Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 1995-1999  (3)
  • 1985-1989  (5)
  • Engineering General  (7)
  • Desorption  (1)
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    Nutrient cycling in agroecosystems 51 (1998), S. 209-215 
    ISSN: 1573-0867
    Keywords: Desorption ; kinetics ; microbial transformation ; phosphate ; soils
    Source: Springer Online Journal Archives 1860-2000
    Topics: Agriculture, Forestry, Horticulture, Fishery, Domestic Science, Nutrition
    Notes: Abstract The improvement of P management in agriculture and environment requires a good understanding of residual effect of applied P in soils. The specific adsorption of P on variable charge minerals has been considered as the major mechanism that leads to a very low utilization of P fertilizer by crops within a growing season in Chinese red soils. Soil incubation and isotope tracing analysis were carried out to examine the transformation kinetics and potential availability of added specifically sorbed 32P in two pH contrasting light textured soils. The 32P recovered by 0.5 M NaHCO3 extraction and microbial biomass-P measurement from the added specifically sorbed 32P in the soils was well described by a first-order reaction and a Langmuir-type kinetic model, with correlation coefficients (R) being, on average, 0.938 and 0.959, respectively. The half-life (t1/2, from the first-order model) of the four tested mineral-P complexes ranged from 29 to 47 d in the acid sandy soil and 33 to 105 d in the neutral silty soil. Goethite-P was the most stable among the four tested mineral-P complexes. The potential availability of the mineral complex P (q m , in percent of total 32P added) obtained from the Langmuir equation ranged from 43.7 to 90.9% for the four mineral-P complexes, and decreased in the order: Al oxide-P (90.9%) 〉 montmorillonite-P (86.2%) 〉 kaolinite-P (77.5%) 〉 goethite-P (60.2%) in the acid sandy soil, whereas the order was Al oxide-P (89.3%) 〉 kaolinite-P (86.2%) 〉 montmorillonite-P (82.6%) 〉 goethite-P (43.7%) in the neutral silty soil. Based on the release rate and potential availability, kaolinite-P and Al oxide-P could be important sources for residual effect of applied P in variable-charge soils. The goethite-P has the lowest release rate and potential availability among the mineral-P complexes, implying that iron oxides may be the most important variable-charge mineral responsible for P fixation in the Chinese red soils.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    International Journal for Numerical Methods in Engineering 28 (1989), S. 2161-2174 
    ISSN: 0029-5981
    Keywords: Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mathematics , Technology
    Notes: An a-posteriori error estimator for finite element analysis proposed by Zienkiewicz and Zhu is analysed and shown to be effective and convergent. In addition we analyse wider classes of estimators of which the Zienkiewicz-Zhu estimator is a special case. It is shown that some of these estimators will be asymptotically exact. Numerical evidence is presented supporting the analysis.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    International Journal for Numerical Methods in Engineering 28 (1989), S. 2839-2853 
    ISSN: 0029-5981
    Keywords: Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mathematics , Technology
    Notes: The Zienkiewicz-Zhu error estimator is shown to be effective in problems of plate flexure. When used in conjunction with triangular elements and an adaptive mesh generator allowing a prescribed size of elements to be developed, very fast adaptive convergence for results of specified accuracy is achieved.
    Additional Material: 10 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    International Journal for Numerical Methods in Engineering 24 (1987), S. 337-357 
    ISSN: 0029-5981
    Keywords: Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mathematics , Technology
    Notes: A new error estimator is presented which is not only reasonably accurate but whose evaluation is computationally so simple that it can be readily implemented in existing finite element codes.The estimator allows the global energy norm error to be well estmated and alos gives a good evaluation of local errors. It can thus be combined with a full adaptive process of refinement or, more simply, provide guidance for mesh redesign which allows the user to obtain a desired accuracy with one or two trials.When combined with an automatic mesh generator a very efficient guidance process to analysis is avaiable.Estimates other than the energy norm have successfully been applied giving, for instance, a predetermined accuracy of stresses.
    Additional Material: 19 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    International Journal for Numerical Methods in Engineering 28 (1989), S. 879-891 
    ISSN: 0029-5981
    Keywords: Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mathematics , Technology
    Notes: Two practical and effective, h-p-type, finite element adaptive procedures are presented. The procedures allow not only the final global energy norm error to be well estimated using hierarchic p-refinement, but in addition give a nearly optimal mesh. The design of this is guided by the local information computed on the previous mesh. The desired accuracy can always be obtained within one or at most two h-p-refinements.The rate of convergence of the adaptive h-p-version analysis procedures has been tested for some examples and found to be very strong.The presented procedures can easily be incorporated into existing p- or h-type code structures.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Chichester : Wiley-Blackwell
    International Journal for Numerical Methods in Fluids 23 (1996), S. 1133-1144 
    ISSN: 0271-2091
    Keywords: turbulence models ; realizability ; complex flows ; Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Various wall-bounded flows with complex geometries and free shear flows have been studied with a newly developed realizable Reynolds stress algebraic equation model. The model development is based on the invariant theory in continuum mechanics. This theory enables us to formulate a general constitutive relation for the Reynolds stresses. Pope (J. Fluid Mech., 72, 331-340 (1975)) was the first to introduce this kind of constitutive relation to turbulence modelling. In our study, realizability is imposed on the truncated constitutive relation to determine the coefficients so that, unlike the standard k-∊ eddy viscosity model, the present model will not produce negative normal stresses in any situations of rapid distortion. The calculations based on the present model have shown encouraging success in modelling complex turbulent flows.
    Additional Material: 15 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Chichester [u.a.] : Wiley-Blackwell
    International Journal for Numerical Methods in Engineering 39 (1996), S. 1017-1028 
    ISSN: 0029-5981
    Keywords: singular integrals ; Green's functions ; stiffness method ; Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mathematics , Technology
    Notes: A new technique is developed to evaluate the Cauchy principal value integrals and weakly singular integrals involved in the boundary integral equations. The boundary element method is then applied to analyse scattering of waves by cracks in a laminated composite plate. The Green's functions are obtained in discrete form through the thickness of the plate using a stiffness method. To circumvent the difficulties associated with the evaluation of hypersingular integrals due to the presence of cracks, the multidomain technique is applied. Numerical computations have shown the accuracy and reliability of the proposed technique. Scattered wave fields for a composite plate with a horizontal crack are computed. The numerical results show that the applications of the technique in non-destructive evaluation of defects is very promising.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Communications in Applied Numerical Methods 4 (1988), S. 197-204 
    ISSN: 0748-8025
    Keywords: Engineering ; Engineering General
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mathematics , Technology
    Notes: An effective h-version finite element adaptive strategy combined with mesh regeneration is presented. This is based on the error estimator developed in Reference 1. The rate of convergence of the adaptive procedure has been tested for some examples and very strong convergence observed. Unlike some existing h-version adaptive procedures, a nearly optimal mesh of predicted accuracy can be obtained in one or two adaptive process steps.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...