted to high-field applications where magnet bore size is a limiting factor. The sample and thermometer are thermolyzed in the dry vapor trapped at the top of the bathysphere. Temperature can be varied rapidly from 300 to 4 K at a rate of 1 K min with less than a 0.1 K thermal lag between the sample and thermometer.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 58 (1985), S. 3888-3895 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: An Nb-Sn filament mounted on a flexible glass beam can be broken to form an electron tunneling junction between the fracture elements. Breaking the filament in liquid helium prevents oxidation of the freshly exposed fracture surfaces. A sharp superconducting energy gap in the I-V characteristics measured at 4 K indicates the formation of a high-quality tunneling barrier between the fracture elements. The resistance of the junction can be continuously adjusted by varying the surface bending strain of the beam. An estimated 0.1 nm change in the barrier thickness produces about an order of magnitude change in the resistance over the range from 105 to 108 Ω. The exponential character of this dependence shows that the tunnel junction is freely adjustable without intimate contact of the junction elements. "Break'' junctions made in this way offer a new class of tunneling experiments on freshly exposed surfaces of a fractured sample without the oxide barrier previously required for junction stability. Such experiments provide a simple technique for tunneling to new materials and may eliminate complications that can be encountered during interpretation of data obtained using oxide barriers.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 58 (1985), S. 392-396 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We present current versus voltage characteristics for two metal-insulator-semiconductor systems: lead-insulator-mercury cadmium telluride and silver-insulator-silicon. A previously developed new technique allows us to suspend the metal 〈20 A(ring) above the semiconductor so that the insulator is simply the space between them. The Si studies at room temperature show features suggestive of electron tunneling between the metal and semiconductor, while the HgCdTe studies in liquid helium conclusively show the Pb superconducting energy gap, demonstrating that contactless tunneling studies of semiconductor surfaces are possible.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Cambridge : Cambridge University Press
    Urban history 25 (1998), S. 261-262 
    ISSN: 0963-9268
    Source: Cambridge Journals Digital Archives
    Topics: Architecture, Civil Engineering, Surveying , History , Sociology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...